Effect of Salt-Frost Cycles on Mechanical Properties and Uniaxial Compression Stress–Strain Curve of Recycled Coarse Aggregate Concrete
Publication: Journal of Materials in Civil Engineering
Volume 32, Issue 2
Abstract
In this study, recycled coarse aggregate concrete (RAC) with incorporation of high-performance water-reducer and air-entraining agent was designed with a water to cement ratio of 0.25. Rapid salt-frost tests were conducted on the RAC specimens, during which mass loss and relative dynamic modulus of elasticity of the RAC specimens after salt-frost cycles (SFC) were obtained. Cubic compressive strength, splitting tensile strength, and uniaxial compression stress–strain curve of the RAC after SFC were also obtained. The loss of mass and relative dynamic modulus of elasticity of the RAC after 250 SFC was 0.5% and 19.31%, respectively; both much lower than the corresponding critical failure values of 5% and 40%, respectively. The cubic compressive strength, splitting tensile strength, peak stress, and modulus of elasticity of the RAC after SFC were found to decrease with the increase in the number of SFC, by 56.9%, 41.3%, 7.9%, and 15.0%, respectively, after 250 SFC. The elastic Poisson ratio and peak strain of the RAC after 0–250 SFC varied slightly around 0.22 and 2,200 με, respectively. In addition, the equations for describing the uniaxial compression stress–strain curve of the RAC after 0–250 SFC are presented, which fit well with the experimental results.
Get full access to this article
View all available purchase options and get full access to this article.
References
ACI (American Concrete Institute). 1997. Standard practice for selecting proportions for normal, heavyweight and mass concrete. ACI 211.1. Farmington Hills, MI: ACI.
Amer, A. A. M., K. Ezziane, and A. Bougara. 2016. “Rheological and mechanical behavior of concrete made with pre-saturated and dried recycled concrete aggregates.” Constr. Build. Mater. 123 (Oct): 300–308. https://doi.org/10.1016/j.conbuildmat.2016.06.107.
Amorim, J. N. S., G. A. O. Silva, and D. V. Ribeiro. 2018. “Effects of the incorporation of recycled aggregate in the durability of the concrete submitted to freeze-thaw cycles.” Constr. Build. Mater. 161 (Feb): 723–730. https://doi.org/10.1016/j.conbuildmat.2017.12.076.
Andal, J., M. Shehata, and P. Zacarias. 2016. “Properties of concrete containing recycled concrete aggregate of preserved quality.” Constr. Build. Mater. 125 (Oct): 842–855. https://doi.org/10.1016/j.conbuildmat.2016.08.110.
Andreu, G., and E. Miren. 2014. “Experimental analysis of properties of high performance recycled aggregate concrete.” Constr. Build. Mater. 52 (2): 227–235. https://doi.org/10.1016/j.conbuildmat.2013.11.054.
ASTM. 2012. Standard test method for resistance of concrete to rapid freezing and thawing. ASTM C666. West Conshohocken, PA: ASTM.
ASTM. 2017. Standard test method for splitting tensile strength of cylindrical concrete specimens. ASTM C496/C496M. West Conshohocken, PA: ASTM.
ASTM. 2018a. Standard specification for concrete aggregates. ASTM C33/C33M. West Conshohocken, PA: ASTM.
ASTM. 2018b. Standard test method for compressive strength of cylindrical concrete specimens. ASTM C39/C39M. West Conshohocken, PA: ASTM.
ASTM. 2019. Standard specification for portland cement. ASTM C150/C150M. West Conshohocken, PA: ASTM.
Belén, G. F., M. A. Fernando, C. L. Diego, and S. P. Sindy. 2011. “Stress-strain relationship in axial compression for concrete using recycled saturated coarse aggregate.” Constr. Build. Mater. 25 (5): 2335–2342.
Brand, A. S., J. R. Roesler, and A. Salas. 2015. “Initial moisture and mixing effects on higher quality recycled coarse aggregate concrete.” Constr. Build. Mater. 79 (Mar): 83–89. https://doi.org/10.1016/j.conbuildmat.2015.01.047.
Brito, J. D., M. Barra, and L. Ferreira. 2011. “Influence of the pre-saturation of recycled coarse concrete aggregates on concrete properties.” Mag. Concr. Res. 63 (8): 617–627. https://doi.org/10.1680/macr.2011.63.8.617.
Carreira, D. J., and K.-H. Chu. 1985. “Stress-strain relationship for plain concrete in compression.” ACI J. 82 (6): 797–804.
Chinese Standard. 2002. Standard for test method of mechanical properties on ordinary concrete. [In Chinese.] GB/T50081. Beijing: China Architecture & Building Press.
Chinese Standard. 2006. Standard for technical requirements and test method of sand and crushed stone (or gravel) for ordinary concrete. [In Chinese.] JGJ 52. Beijing: China Architecture & Building Press.
Chinese Standard. 2007. Common portland cement. [In Chinese.] GB 175. Beijing: Standardization Administration.
Chinese Standard. 2009. Standard for test method of long-term performance and durability of ordinary concrete. [In Chinese.] GB/T50082. Beijing: China Architecture & Building Press.
Chinese Standard. 2011. Specification for mix proportion design of ordinary concrete. [In Chinese.] JGJ 55. Beijing: China Architecture & Building Press.
Duan, A., W. Jin, and J. Qian. 2011. “Effect of freeze–thaw cycles on the stress–strain curves of unconfined and confined concrete.” Mater. Struct. 44 (7): 1309–1324. https://doi.org/10.1617/s11527-010-9702-9.
Gokce, A., S. Nagataki, T. Saeki, and M. Hisada. 2004. “Freezing and thawing resistance of air-entrained concrete incorporating recycled coarse aggregate: The role of air content in demolished concrete.” Cem. Concr. Res. 34 (5): 799–806. https://doi.org/10.1016/j.cemconres.2003.09.014.
Hu, J., and J. Wu. 2019. “Mechanical properties and uni-axial compression stress-strain relation of recycled coarse aggregate concrete subjected to salt-frost cycles.” Constr. Build. Mater. 197 (Feb): 652–666. https://doi.org/10.1016/j.conbuildmat.2018.11.213.
Huda, S. B., and M. S. Alam. 2015. “Mechanical and freeze-thaw durability properties of recycled aggregate concrete made with recycled coarse aggregate.” J. Mater. Civ. Eng. 27 (10): 04015003. https://doi.org/10.1061/(ASCE)MT.1943-5533.0001237.
Jansen, D. C., and S. P. Shah. 1997. “Effect of length on compressive strain softening of concrete.” J. Eng. Mech. 123 (1): 25–35. https://doi.org/10.1061/(ASCE)0733-9399(1997)123:1(25).
Katzer, J. 2013. “Strength performance comparison of mortars made with waste fine aggregate and ceramic fume.” Constr. Build. Mater. 47 (Oct): 1–6. https://doi.org/10.1016/j.conbuildmat.2013.04.039.
Kou, S., and C. Poon. 2015. “Effect of the quality of parent concrete on the properties of high performance recycled aggregate concrete.” Constr. Build. Mater. 77: 501–508. https://doi.org/10.1016/j.conbuildmat.2014.12.035.
Lei, B., W. Li, Z. Tang, V. W. Y. Tam, and Z. Sun. 2018. “Durability of recycled aggregate concrete under coupling mechanical loading and freeze-thaw cycle in salt-solution.” Constr. Build. Mater. 163 (Feb): 840–849. https://doi.org/10.1016/j.conbuildmat.2017.12.194.
Limbachiya, M. C., T. Leelawat, and R. K. Dhir. 2000. “Use of recycled concrete aggregate in high-strength concrete.” Mater. Struct. 33 (9): 574. https://doi.org/10.1007/BF02480538.
Luo, S., S. Ye, J. Xiao, J. Zheng, and Y. Zhu. 2018. “Carbonated recycled coarse aggregate and uniaxial compressive stress-strain relation of recycled aggregate concrete.” Constr. Build. Mater. 188 (Nov): 956–965. https://doi.org/10.1016/j.conbuildmat.2018.08.159.
Oliveira, M. B. D., and E. Vazquez. 1996. “The influence of retained moisture in aggregates from recycling on the properties of new hardened concrete.” Waste Manage. (Oxford) 16 (1–3): 113–117. https://doi.org/10.1016/S0956-053X(96)00033-5.
Seitl, S., V. Viszlay, J. Domski, and J. Katzer. 2017. “Fracture mechanical properties of cement based composites with various amount of waste aggregates.” Procedia Eng. 190: 345–351. https://doi.org/10.1016/j.proeng.2017.05.347.
Shah, S. P., et al. 2000. “Test method for measurement of the strain-softening behaviour of concrete under uniaxial compression.” Mater. Struct. 33 (6): 347–351. https://doi.org/10.1007/BF02479643.
Suryawanshi, S., B. Singh, and P. Bhargava. 2018. “Equation for stress–strain relationship of recycled aggregate concrete in axial compression.” Mag. Concr. Res. 70 (4): 163–171. https://doi.org/10.1680/jmacr.16.00108.
Valenza, J. J., and G. W. Scherer. 2006. “Mechanism for salt scaling.” J. Am. Ceram. Soc. 89 (4): 1161. https://doi.org/10.1111/j.1551-2916.2006.00913.x.
Verian, K. P., J. Jain, J. Olek, and N. Whiting. 2012. “Durability of pavement concretes made with recycled concrete aggregates.” Transp. Res. Rec. 2290 (1): 44–51. https://doi.org/10.3141/2290-06.
Wang, Q., Y. Wang, G. Yue, and Z. Huan. 2016. “Influence of mixing methods on mechanical behaviors of recycled aggregate concrete.” [In Chinese.] Supplement, J. Build. Struct. 37 (S2): 79–87.
Wu, J., X. Jing, and Z. Wang. 2017. “Uni-axial compressive stress-strain relation of recycled coarse aggregate concrete after freezing and thawing cycles.” Constr. Build. Mater. 134 (Mar): 210–219. https://doi.org/10.1016/j.conbuildmat.2016.12.142.
Xiao, J., J. Li, and C. Zhang. 2005. “Mechanical properties of recycled aggregate concrete under uniaxial loading.” Cem. Concr. Res. 35 (6): 1187–1194. https://doi.org/10.1016/j.cemconres.2004.09.020.
Xiao, J., W. Li, Y. Fan, and X. Huang. 2012. “An overview of study on recycled aggregate concrete in China (1996–2011).” Constr. Build. Mater. 31 (6): 364–383. https://doi.org/10.1016/j.conbuildmat.2011.12.074.
Xiao, J., K. Zhang, and A. Akbarnezhad. 2018. “Variability of stress-strain relationship for recycled aggregate concrete under uniaxial compression loading.” J. Cleaner Prod. 181 (Apr): 753–771. https://doi.org/10.1016/j.jclepro.2018.01.247.
Yang, L., R. Wang, and Y. Zhao. 2017. “Effect of coupled deterioration by freeze-thaw cycle and carbonation on concrete produced with coarse recycled concrete aggregates.” J. Ceram. Soc. Jpn. 125 (1): 36–45. https://doi.org/10.2109/jcersj2.16190.
Yildirim, S. T., C. Meyer, and S. Herfellner. 2015. “Effects of internal curing on the strength, drying shrinkage and freeze–thaw resistance of concrete containing recycled concrete aggregates.” Constr. Build. Mater. 91 (Aug): 288–296. https://doi.org/10.1016/j.conbuildmat.2015.05.045.
Information & Authors
Information
Published In
Copyright
©2019 American Society of Civil Engineers.
History
Received: Nov 25, 2018
Accepted: Jul 3, 2019
Published online: Dec 10, 2019
Published in print: Feb 1, 2020
Discussion open until: May 10, 2020
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.