Conditional Probabilistic Analysis of Cement-Treated Soil Column Strength
Publication: International Journal of Geomechanics
Volume 16, Issue 1
Abstract
The quality of cement-treated soil columns is usually assessed by examining the strength of cored samples. This paper presents a finite-element analysis approach with random field theory for assessing the quality of a cement-treated soil column from which cored samples are retrieved. Monte Carlo simulations with conditional distribution (conditional simulation) were conducted to generate spatial dependence random fields with the data known at some locations. Simulations without the known data (unconditional simulation) were also performed for comparison. Using the random field samples generated from the Monte Carlo simulations, finite-element analysis was performed to simulate the compression behavior of a full-scale column in which material properties vary with a presence of spatial autocorrelation. Finite-element analysis with conditional simulation predicts the overall strength of a targeted cement-treated soil column appropriately, and the overall strength variability obtained with the conditional simulation is lower than that obtained with the unconditional simulation. The results suggest that the conditional simulation offers advantages over the unconditional simulation when assessing the probability of failure of a cement-treated soil column with large autocorrelation distance.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
The author is grateful to Takenaka Corporation for their cooperation in the numerical analysis. The author also acknowledges the support of the Japan Society for the Promotion of Science (JSPS KAKENHI Grant No. 25420509).
References
Anderson, T. W. (2003). An introduction to multivariate statistical analysis, 3rd Ed., Wiley, Hoboken, NJ, 6–65.
Andrade, J. E., Baker, J. W., and Ellison, K. C. (2008). “Random porosity fields and their influence on the stability of granular media.” Int. J. Numer. Anal. Meth. Geomech., 32(10), 1147–1172.
Baker, J. W., and Faber, M. H. (2008). “Liquefaction risk assessment using geostatistics to account for soil spatial variability.” J. Geotech. Geoenviron. Eng., 14–23.
CDIT (Coastal Development Institute of Technology), Japan. (2002). The deep mixing method: Principle, design and construction, A. A. Balkema, Lisse, Netherlands, 69–107.
Chen, Q., Seifried, A., Andrade, J. E., and Baker, J. W. (2012). “Characterization of random fields and their impact on the mechanics of geosystems at multiple scales.” Int. J. Numer. Anal. Meth. Geomech., 36(2), 140–165.
Cressie, N. A. C. (1993). Statistics for spatial data, Rev. Ed., Wiley, New York.
Fenton, G. A., and Vanmarcke, E. H. (1990). “Simulation of random fields via local average subdivision.” J. Eng. Mech., 1733–1749.
Futaki, M., and Tamura, M. (2002). “The quality control in deep mixing method for the building foundation ground in Japan.” Proc., Tokyo Workshop 2002 on Deep Mixing, M. Kitazume and M. Terashi, eds., Port and Airport Research Institute and Coastal Development Institute of Technology, Tokyo, 139–149.
Griffiths, D. V., and Fenton, G. A. (2007). “Random field generation and the local average subdivision method.” Probabilistic methods in geotechnical engineering, Springer, New York, 201–223.
Griffiths, D. V., Huang, J., and Fenton, G. A. (2009). “Influence of spatial variability on slope reliability using 2-D random fields.” J. Geotech. Geoenviron. Eng., 1367–1378.
Honjo, Y. (1982). “A probabilistic approach to evaluate shear strength of heterogeneous stabilized ground by deep mixing method.” Soils Found., 22(1), 23–38.
Honjo, Y., Otake, Y., Kusano, T., and Hara, T. (2013). “Reliability analysis of 640 m long soil retaining wall for an embedded highway construction.” Proc., 4th Int. Symp. on Geotechnical Safety and Risk, L. M. Zhang, Y. Wang, G. Wang, and D. Q. Li, eds., CRC Press/Balkema, Leiden, Netherlands, 121–126.
Kanji, G. K. (2006). 100 statistical tests, 3rd Ed., SAGE Publications, London, 76–77.
Koseki, J., Sato, T., Mihira, S., Takeya, N. and Yoshizawa, M. (2005). “Comparison of tensile strength of cement treated sand by various test methods.” Proc., Int. Conf. on Deep Mixing, Best Practice and Recent Advances, Swedish Deep Stabilization Research Center, Stockholm, Sweden, 95–100.
Namikawa, T. (2012). “Numerical study of compression behavior of cement-treated columns with strength fields following normal and lognormal distributions.” Proc., Int. Conf. on Ground Improvement and Ground Control, B. Indraratna, C. Rujikiatkamjorn, and J. Vinod, eds., Vol. 2, Research Center for Geomechanics and Railway Engineering, Univ. of Wollongong, Wollongong, Singapore, 1193–1199.
Namikawa, T. (2014). “Evaluation of compressive strength of cement-treated column by numerical simulation with conditional distribution.” J. Soc. Mater. Sci. Jpn., 63(1), 55–60 (in Japanese).
Namikawa, T., and Koseki, J. (2006). “Experimental determination of softening relations for cement-treated sand.” Soils Found., 46(4), 491–504.
Namikawa, T., and Koseki, J. (2007). “Evaluation of tensile strength of cement-treated sand based on several types of laboratory tests.” Soils Found., 47(4), 657–674.
Namikawa, T., and Koseki, J. (2013). “Effects of spatial correlation on the compression behavior of a cement-treated column.” J. Geotech. Geoenviron. Eng., 1346–1359.
Namikawa, T., Koseki, K., and Suzuki, Y. (2008). “Finite element analysis of a full scale bending test of cement treated soil column.” Proc., 12th Int. Conf. of the International Association for Computer Methods and Advances in Geomechanics, International Association for Computer Methods and Advances in Geomechanics, Goa, India, 3635–3641.
Namikawa, T., and Mihira, S. (2007). “Elasto-plastic model for cement-treated sand.” Int. J. Numer. Anal. Meth. Geomech., 31(1), 71–107.
Navin, M. P., and Filz, G. M. (2005). “Statistical analysis of strength date from ground improved with DMM columns.” Proc., Int. Conf. on Deep Mixing, Best Practice and Recent Advances, Swedish Deep Stabilization Research Center, Stockholm, Sweden, 145–154.
Pietruszczak, S. T., and Mróz, Z. (1981). “Finite element analysis of deformation of strain-softening materials.” Int. J. Numer. Meth. Eng., 17(3), 327–334.
Popescu, R., Prevost, J. H., and Deodatis, G. (2005). “3D effects in seismic liquefaction of stochastically variable soil deposits.” Géotechnique, 55(1), 21–31.
Porbaha, A., Shibuya, S., and Kishida, T. (2000). “State of the art in deep mixing technology. Part III: Geomaterial characterization.” Ground Imp., 3(3), 91–110.
Saitoh, S., Suzuki, Y., Nishioka, S., and Okumura, R. (1996). “Required strength of cement improved ground.” Grouting and deep mixing, R. Yonekura, M. Terashi, and M. Shibazaki, eds., Balkema, Rotterdam, Netherlands, 557–562.
Shiomi, T., Shigeno, Y., and Zienkiewicz, O. C. (1993). “Numerical prediction for model no. 1.” Proc., Int. Conf. on the Verification of Numerical Procedures for the Analysis of Soil Liquefaction Problems, A. Kandiah and R. Scott, eds., Balkema, Rotterdam, Netherlands, 213–219.
Tatsuoka, F., Uchida, K., Imai, K., Ouchi, T., and Kohata, Y. (1997). “Properties of cement-treated soils in trans-Tokyo bay highway project.” Ground Imp., 1(1), 37–57.
Zaman, M., Khoury, N., and Solanki, P. (2009). “Finite-element modeling of cementitiously stabilized beams using a smeared fracture approach.” Int. J. Geomech., 34–42.
Information & Authors
Information
Published In
International Journal of Geomechanics
Volume 16 • Issue 1 • February 2016
Copyright
© 2015 American Society of Civil Engineers.
History
Received: Apr 14, 2014
Accepted: Dec 5, 2014
Published online: May 5, 2015
Discussion open until: Oct 5, 2015
Published in print: Feb 1, 2016
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.