Contributions of Internal and External Fouling to Transmembrane Pressure in MBRs: Experiments and Modeling
Publication: Journal of Environmental Engineering
Volume 141, Issue 6
Abstract
This paper reports a new approach to understanding membrane fouling in membrane bioreactors (MBR). The foulants were categorized into those inside the membrane (internal fouling) and those on the membrane forming the so-called external fouling layer (external fouling). The volumes of the internal and external foulants were determined with the aid of a confocal laser scanning microscope (CLSM) after staining the foulants. Thus, the porosities of both the membrane and the external fouling layer were calculated, which explained the contributions of internal and external fouling to transmembrane pressure (TMP) from the standpoint of fundamental filtration theory. The categorical method indicates that external fouling may dominate the long-term operation of MBR with the formation of the external fouling layer, whereas internal fouling, in the form of pore constriction, may cause both initial and final TMP jumps under the operating conditions in the current study. In addition, a mathematical model was developed to dynamically link TMP with the basic filtration parameters (e.g., porosities of the membrane and external fouling layer, thickness of the external fouling layer, pore size inside the membrane, and size of the particles forming the external fouling layer). The model quantitatively describes the contributions of both internal and external fouling and further supports the experimental results.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
This study is part of a project funded by the USEPA (EPA #: CR-83419301), which is greatly appreciated. The authors are also thankful for the assistance from Dr. Barbara Morely and Steven Ready of the Boys Town National Research Hospital, Dr. William Tapprich of the University of Nebraska at Omaha, Dr. Yongfeng Lu, Lisha Fan, and Xueyi Wang of the University of Nebraska–Lincoln.
References
Adav, S. S., et al. (2010). “Stereological assessment of extracellular polymeric substances, exo-enzymes, and specific bacterial strains in bioaggregates using fluorescence experiments.” Biotechnol. Adv., 28(2), 255–280.
Carman, P. (1937). “Fluid flow through granular beds.” Trans. Inst. Chem. Eng., 15, 150–166.
Carman, P. (1938). “Fundamental principles of industrial filtration.” Trans. Inst. Chem. Eng, 16, 168–188.
Carniglia, S. C. (1986). “Construction of the tortuosity factor from porosimetry.” J. Catal., 102(2), 401–418.
Chang, I., Le Clech, P., Jefferson, B., and Judd, S. (2002). “Membrane fouling in membrane bioreactors for wastewater treatment.” J. Environ. Eng., 1018–1029.
Chen, M. Y., Lee, D. J., Yang, Z., Peng, X. F., and Lai, J. Y. (2006). “Fluorescent staining for study of extracellular polymeric substances in membrane biofouling layers.” Environ. Sci. Technol., 40(21), 6642–6646.
Cho, J., Song, K. G., Yun, H., Ahn, K. H., Kim, J. Y., and Chung, T. H. (2005). “Quantitative analysis of biological effect on membrane fouling in submerged membrane bioreactor.” Water Sci. Technol., 51, 9–18.
Choi, H., Zhang, K., Dionysiou, D. D., Oerther, D. B., and Sorial, G. A. (2005). “Effect of permeate flux and tangential flow on membrane fouling for wastewater treatment.” Sep. Purif. Technol., 45(1), 68–78.
Crittenden, J., Trussell, R., Hand, D., Howe, K., and Tchobanoglous, G. (2005). Water treatment: Principles and design, Wiley, Hoboken, NJ.
Duclos-Orsello, C., Li, W., and Ho, C.-C. (2006). “A three mechanism model to describe fouling of microfiltration membranes.” J. Membr. Sci., 280(1), 856–866.
Eckenfelder, W. W. (1966). Industrial water pollution control, McGraw-Hill, Boston.
Fan, X., Urbain, V., Qian, Y., and Manem, J. (2000). “Ultrafiltration of activated sludge with ceramic membranes in a cross-flow process.” Wat. Sci. Tech., 41, 243–250.
Fane, A. G., and Fane, S. A. (2005). “The role of membrane technology in sustainable decentralized wastewater systems.” Wat. Sci. Tech., 51, 317–325.
Ferrando, M., Rŏżek, A., Zator, M., López, F., and Güell, C. (2005). “An approach to membrane fouling characterization by confocal scanning laser microscopy.” J. Membr. Sci., 250(1–2), 283–293.
Han, S.-S., Bae, T.-H., Jang, G.-G., and Tak, T.-M. (2005). “Influence of sludge retention time on membrane fouling and bioactivities in membrane bioreactor system.” Process Biochem., 40(7), 2393–2400.
Hermanowicz, S. W. (2004). “Membrane filtration of biological solids: A unified framework and its applications to membrane bioreactors.” Proc., Water Environment Membrane Technology 2004 Conf., IWA, London.
Hu, M. (2011). “Application of shredded-tire biofilter and membrane bioreactor for greywater reclamation.” M.S. thesis, Univ. of Nebraska, Lincoln, NE.
Huisman, I. H., Prádanos, P., and Hernández, A. (2000). “The effect of protein–protein and protein–membrane interactions on membrane fouling in ultrafiltration.” J. Membr. Sci., 179(1–2), 79–90.
ImageJ [Computer software]. Bethesda, MD, National Institutes of Health.
Imaris [Computer software]. Zurich, Switzerland, Bitplane.
Juang, Y.-C., Adav, S. S., Lee, D.-J., and Lai, J.-Y. (2010). “Influence of internal biofilm growth on residual permeability loss in aerobic granular membrane bioreactors.” Environ. Sci. Technol., 44(4), 1267–1273.
Kallioinen, M., and Nyström, M. (2008). “Membrane surface characterization.” Advanced membrane technology and applications, N. N. Li, A. G. Fane, W. S. W. Ho, and T. Matsuura, eds., Wiley, Hoboken, NJ.
Kimura, K., Naruse, T., and Watanabe, Y. (2009). “Changes in characteristics of soluble microbial products in membrane bioreactors associated with different solid retention times: Relation to membrane fouling.” Water Res., 43(4), 1033–1039.
Koh, L. L. A., Nguyen, T. H., Chandrapala, J., Zisu, B., Ashokkumar, M., and Kentish, S. E. (2014). “The use of ultrasonic feed pre-treatment to reduce membrane fouling in whey ultrafiltration.” J. Membr. Sci., 453, 230–239.
Le-Clech, P., Chen, V., and Fane, T. A. G. (2006). “Fouling in membrane bioreactors used in wastewater treatment.” J. Membr. Sci., 284(1–2), 17–53.
Massé, A., Spérandio, M., and Cabassud, C. (2006). “Comparison of sludge characteristics and performance of a submerged membrane bioreactor and an activated sludge process at high solids retention time.” Water Res., 40(12), 2405–2415.
Meng, F., Chae, S.-R., Drews, A., Kraume, M., Shin, H.-S., and Yang, F. (2009). “Recent advances in membrane bioreactors (MBRs): Membrane fouling and membrane material.” Water Res., 43(6), 1489–1512.
Meng, F., Liao, B., Liang, S., Yang, F., Zhang, H., and Song, L. (2010). “Morphological visualization, componential characterization and microbiological identification of membrane fouling in membrane bioreactors (MBRs).” J. Membr. Sci., 361(1), 1–14.
Meng, F., Zhang, H., Yang, F., and Liu, L. (2007). “Characterization of cake layer in submerged membrane bioreactor.” Environ. Sci. Technol., 41(11), 4065–4070.
Ng, T. C. A., and Ng, H. Y. (2010). “Characterisation of initial fouling in aerobic submerged membrane bioreactors in relation to physico-chemical characteristics under different flux conditions.” Water Res., 44(7), 2336–2348.
Ognier, S., Wisniewski, C., and Grasmick, A. (2002a). “Characterisation and modelling of fouling in membrane bioreactors.” Desalination, 146(1–3), 141–147.
Ognier, S., Wisniewski, C., and Grasmick, A. (2002b). “Membrane fouling during constant flux filtration in membrane bioreactors.” Membr. Technol., 2002(7), 6–10.
Rosenberger, S., et al. (2006). “Impact of colloidal and soluble organic material on membrane performance in membrane bioreactors for municipal wastewater treatment.” Water Res., 40(4), 710–720.
Rosenberger, S., and Kraume, M. (2002). “Filterability of activated sludge in membrane bioreactors.” Desalination, 146(1–3), 373–379.
Song, L. (1998). “Flux decline in crossflow microfiltration and ultrafiltration: Mechanisms and modeling of membrane fouling.” J. Membr. Sci., 139(2), 183–200.
Svarosky, L. (1977). Solid-liquid separation, Butterworth, London.
Tracey, E. M., and Davis, R. H. (1994). “Protein fouling of track-etched polycarbonate microfiltration membranes.” J. Colloid Interface Sci., 167(1), 104–116.
Ueda, T., Hata, K., Kikuoka, Y., and Seino, O. (1997). “Effects of aeration on suction pressure in a submerged membrane bioreactor.” Water Res., 31(3), 489–494.
Visvanathan, C., Aim, R. B., and Parameshwaran, K. (2000). “Membrane separation bioreactors for wastewater treatment.” Crit. Rev. Environ. Sci. Technol., 30(1), 1–48.
Wang, R., Shi, L., Tang, C. Y., Chou, S., Qiu, C., and Fane, A. G. (2010). “Characterization of novel forward osmosis hollow fiber membranes.” J. Membr. Sci., 355(1–2), 158–167.
Wang, Z., Wu, Z., Yin, X., and Tian, L. (2008). “Membrane fouling in a submerged membrane bioreactor (MBR) under sub-critical flux operation: Membrane foulant and gel layer characterization.” J. Membr. Sci., 325(1), 238–244.
Yamammoto, K., Hiasa, H., Mahmood, T., and Matsuo, T. (1989). “Direct solid liquid separation using hollow fiber membrane in an activated sludge aeration tank.” Wat. Sci. Tech., 21, 43–54.
Yamamura, H., Kimura, K., Okajima, T., Tokumoto, H., and Watanabe, Y. (2008). “Affinity of functional groups for membrane surfaces: Implications for physically irreversible fouling.” Environ. Sci. Technol., 42(14), 5310–5315.
Yang, Z., Juang, Y. C., Lee, D. J., and Duan, Y. Y. (2012). “Pore blockage of organic fouling layer with highly heterogeneous structure in membrane filtration: Role of minor organic foulants.” J. Membr. Sci., 411, 30–34.
Yang, Z., Peng, X. F., Chen, M. Y., Lee, D. J., and Lai, J. Y. (2007). “Intra-layer flow in fouling layer on membranes.” J. Membr. Sci., 287(2), 280–286.
Zhang, J., Chua, H. C., Zhou, J., and Fane, A. G. (2006). “Factors affecting the membrane performance in submerged membrane bioreactors.” J. Membr. Sci., 284(1–2), 54–66.
Zhang, T. C., and Bishop, P. L. (1994). “Evaluation of tortuosity factors and effective diffusivities in biofilms.” Water Res., 28(11), 2279–2287.
Information & Authors
Information
Published In
Journal of Environmental Engineering
Volume 141 • Issue 6 • June 2015
Copyright
© 2014 American Society of Civil Engineers.
History
Received: Jan 23, 2014
Accepted: Nov 13, 2014
Published online: Dec 16, 2014
Discussion open until: May 16, 2015
Published in print: Jun 1, 2015
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.