Effect of Elevated Temperature on Ceramic Ultrafiltration of Colloidal Suspensions
Publication: Journal of Environmental Engineering
Volume 141, Issue 6
Abstract
High-temperature wastewaters and process waters in many industries have been a concern, compromising the integrity of polymeric membranes in filtration processes or requiring the temperature to be lowered for further treatments. Filtration processes employing ceramic membranes, however, can treat high temperature water owing to the inherent thermal resistance of ceramic materials, and may benefit from increases in permeate flux attributable to decreases in water viscosity at higher temperatures. In this study, the performance of a ceramic ultrafiltration membrane was evaluated for the filtration of feed solutions containing colloidal silica at temperatures between 25 and 90°C, the range encountered in various industries. Results indicated the net benefit of increasing permeate production at elevated temperatures, with a nearly 90% increase in steady-state flux from 25 to 90°C. However, this increase was lower than that observed for pure water filtration, in which the flux increase with increasing temperature was entirely attributable to viscosity reduction. Resistance-in-series model analysis and cake property characterization suggested that total fouling resistance increased as temperature increased, with physically removable cake formation as the dominant fouling mechanism.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
Tyler Cromey was supported by the Georgia Power Fellowship during this study.
References
Allègre, C., Moulin, P., Maisseu, M., and Charbit, F. (2006). “Treatment and reuse of reactive dyeing effluents.” J. Membr. Sci., 269(1–2), 15–34.
Altmann, J., and Ripperger, S. (1997). “Particle deposition and layer formation at the crossflow microfiltration.” J. Membr. Sci., 124(1), 119–128.
Belfort, G., Davis, R. H., and Zydney, A. L. (1994). “The behavior of suspensions and macromolecular solutions in crossflow microfiltration.” J. Membr. Sci., 96(1–2), 1–58.
Beril Gönder, Z., Arayici, S., and Barlas, H. (2011). “Advanced treatment of pulp and paper mill wastewater by nanofiltration process: Effects of operating conditions on membrane fouling.” Sep. Purif. Technol., 76(3), 292–302.
Boerlage, S. F. E. (2001). “Scaling and particulate fouling in membrane filtration systems.” Ph.D. dissertation, Wageningen Univ., Delft, Netherlands.
Cheryan, M. (1986). Ultrafiltration handbook, Technomic Publishing, Lancaster, PA.
Cheryan, M. (1998). Ultrafiltration and microfiltration handbook, Technomic Publishing, Lancaster, PA.
Chiemchaisri, C., and Yamamoto, K. (1994). “Performance of membrane separation bioreactor at various temperatures for domestic wastewater treatment.” J. Membr. Sci., 87(1–2), 119–129.
Chuang, S. H., Chang, T. C., Ouyang, C. F., and Leu, J. M. (2007). “Colloidal silica removal in coagulation processes for wastewater reuse in a high-tech industrial park.” Water Sci. Technol., 55(1–2), 187.
Daufin, G., Escudier, J. P., Carrère, H., Bérot, S., Fillaudeau, L., and Decloux, M. (2001). “Recent and emerging applications of membrane processes in the food and dairy industry.” Food Bioprod. Process., 79(2), 89–102.
Faibish, R. S., Elimelech, M., and Cohen, Y. (1998). “Effect of interparticle electrostatic double layer interactions on permeate flux decline in crossflow membrane filtration of colloidal suspensions: An experimental investigation.” J. Colloid Interface Sci., 204(1), 77–86.
Finley, J. (2005). “Ceramic membranes: A robust filtration alternative.” Filtr. Sep., 42(9), 34–37.
Freeman, S., and Shorney-Darby, H. (2011). “What’s the buzz about ceramic membranes?” J. Am. Water Works Assoc., 103(12), 12–13.
Garcia-Garcia, S., Jonsson, M., and Wold, S. (2006). “Temperature effect on the stability of bentonite colloids in water.” J. Colloid Interface Sci., 298(2), 694–705.
Guerra, K., and Pellegrino, J. (2012). “Development of a techno-economic model to compare ceramic and polymeric membranes.” Sep. Sci. Technol., 48(1), 51–65.
Higgins, T. E., Sandy, T., and Givens, S. W. (2009). “Flue gas desulfurization wastewater treatment primer.” Power, 153(3), 34–43.
Hong, S., Faibish, R. S., and Elimelech, M. (1997). “Kinetics of permeate flux decline in crossflow membrane filtration of colloidal suspensions.” J. Colloid Interface Sci., 196(2), 267–277.
Huisman, I. H., Dutré, B., Persson, K. M., and Trägårdh, G. (1997). “Water permeability in ultrafiltration and microfiltration: Viscous and electroviscous effects.” Desalination, 113(1), 95–103.
Huisman, I. H., Elzo, D., Middelink, E., and Trägårdh, A. C. (1998). “Properties of the cake layer formed during crossflow microfiltration.” Colloids Surf. Physicochem. Eng. Aspects, 138(2–3), 265–281.
Kallioinen, M., Manttari, M., Nystrom, M., and Nuortila-Jokinen, J. (2007). “Effect of high filtration temperature on regenerated cellulose ultrafiltration membranes.” Sep. Sci. Technol., 42(13), 2863–2879.
Krynicki, K., Green, C. D., and Sawyer, D. W. (1978). “Pressure and temperature dependence of self-diffusion in water.” Faraday Discuss. Chem. Soc., 66, 199–208.
Lahoussine-Turcaud, V., Wiesner, M. R., and Bottero, J.-Y. (1990). “Fouling in tangential-flow ultrafiltration: The effect of colloid size and coagulation pretreatment.” J. Membr. Sci., 52(2), 173–190.
Lamminen, M. O., Walker, H. W., and Weavers, L. K. (2004). “Mechanisms and factors influencing the ultrasonic cleaning of particle-fouled ceramic membranes.” J. Membr. Sci., 237(1), 213–223.
Lee, H., Kim, S. G., Choi, J. S., Kim, S. K., Oh, H. J., and Lee, W. T. (2013a). “Effects of water temperature on fouling and flux of ceramic membranes for wastewater reuse.” Desalin. Water Treat., 51(25–27), 5222–5230.
Lee, S.-H., Chung, K.-C., Shin, M.-C., Dong, J.-I., Lee, H.-S., and Auh, K. H. (2002). “Preparation of ceramic membrane and application to the crossflow microfiltration of soluble waste oil.” Mater. Lett., 52(4–5), 266–271.
Lee, S.-J., Dilaver, M., Park, P.-K., and Kim, J.-H. (2013b). “Comparative analysis of fouling characteristics of ceramic and polymeric microfiltration membranes using filtration models.” J. Membr. Sci., 432, 97–105.
Lindmark, J., Thorin, E., Kastensson, J., and Pettersson, C. M. (2011). “Membrane filtration of process water at elevated temperatures—A way to increase the capacity of a biogas plant.” Desalination, 267(2–3), 160–169.
Mänttäri, M., Pihlajamäki, A., Kaipainen, E., and Nyström, M. (2002). “Effect of temperature and membrane pre-treatment by pressure on the filtration properties of nanofiltration membranes.” Desalination, 145(1–3), 81–86.
McCarthy, A. A., Walsh, P. K., and Foley, G. (2002). “Experimental techniques for quantifying the cake mass, the cake and membrane resistances and the specific cake resistance during crossflow filtration of microbial suspensions.” J. Membr. Sci., 201(1–2), 31–45.
Qu, X., Gao, W. J., Han, M. N., Chen, A., and Liao, B. Q. (2012). “Integrated thermophilic submerged aerobic membrane bioreactor and electrochemical oxidation for pulp and paper effluent treatment—Towards system closure.” Bioresour. Technol., 116, 1–8.
Shu-Sen, W. (1988). “Effect of solution viscosity on ultrafiltration flux.” J. Membr. Sci., 39(2), 187–194.
Singh, G., and Song, L. (2007). “Experimental correlations of pH and ionic strength effects on the colloidal fouling potential of silica nanoparticles in crossflow ultrafiltration.” J. Membr. Sci., 303(1–2), 112–118.
Singh, G., and Song, L. (2008). “Impact of feed water acidification with weak and strong acids on colloidal silica fouling in ultrafiltration membrane processes.” Water Res., 42(3), 707–713.
Snow, M. J. H., de Winter, D., Buckingham, R., Campbell, J., and Wagner, J. (1996). “New techniques for extreme conditions: High temperature reverse osmosis and nanofiltration.” Desalination, 105(1–2), 57–61.
Sójka-Ledakowicz, J., Koprowski, T., Machnowski, W., and Knudsen, H. H. (1998). “Membrane filtration of textile dyehouse wastewater for technological water reuse.” Desalination, 119(1–3), 1–9.
Suganthi, K. S., and Rajan, K. S. (2012). “Temperature induced changes in ZnO–water nanofluid: Zeta potential, size distribution and viscosity profiles.” Int. J. Heat Mass Transfer, 55(25–26), 7969–7980.
Tarleton, E. S., and Wakeman, R. J. (1993). “Understanding flux decline in crossflow microfiltration: Part 1—Effects of particle and pore size.” Chem. Eng. Res. Des., 71(4), 399–410.
Vincent-Vela, M.-C., Cuartas-Uribe, B., Álvarez-Blanco, S., and Lora-García, J. (2012). “Analysis of an ultrafiltration model: Influence of operational conditions.” Desalination, 284, 14–21.
Vladisavljevic, G. T., Milonjic, S. K., Nikolic, D., and Pavasovic, V. L. (1992). “Influence of temperature on the ultrafiltration of silica sol in a stirred cell.” J. Membr. Sci., 66(1), 9–17.
Vyas, H. K., Bennett, R. J., and Marshall, A. D. (2001). “Cake resistance and force balance mechanism in the crossflow microfiltration of lactalbumin particles.” J. Membr. Sci., 192(1–2), 165–176.
Zhang, M., and Song, L. (2000). “Mechanisms and parameters affecting flux decline in cross-flow microfiltration and ultrafiltration of colloids.” Environ. Sci. Technol., 34(17), 3767–3773.
Zhao, Y., Zhang, Y., Xing, W., and Xu, N. (2005). “Treatment of titanium white waste acid using ceramic microfiltration membrane.” Chem. Eng. J., 111(1), 31–38.
Zhu, X., and Elimelech, M. (1997). “Colloidal fouling of reverse osmosis membranes: Measurements and fouling mechanisms.” Environ. Sci. Technol., 31(12), 3654–3662.
Information & Authors
Information
Published In
Copyright
© 2014 American Society of Civil Engineers.
History
Received: Apr 11, 2014
Accepted: Nov 21, 2014
Published online: Dec 15, 2014
Discussion open until: May 15, 2015
Published in print: Jun 1, 2015
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.