Cyclic Behavior of Steel Tube-Confined Circular RC Columns under High Axial Load
Publication: Journal of Structural Engineering
Volume 150, Issue 10
Abstract
This study builds on existing researches to further investigates cyclic responses of the steel tube-confined reinforced concrete (RC) columns, with a primary focus on those subjected to high-axial load. A total of eleven column specimens were tested under lateral displacement reversal and axial load of either or , where and refers to concrete cross section area and tested concrete strength of the column, respectively. Three specimens represented the conventional reinforced concrete (RC) columns while the rest were the steel tube-confined circular RC columns. The key test parameters included (1) amount of longitudinal reinforcement, (2) axial load level, (3) continuity of the confining steel tube, and (4) clear cover of the longitudinal reinforcement. Test results showed that all the steel tube-confined RC specimens sustained the target axial load and maximum lateral strength up to around 10% drift ratio. A simple strength model was proposed to reasonably estimate the maximum strength of the steel tube-confined RC columns. The flexural rigidity ratio, , for RC specimens and specimens confined by continuous steel tube ranged between 0.6 and 0.8, approximately. Specimens confined by the cutoff steel tube showed lower ratio between approximately 0.3 and 0.6.
Get full access to this article
View all available purchase options and get full access to this article.
Data Availability Statement
Some or all data, models, or code that support the findings of this study are available from the corresponding author upon reasonable request.
Acknowledgments
This research was sponsored by the Taiwan Building Technology Center (TBTC) under the Featured Area Research Center Program within the framework of the Higher Education Sprout Project of the Ministry of Education of Taiwan. The ideas and conclusions expressed in this manuscript are those of the authors and may not represent the views of the sponsor.
References
Aboutaha, R. S., and R. I. Machado. 1999. “Seismic resistance of steel-tubed high-strength reinforced-concrete columns.” J. Struct. Eng. 125 (5): 485–494. https://doi.org/10.1061/(ASCE)0733-9445(1999)125:5(485).
ACI (American Concrete Institute). 2019. Building code requirements for structural concrete and commentary (Reapproved 2022). ACI Committee 318. Farmington Hills, MI: ACI.
AISC. 2022. American national standard. Specification for structural steel building. AISC 360-22. Chicago: ACI.
ASCE. 2023. Seismic evaluation and retrofit of existing buildings. ASCE/SEI 41-23. Reston, VA: ASCE.
ASTM. 2022. Standard test method for tension testing of metallic materials. ASTM E8/E8M-22. West Conshohocken, PA: ASTM.
Chen, S. J., K. C. Yang, K. M. Lin, and C. D. Wang. 2011. “Seismic behavior of ductile rectangular composite bridge piers.” Earthquake Eng. Struct. Dyn. 40 (1): 21–34. https://doi.org/10.1002/eqe.1018.
Elwood, K. J., and J. P. Moehle. 2005. “Axial capacity model for shear-damaged columns.” ACI Struct. J. 102 (4): 578–587. https://doi.org/10.14359/14562.
Ichinose, T. 1995. “Splitting bond failure of columns under seismic action.” ACI Struct. J. 92 (5): 535–542. https://doi.org/10.14359/904.
Lai, Z., and A. H. Varma. 2015. “Noncompact and slender circular CFT members: Experimental database, analysis, and design.” J. Constr. Steel Res. 106 (3): 220–233. https://doi.org/10.1016/j.jcsr.2014.11.005.
Lai, Z., A. H. Varma, and K. Zhang. 2014. “Noncompact and slender rectangular CFT members: Experimental database, analysis, and design.” J. Constr. Steel Res. 101 (10): 455–468. https://doi.org/10.1016/j.jcsr.2014.06.004.
Leon, R. T., D. K. Kim, and J. F. Hajjar. 2007. “Limit state response of composite columns and beam-columns part 1: Formulation of design provisions for the 2005 AISC specification.” Eng. J. Am. Inst. Steel Constr. 44 (4): 341–358.
Mander, J. B., M. J. Priestley, and R. Park. 1988. “Theoretical stress-strain model for confined concrete.” J. Struct. Eng. 114 (8): 1804–1826. https://doi.org/10.1061/(ASCE)0733-9445(1988)114:8(1804).
Moehle, J. 2015. Seismic design of reinforced concrete buildings. 1st ed. New York: McGraw-Hill Education.
Rodrigues, H., A. Arêde, and A. G. Costa. 2013. “Experimental evaluation of rectangular reinforced concrete column behaviour under biaxial cyclic loading.” Earthquake Eng. Struct. Dyn. 42: 239–259. https://doi.org/10.1002/eqe.2205.
Sakino, K., Y. P. Sun, and A. Aklan. 1996. “Effects of wall thickness of steel tube on the behavior of square tubed R/C columns.” In Proc., 11th World Conf. on Earthquake Engineering, 690. Acapulco, Mexico: International Association for Earthquake Engineering.
Sezen, H., and J. P. Moehle. 2006. “Seismic tests of concrete columns with light transverse reinforcement.” ACI Struct. J. 103 (6): 842–849. https://doi.org/10.14359/18236.
Sun, Y., and K. Sakino. 1997. “Earthquake-resisting performance of R/C columns confined by square steel tubes: Part 1 Columns under high axial load.” J. Struct. Constr. Eng. 62 (501): 93–101. https://doi.org/10.3130/aijs.62.93_2.
Sun, Y. P., and K. Sakino. 1992. “Flexural behavior of reinforced concrete columns in square steel tube.” In Vol. 8 of Proc., 10th World Conf. on Earthquake Engineering, 4365–4370. Madrid, Spain: International Association for Earthquake Engineering.
Tomii, M., K. Sakino, and Y. Xiao. 1987. “Ultimate moment of reinforced concrete short columns confined in steel tube.” In Vol. 2 of Proc., Pacific Conf. on Earthquake Engineering, 11–22. Wairakei, New Zealand: New Zealand Society for Earthquake Engineering.
Varma, A. H., J. M. Ricles, R. Sause, and L. W. Lu. 2002. “Seismic behavior and modeling of high-strength composite concrete-filled steel tube (CFT) beam–columns.” J. Constr. Steel Res. 58 (5–8): 725–758. https://doi.org/10.1016/S0143-974X(01)00099-2.
Information & Authors
Information
Published In
Copyright
© 2024 American Society of Civil Engineers.
History
Received: Jan 5, 2024
Accepted: Apr 18, 2024
Published online: Jul 31, 2024
Published in print: Oct 1, 2024
Discussion open until: Dec 31, 2024
ASCE Technical Topics:
- Axial loads
- Columns
- Concrete
- Concrete columns
- Engineering fundamentals
- Engineering materials (by type)
- Engineering mechanics
- Load tests
- Material mechanics
- Material properties
- Materials engineering
- Reinforced concrete
- Static loads
- Statics (mechanics)
- Steel columns
- Strength of materials
- Structural analysis
- Structural engineering
- Structural members
- Structural systems
- Tests (by type)
- Tubes (structure)
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.