Bond Behavior of Self-Consolidating Concrete with Mineral and Chemical Admixtures
Publication: Journal of Materials in Civil Engineering
Volume 20, Issue 9
Abstract
Self-consolidating concrete (SCC) is known for its excellent deformability, high resistance to segregation, and use in congested reinforced concrete structures characterized by difficult casting conditions without applying vibration. Research has been conducted on the development of SCC using high volumes of supplementary cementing materials (SCM) (such as fly ash and slag) and viscosity modifying admixtures (VMA). The bond characteristics of such SCCs are very important for their application in practical construction. An extensive investigation was conducted to determine the bond strength between deformed reinforcing steel bar and SCM and VMA based SCC as well as normal concrete (NC). Bond tests were conducted using a specially developed pullout test. The SCC pullout specimens were cast without applying any consolidation, whereas the NC specimens were cast by conventional practice with consolidation and vibration. It was found that the reduction in bond strength due to bleeding and inhomogeneous nature was less in SCC compared to NC. Although the variation in bond strengths at different casting elevations was observed in SCC, the extent was less significant than that of NC. SCC also exhibited a less significant top-bar effect compared to NC. This can be attributed to the more consistent nature of SCC and its superior filling capability. Performance of various code based and other existing bond equations are validated through experimental results illustrating the influence of concrete types (either SCC of different types or NC).
Get full access to this article
View all available purchase options and get full access to this article.
References
American Concrete Institute (ACI) Committee 318. (2002). Building code requirements for structural concrete (ACI 318-02) and commentary (318R-02), Farmington Hills, Mich.
American Concrete Institute (ACI) Committee 408. (2003). Bond and development of state reinforcement in tension, ACI 408R-03, Farmington Hills, Mich.
Arima, I., Takeguchi, M., Sakurai, S., and Hayashi, J. (1994). “The quality of superworkable concrete used for the construction of Akashi-Kaikyo Bridge 4A Anchorage.” Trans. Jpn. Concr. Inst., 16(1), 25–30.
Campion, M. J., and Jost, P. (2000). “Self-compacting concrete.” Concr. Int., 22(4), 31–34.
Canadian Standard Association (CSA). (2004). Design of concrete structures, A 23.3-04, Rexdale, Ont., Canada.
Chan, Y.-W., Chen, Y.-S., and Liu, Y.-S. (2003). “Development of bond strength of reinforcement steel in self-consolidating concrete.” ACI Struct. J., 100(4), 490–498.
Chapman, R. A., and Shah, S. P. (1988). “Early-age bond strength in reinforced concrete.” ACI Mater. J., 84(6), 501–510.
Darwin, D., Zuo, J., Tholen, M. L., and Idun, E. K. (1996). “Development length criteria for conventional and high relative rib area reinforcing bars.” ACI Struct. J., 93(3), 347–359.
Esfahani, M. R., and Rangan, B. V. (1998). “Bond between normal-strength and high-strength concrete (HSC) and reinforcing bars in splices in beams.” ACI Struct. J., 95(3), 272–279.
Fujiwara, H. (1992). “Fundamental study of self-compacting property of high-fluidity concrete.” Trans. Jpn. Concr. Inst., 14(1), 27–32.
Hoshino, M. (1989). “Relationships between bleeding, coarse aggregate, and specimen height of concrete.” ACI Mater. J., 86(2), 185–190.
Hossain, K. M. A. (1999). “Bond in lightweight volcanic pumice concrete.” Proc., 7th East Asia-Pacific Conf. on Structural Engineering and Construction (EASEC7), Vol. 2, Kochi, Japan, 1460–1465.
Hwang, S. J., Leu, Y. R., and Hwang, H. L. (1996). “Tensile bond strengths of deformed bars in high-performance concrete.” ACI Struct. J., 93(1), 1–20.
Jirsa, J. O., Lutz, L. A., and Gergely, P. (1979). “Rationale for suggested development, splice and standard hook provisions for deformed bars in tension.” Concr. Int.: Des. Constr., 1(7), 47–61.
Khayat, K. H. (1998). “Use of viscosity-modifying admixtures to reduce top-bar effect of anchored bars cast with fluid concrete.” ACI Mater. J., 95(2), 158–167.
Khayat, K. H., Paultre, P., and Tremblay, S. (2001). “Structural performance and in-place properties of self-consolidating concrete used for casting highly reinforced columns.” ACI Mater. J., 98(5), 371–378.
Lachemi, M., Hossain, K. M. A., Lambros, V., and Bouzoubaâ, N. (2004). “Development of cost-effective self-consolidating concrete incorporating fly ash, slag cement, or viscosity modifying admixtures.” ACI Mater. J., 100(5), 419–425.
Mathey, R. G., and Watstein, D. (1961). “Investigation of bond in beam and pull-out specimens with high-yield-strength deformed bars.” ACI J., 57(3), 1071–1090.
Okamura, H., and Ozawa, K. (1995). “Mix design for self-compacting concrete.” Concrete Library of Japan Society of Civil Engineers (JSCE), No. 25, June, 107–120.
Orangun, C. O., Jirsa, J. O., and Breen, J. E. (1977). “A reevaluation of test data on development length and splices.” ACI J., 74(3), 114–122.
Ozawa, K., Sakata, N., and Okamura, H. (1995). “Evaluation of self-compactability of fresh concrete using the funnel test.” Concrete Library of Japan Society of Civil Engineers (JSCE), No. 25, June, 59–75.
Petersson, O. (1998). “Application of self-compacting concrete for bridge castings.” Swedish Cement and Concrete Research Institute, Stockholm, Sweden.
Reynolds, G. C. (1977). “Bond strength of deformed bars in tension.” Proc., Symp. on Concrete National Conf., Publication No. 83/12, Institute of Engineers, Perth, Australia, 65–69.
Sakata, N., Maruyama, K., and Minami, M. (1996). “Basic properties and effects of Welan gum on self consolidating concrete.” Production methods and workability of concrete, P. J. M. Bartos et al., eds., E & FN Spon, London, 237–252.
Sonebi, M., Bartos, P. J. M., Zhu, W., Gibbs, J., and Tamimi, A. (2000). “Task 4—Properties of hardened concrete.” Final Rep., Advanced Concrete Masonry Centre, Univ. of Paisley, Scotland, U.K.
Tepfers, R. (1979). “Cracking of concrete cover along anchored deformed reinforcing bars.” Mag. Concrete Res., 106 (March), 3–12.
Uomoto, T., and Ozawa, K. (1999). Recommendation for self-compacting concrete, Japan Society of Civil Engineers, Aug., Japan.
Yurugi, M. (1998). “Application of self-compacting concrete in Japan.” Proc., 23rd OWICS Conf., CI Premier Pte Ltd., Singapore, 29-42.
Information & Authors
Information
Published In
Copyright
© 2008 ASCE.
History
Received: Aug 7, 2006
Accepted: Dec 10, 2007
Published online: Sep 1, 2008
Published in print: Sep 2008
Notes
Note. Associate Editor: Nemkumar Banthia
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.