Influence of Hysteretic Behavior on Equivalent Period and Damping of Structural Systems
Publication: Journal of Structural Engineering
Volume 129, Issue 5
Abstract
Relations for the equivalent period and equivalent damping ratio for the equivalent linear system approach for seismic design are proposed. These relations are based on optimal and values derived from extensive time-history analyses of single-degree-of-freedom systems with six types of hysteretic behavior and a period range of 0.1 to 1.5 s. The proposed relations are more general (in their applicability to a wide range of hysteretic systems) and have stronger ties to physical behavior compared to existing empirical methods for evaluating and The proposed relations address differences in equivalent stiffness resulting from different hysteretic behavior. Simulations show that the optimal associated with the stiffness of the partial load-displacement cycles of a hysteretic system, is the highest for the slip system (with a zero unloading/reloading stiffness) and the lowest for the bilinear elastic system (with an elastic unloading/reloading stiffness). The optimal associated with the energy dissipation capacity of a hysteretic system, is the highest for the elastoplastic system and the lowest for the bilinear elastic system.
Get full access to this article
View all available purchase options and get full access to this article.
References
AASHTO. (1996). Standard specifications for highway bridges, American Association of State Highway and Transportation Officials, 16th Ed., Washington, D.C.
Applied Technology Council (ATC). (1978). “Tentative provisions for the development of seismic regulations for buildings.” ATC-3, Redwood City, Calif.
ATC. (1996). “Seismic evaluation and retrofit of concrete buildings.” ATC-40, Vol. 1, Redwood City, Calif.
Billington S. L., and Kwan, W. P. (2002) “Seismic response of unbonded post-tensioned columns.” Proc., 7th National Conf. on Earthquake Engineering, Earthquake Engineering Research Institute, Boston.
Chopra A. K. (1995). Dynamics of structures, Prentice-Hall, New Jersey.
Chopra, A. K., and Goel, R. K.(2000). “Evaluation of NSP to estimate seismic deformation: SDF systems.” J. Struct. Eng., 126(4), 482–490.
Comité Européen de Normalisation (CEN). (1995). “European prestandard ENV 1998-1-1: Eurocode 8-Earthquake resistant design of structures, part 1: General rules and rules for buildings.” Comité Europeen de Normalisation, Brussels.
Deierlein, G. G., and Hsieh, S.-H. (1990). “Seismic response of steel frames with semi-rigid connections using the capacity spectrum method.” Proc., 4th U.S. National Conf. on Earthquake Engineering, 2, 863–872.
Federal Emergency Management Agency (FEMA). (1997a). “NEHRP guidelines for the seismic rehabilitation of buildings.” FEMA-273, Washington, D.C.
FEMA. (1997b). “NEHRP commentary on the guidelines for the seismic rehabilitation of buildings.” FEMA-274, Washington, D.C.
Gulkan, P., and Sozen, M. A.(1974). “Inelastic responses of reinforced concrete structures to earthquake motions.” J. Am. Concr. Inst., 71(12), 604–610.
International Conference of Building Officials (ICBO). (1997). Uniform building code, Whittier, Calif.
Iwan, W. D.(1980). “Estimating inelastic response spectra from elastic spectra.” Earthquake Eng. Struct. Dyn., 8(4), 375–388.
Iwan, W. D., and Gates, N. C.(1979). “The effective period and damping of a class of hysteretic structures.” Earthquake Eng. Struct. Dyn., 7(3), 199–211.
Kowalsky, M. J., Priestley, M. J. N., and MacRae, G.(1995). “Displacement-based design of RC bridge columns in seismic regions.” Earthquake Eng. Struct. Dyn., 24(12), 1623–1643.
Kurama, Y. C., Pessiki, S., Sause, R., and Lu, L.-W.(1999). “Seismic behavior and design of unbonded post-tensioned precast concrete walls.” PCI J., 44(3), 72–89.
Kwan, W.-P. (2001). “Seismic analysis, behavior and performance-based design of unbonded post-tensioned concrete substructure systems.” PhD dissertation, Cornell Univ., New York, Research 01-01.
Kwan, W.-P., and Billington, S. L.(2003a). “Unbonded post-tensioned concrete bridge piers. I: Monotonic and cyclic analyses.” J. Bridge Eng., 8(2), 92–101.
Kwan, W.-P., and Billington, S. L.(2002b). “Unbonded post-tensioned concrete bridge piers. II: Seismic analyses.” J. Bridge Eng., 8(2), 102–111.
Mahin, S., and Bertero, V. V.(1981). “Evaluation of inelastic seismic design spectra.” J. Struct. Div. ASCE, 107(9), 1777–1795.
Miranda, E., and Bertero, V. V.(1994). “Strength reduction factors for earthquake-resistant design.” Earthquake Spectra, 10(2), 357–379.
Newmark, N. M., and Hall, W. J. (1973). “Procedures and criteria for earthquake-resistant design.” Building practices for disaster mitigation, Building Science Series 46, Bureau of Standards, Washington, D.C., 209–237.
Paret, T. F., Sasaki, K. K., Eilbekc, D. H., and Freeman, S. A. (1996). “Approximate inelastic procedures to identify failure mechanisms from higher mode effects.” Paper No. 966, 11th World Conf. on Earthquake Engineering, Acapulco, Mexico.
Park, Y. J., and Ang, A. H.-S.(1985). “Mechanistic seismic damage model for reinforced concrete.” J. Struct. Eng., 111(4), 722–739.
Priestley, M. J. N., Seible, F., and Calvi, G. M. (1996). Seismic design and retrofit of bridges, Wiley, New York.
Reinhorn, A. M., Li, C., and Constantinou, M. C. (1995). “Experimental and analytical investigations of seismic retrofit of structures with supplemental damping.” Rep. No. NCEER-95-0001, National Center of Earthquake Engineering Research., State Univ. of New York, Buffalo, New York.
SAC. (1997). Draft report: Develop suites of time histories, SAC Joint Venture Steel Project Phase 2, Project Task: 5.4.1, Richmond, Calif., 〈http://nisee.berkeley.edu/data/strong-motion/sacsteel/draftreport.html〉
Stanton, J. F., Stone, W., and Cheok, G. S.(1997). “A hybrid reinforced precast frame for seismic regions.” PCI J., 42(2), 20–32.
Information & Authors
Information
Published In
Copyright
Copyright © 2003 American Society of Civil Engineers.
History
Received: Dec 26, 2001
Accepted: Jun 17, 2002
Published online: Apr 15, 2003
Published in print: May 2003
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.