Investigation of the Buckling Capacity of Concrete Encased Steel H-Piles on Highway Bridge Structures
Publication: Journal of Bridge Engineering
Volume 28, Issue 11
Abstract
Concrete encasements are usually utilized to protect bridge above-ground piles from corrosion. These concrete encasements are usually square or round shapes reinforced by longitudinal rebars. However, the contributions of concrete encasements are not considered in traditional pile design procedures. On the other hand, rating engineers need to have realistic evaluations of the piles to estimate the capacity of the foundation for scour-critical bridges. Underestimation and overestimation of pile capacity can result in either potential bridge failure or uneconomical assessment. The objective of this paper is to investigate the effect of concrete encasement on pile buckling behavior subject to concentric load. To achieve this objective, four full-scale concrete encased pile specimens with various pile and concrete encasement lengths were fabricated and tested with concentric axial loading to measure the specimen ultimate capacity. In addition, the finite-element (FE) approach was utilized to simulate the buckling behavior and predict the ultimate capacities of the lab-tested specimens. The developed FE models were validated against the laboratory test data. Finally, the validated FE models were utilized in the parametric study to investigate the effect of the length and shape of the concrete encasement on the ultimate capacities of the steel H-piles. The results indicated that the concrete encasement could increase the buckling load of the pile, and ignoring the effect of the concrete encasement, as with the use of the equations suggested by the AISC, could result in a significantly underestimated prediction. It was also found that the concrete encasement increases the initial axial stiffness of the pile before the buckling load is achieved.
Get full access to this article
View all available purchase options and get full access to this article.
Data Availability Statement
All data, models, or codes that support the findings of this study are available from the corresponding author upon reasonable request.
References
Abdulazeez, M. M., K. Brown, and M. A. ElGawady. 2020. “Interfacial shear bond strength between steel H-piles and polymer concrete jackets.” Transp. Res. Rec. 2674 (4): 314–324. https://doi.org/10.1177/0361198120909837.
AISC. 2017. AISC steel construction manual. 15th ed. Chicago: AISC.
ASTM. 2021. Standard specification for high-strength low-alloy columbium-vanadium structural steel. ASTM A572. West Conshohocken, PA: ASTM.
Castilla, F., P. Martin, and J. Link. 1984. Fixity of members embedded in concrete. Champaign, IL: Army Construction Engineering Research Laboratory.
Dahlberg, J., B. M. Phares, Z. Liu, and K. S. Freeseman. 2023. “Investigation of the pier response during the lateral slide of multi-span bridges.” Transp. Res. Rec. 2677: 03611981231155431. https://doi.org/10.1177/03611981231155431.
Dawood, M., H. Karagah, C. Shi, A. Belarbi, and C. Vipulanandan. 2017. Repair systems for deteriorated bridge piles. Austin, TX: Texas Dept. of Transportation Research and Technology Implementation Office.
Deng, Y., B. M. Phares, and P. Lu. 2018. Development of a rapid assessment tool for pile capacity and stability in response to scour situations. Final Rep. Washington, DC: Iowa Dept. of Transportation, Federal Highway Administration.
DOT. 2009. LRFD bridge design manual commentary. Ames, IA: DOT, Bridges and Structures Bureau.
DOT. 2021. LRFD bridge design manual. Ames, IA: DOT, Bridges and Structures Bureau.
El-Barbary, A. A., M. T. Elmihilmy, and W. W. El-Tahan. 2011. “Experimental tests on short composite and internally reinforced concrete columns.” Int. J. Struct. Eng. 2 (1): 35–49. https://doi.org/10.1504/IJSTRUCTE.2011.038068.
ElGawady, M. A., M. M. Abdulazeez, and S. Ahmed Gheni. 2019. Behavior and repair of corroded steel H-piles phase I (axial behavior). Lincoln, NE: Mid-America Transportation Center.
Freeseman, K., Z. Liu, J. M. Dahlberg, and B. M. Phares. 2021. Multi-span lateral slide laboratory investigation: Phase I. Rep. No. ABC-UTC-2016-C3-ISU02-Final. Washington, DC: US Dept. of Transportation Office of the Assistant Secretary for Research and Technology.
Hannigan, P. J., F. Rausche, L. E. Garland, B. R. Robinson, M. L. Becker, and H. Shelsta. 2016. Vol. I of Design and construction of driven pile foundations workshop manual. Washington, DC: US Dept. of Transportation, Federal Highway Administration.
Hughes, D., G. E. Ramey, and M. L. Hughes. 2007a. “Effects of extreme scour and soil subgrade modulus on bridge pile bent buckling.” Pract. Period. Struct. Des. Constr. 12 (2): 96–108. https://doi.org/10.1061/(ASCE)1084-0680(2007)12:2(96).
Hughes, D., G. E. Ramey, and M. L. Hughes. 2007b. “Bridge pile bent number of piles and XBracing system: Impact on pushover capacity as scour increases.” Pract. Period. Struct. Des. Constr. 12 (2): 82–89. https://doi.org/10.1061/(ASCE)1084-0680(2007)12:2(82).
Karagah, H., M. Dawood, and A. Belarbi. 2018. “Experimental study of full-scale corroded steel bridge piles repaired underwater with grout-filled fiber-reinforced polymer jackets.” J. Compos. Constr. 22: 04018008. https://doi.org/10.1061/(ASCE)CC.1943-5614.0000847.
Kattell, J. 1998. Vol. 9877 of Bridge scour evaluation: Screening, analysis, & countermeasures. San Dimas, CA: USDA Forest Service, San Dimas Technology and Development Center.
Kent, D. C., and R. Park. 1971. “Flexural members with confined concrete.” J. Struct. Div. 97 (7): 1969–1990. https://doi.org/10.1061/JSDEAG.0002957.
Khodair, Y., and A. Abdel-Mohti. 2014. “Numerical analysis of pile–soil interaction under axial and lateral loads.” Int. J. Concr. Struct. Mater. 8 (3): 239–249. https://doi.org/10.1007/s40069-014-0075-2.
Klohn, E., and G. T. Hughes. 1964. “Buckling of load unsupported timber piles.” J. Soil Mech. Found. Div. 90 (6): 107–124.
Lagasse, P. F., P. E. Clopper, L. W. Zevenbergen, and L. G. Girard. 2007. Countermeasures to protect bridge piers from scour. Washington, DC: Transportation Research Board.
Liang, F., C. R. Bennett, R. L. Parsons, J. Han, and C. Lin. 2009. “A literature review on behavior of scoured piles under bridges.” In Contemporary topics in in situ testing, analysis, and reliability of foundations, edited by M. Iskander, D. F. Laefer, and M. H. Hussein, 482–489. Reston, VA: ASCE.
Liang, F., H. Zhang, and M. Huang. 2015. “Extreme scour effects on the buckling of bridge piles considering the stress history of soft clay.” Nat. Hazard. 77 (2): 1143–1159. https://doi.org/10.1007/s11069-015-1647-4.
Lin, C., C. Bennett, J. Han, and R. L. Parsons. 2012. “Integrated analysis of the performance of pile-supported bridges under scoured conditions.” Eng. Struct. 36: 27–38. https://doi.org/10.1016/j.engstruct.2011.11.015.
Liu, X., A. Nanni, and P. F. Silva. 2005. “Rehabilitation of compression steel members using FRP pipes filled with non-expansive and expansive light-weight concrete.” Adv. Struct. Eng. 8 (2): 129–141. https://doi.org/10.1260/1369433054038029.
Liu, Z., A. Alomari, and B. M. Phares. 2022. Multi-span lateral slide laboratory investigation: Phase II. No. InTrans Project 22-786. Ames, IA: Iowa State Univ., Bridge Engineering Center.
Liu, Z., K. S. Freeseman, J. M. Dahlberg, B. M. Phares, and M. LaViolette. 2021a. Lateral slide of multi-span bridges: Investigation of connections and other details—Phase I. InTrans Project 19-691. Ames, IA: Iowa State Univ., Bridge Engineering Center.
Liu, Z., K. S. Freeseman, B. M. Phares, and S. Mousavi. 2021b. Experimental validation of a rapid assessment tool for pile capacity and stability in response to scour situations. InTrans Project 19-692. Ames, IA: Iowa State Univ., Bridge Engineering Center.
McClelland, B., and J. A. Focht. 1958. “Soil modulus for laterally loaded piles.” Trans. ASCE 123 (1): 1049–1063. https://doi.org/10.1061/TACEAT.0007599.
Rahman, S., M. Begum, and R. Ahsan. 2016. “Comparison between experimental and numerical studies of fully encased composite columns.” Int. J. Struct. Constr. Eng. 10 (6): 756–763.
Shi, C., H. Karagah, A. Belarbi, and M. Dawood. 2016. “Inelastic buckling behavior of steel H-piles with localized severe corrosion.” J. Bridge Eng. 21 (3): 04015069. https://doi.org/10.1061/(ASCE)BE.1943-5592.0000826.
Stauffer, S. T. 2016. Performance assessment of deteriorated and retrofitted steel HP piles, 1–129. Lincoln, NE: Univ. of Nebraska, Mid-America Transportation Center
Subramanian, N. 1999. Principles of space structures. Prayagraj, India: A H Wheeler.
Timoshenko, S., and J. M. Gere. 2009. Theory of elastic stability. Mineola, NY: Dover.
Vijay, P. V., P. R. Soti, H. V. S. GangaRao, R. G. Lampo, and J. D. Clarkson. 2016. “Repair and strengthening of submerged steel piles using GFRP composites.” J. Bridge Eng. 21 (7): 04016038. https://doi.org/10.1061/(ASCE)BE.1943-5592.0000903.
Vogt, N., S. Vogt, and C. Kellner. 2009. “Buckling of slender piles in soft soils.” Bautechnik 86 (S1): 98–112. https://doi.org/10.1002/bate.200910046.
Wang, C. M., C. Y. Wang, and J. N. Reddy. 2004. Exact solutions for buckling of structural members, 1–205. Boca Raton, FL: CRC Press.
Winkler, E. 1867. Die Lehre von Elastizitat und Festigkeit (on Elasticity and Fixity). Prague: Dominicus.
Ziemian, R. D. 2010. Guide to stability design criteria for metal structures. 6th ed. Hoboken, NJ: Wiley.
Information & Authors
Information
Published In
Copyright
© 2023 American Society of Civil Engineers.
History
Received: Dec 28, 2022
Accepted: Jul 13, 2023
Published online: Sep 7, 2023
Published in print: Nov 1, 2023
Discussion open until: Feb 7, 2024
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.