Estimation of Potential Transportation and Building Energy Performance of Commercial Office Site Alternatives
Publication: Journal of Urban Planning and Development
Volume 141, Issue 1
Abstract
The energy efficiency of urban infrastructure is in large part influenced by the efficient utilization of transportation and building systems. Opportunities for more efficient utilization of transportation and building systems are available in the context of commercial office building/site selection. Office location decision makers have an opportunity to select buildings and locations that potentially minimize building and transportation energy consumption within a given urban context. The objective of the research presented in this paper was to apply a calculation framework for estimating the potential transportation energy and building energy consumption of commercial office building/site alternatives. The calculation framework was applied to case studies of commercial office buildings/sites that represent typical developments found in the transportation and land-use context of the Atlanta, Georgia, metropolitan region. The framework leverages building energy simulation models and regional travel demand model data to estimate energy performance under uncertainty. Importantly, the calculation results indicate that transportation is a major determinant of commercial office building/site energy performance. Incorporation of the framework into sustainable development policy or market transformation tools (e.g., green building rating systems) could accommodate more performance-based planning of efficient infrastructure utilization.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
This research was supported through a National Science Foundation (NSF) Graduate Research Fellowship.
References
American Society of Heating, Refrigerating and Air-Conditioning Engineers (ASHRAE). (2007). User’s manual for ANSI/ASHRAE/IESNA standard 90.1-2007, Atlanta.
American Society of Heating, Refrigerating and Air-Conditioning Engineers. (2010). “Energy standard for buildings except low-rise residential buildings.” ANSI/ASHRAE/IESNA Standard 90.1-2010, Atlanta.
American Society of Heating, Refrigerating and Air-Conditioning Engineers. (2011). “Proposed revision of standard 100-2006, energy conservation in existing buildings.” ANSI/ASHRAE/IESNA Standard 100-2006R, Atlanta.
Atlanta Regional Commission. (2010). “Developments of regional impact.” 〈http://www.atlantaregional.com/land-use/developments-of-regional-impact〉 (Jul. 29, 2010).
Center for Neighborhood Technology. (2011). “Transportation energy intensity TEI calculator, beta.” 〈http://tei.cnt.org/index.php〉 (Jul. 15, 2011).
Deru, M., et al. (2011). “U.S. Department of Energy commercial reference building models of the national building stock.”, U.S. Dept. of Energy, Washington, DC.
Georgia Regional Transportation Authority. (2008). GRTA DRI review package technical guidelines, Atlanta.
Green Building Initiative. (2009). Green Globes’ new construction module, Portland, OR.
International Initiative for a Sustainable Built Environment. (2007). An overview of SBTool September 2007 release, Ottawa, ON.
James J. Hirsch & Associates. (2010). “eQUEST v3.64.” 〈http://doe2.com/equest/〉 (Aug. 1, 2010).
National Energy Technology Laboratory. (2011). 2010 buildings energy data book, Dept. of Energy, Washington, DC.
Oak Ridge National Laboratory. (2010). Transportation energy data book, Dept. of Energy, Washington, DC.
Peterson, K., and Crowther, H. (2010). “Building EUIs.” High performing buildings, American Society of Heating, Refrigerating and Air-Conditioning Engineers, Atlanta, GA, 40–50.
Rimpo and Associates (2007). URBEMIS environmental management software v9.2.4, Jones & Stokes Associates, Sacramento, CA, 〈http://www.urbemis.com/〉 (Aug. 6, 2010).
Thomas, M., and Edwards, S. (2000). Transport and buildings: Reducing the environmental impact, BRE Global, Watford, U.K.
U.S. Energy Information Administration. (2010). “Commercial buildings energy consumption survey (CBECS).” 〈http://www.eia.doe.gov/emeu/cbecs/〉 (Jul. 14, 2010).
U.S. Green Building Council (USGBC). (2008a). LEED 2009 for new construction and major renovations, Washington, DC.
U.S. Green Building Council (USGBC). (2008b). LEED 2009 for commercial interiors, Washington, DC.
U.S. Green Building Council (USGBC). (2008c). LEED 2009 for core and shell development, Washington, DC.
U.S. Green Building Council (USGBC). (2008d). LEED 2009 for existing buildings operations and maintenance, Washington, DC.
U.S. Green Building Council (USGBC). (2009). LEED 2009 for neighborhood development, Washington, DC.
U.S. Green Building Council (USGBC). (2011). Transportation energy intensity calculator project, Center for Neighborhood Technology, Chicago, IL.
U.S. Green Building Council (USGBC). (2013). LEED V4 for building design and construction, Washington, DC.
Weigel, B. (2011). “Development of a commercial building site selection framework for minimizing greenhouse gas emissions and energy consumption.” World Sustainable Building Conf., International Initiative for a Sustainable Built Environment, Ottawa, ON.
Weigel, B. (2012). “Evaluation of the potential commute energy consumption of commercial office site alternatives.” 91st Annual Meeting of the Transportation Research Board, Transportation Research Board, Washington, DC.
Wilson, A., and Navaro, R. (2007). “Driving to green buildings: The transportation energy intensity of buildings.” Environmental Building News.
Information & Authors
Information
Published In
Copyright
© 2014 American Society of Civil Engineers.
History
Received: Jun 19, 2012
Accepted: Jan 3, 2014
Published online: Mar 10, 2014
Discussion open until: Aug 10, 2014
Published in print: Mar 1, 2015
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.