Merging Preparation Behavior of Drivers: How They Choose and Approach Their Merge Positions at a Congested Weaving Area
Publication: Journal of Transportation Engineering
Volume 142, Issue 9
Abstract
Vehicle merging is a tactical process. In the existing merging models, drivers need to select a target gap and adjust their speed to reach a comfortable merge position to execute lane changing. However, such sequential premerging preparation process has not yet been well-captured on the basis of the field trajectory data. In this study, the authors will focus on analyzing the lane-changing behavior as drivers choose and approach their merge positions at congested merging areas. This study is based on noise-filtered computer-based trajectory data. The authors classify the observed merging vehicles in a congested weaving section into original-gap-targeting (OGT) and forward-gap-targeting (FGT) vehicles. The analysis of the merge-position selection indicates different selection behavior between OGT and FGT merging vehicles. The length of target gap, the speed, and the route plan of vehicles surrounding the merging vehicles have an influence on their merge-position selection. To investigate merge tactics of merging vehicles, their speed synchronization and acceleration behaviors when approaching their merge positions were analyzed. The results illustrate that the acceleration and deceleration behaviors of the FGT merging vehicles in the approaching process should be split into two distinct stages: acceleration to overtake the rejected gap and deceleration to execute speed synchronization. The findings from this study shed light on the complex lane-changing process at merging areas.
Get full access to this article
View all available purchase options and get full access to this article.
References
Ahammed, M., Hassan, Y., and Sayed, T. (2008). “Modeling driver behavior and safety on freeway merging areas.” J. Transp. Eng., 370–377 .
Ahmed, K. I. (1991). “Modeling drivers’ acceleration and lane changing behavior.” Ph.D. thesis, Massachusetts Institute of Technology, Boston.
Choudhury, C., Ramanujam, V., and Ben-Akiva, M. (2009). “Modeling acceleration decisions for freeway merges.” Transp. Res. Rec., 2124, 45–57.
Cohen, S. L. (2004). “Application of relaxation procedure for lane changing in microscopic simulation models.” Transp. Res. Rec., 1883, 50–58.
Daamen, W., and Loot, M., and Hoogendoorn, S. P. (2010). “Empirical analysis of merging behavior at freeway on-ramp.” Transp. Res. Rec., 2188, 108–118.
DOT (U.S. Dept. of Transportation) and FHWA (Federal Highway Administration). (2006). “Next Generation SIMulation (NGSIM) traffic analysis tools.” 〈http://ops.fhwa.dot.gov/trafficanalysistools/ngsim.htm〉 (Dec. 20, 2016).
Hidas, P. (2002). “Modeling lane changing and merging in microscopic traffic simulation.” Transp. Res. Part C: Emerging Technol., 10(5–6), 351–371.
Hidas, P. (2005). “Modelling vehicle interactions in microscopic simulation of merging and weaving.” Transp. Res. Part C: Emerging Technol., 13(1), 37–62.
Hofmann, P., Rinkenauer, G., and Gude, D. (2010). “Preparing lane changes while driving in a fixed-base simulator: Effects of advance information about direction and amplitude on reaction time and steering kinematics.” Transp. Res. Part F, 13(4), 255–268.
Kazi, A. I. (1991). “Modeling drivers’ acceleration and lane changing behavior.” Ph.D. thesis, Massachusetts Institute of Technology, Boston.
Kim, J. T., Kim, J., and Chang, M. (2008). “Lane-changing gap acceptance model for freeway merging in simulation.” Can. J. Civ. Eng., 35(3), 301–311.
Kim, T., Lovell, D. J., and Park, Y. (2007). “Empirical analysis of underlying mechanisms and variability in car-following behavior.” Transp. Res. Rec., 1999, 170–179.
Kou, C. C., and Machemehl, R. (1997). “Modeling driver behavior during merge maneuvers.” Southwest Region Univ. Transportation Center, Center for Transportation Research, Univ. of Texas, Austin, TX.
Laval, J. A., and Leclercq, L. (2008). “Microscopic modeling of the relaxation phenomenon using a macroscopic lane-changing model.” Transp. Res. Part B-Methodol., 42(6), 511–522.
Leclercq, L., Chiabaut, N., Laval, J. A., and Buisson, C. (2007). “Relaxation phenomenon after lane changing—Experimental validation with NGSIM data set.” Transp. Res. Rec., 1999, 79–85.
Liu, H., Xin, W., Adam, Z., and Ban, J. (2007). “A game theoretical approach for modelling merging and yielding behavior at freeway on-ramp sections.” Proc., 17th Int. Symp. on Transportation and Traffic Theory, London.
Marczak, F., Daamen, W., and Buisson, C. (2013). “Merging behavior: Empirical comparison between two sites and new theory development.” Transp. Res. Part C, 36(1), 530–546.
Moridpour, S., Rose, G., and Sarvi, M. (2010). “Effect of surrounding traffic characteristics on lane changing behavior.” J. Transp. Eng., 973–985.
Punzo, V., Borzacchiello, M. T., and Ciuffo, B. (2011). “On the assessment of vehicle trajectory data accuracy and application to the Next Generation SIMulation (NGSIM) program data.” Transp. Res. Part C, 19(6), 1243–1262.
Roess, R. P., and Ulerio, J. M. (2007). “Analysis of four weaving sections: Implications for modeling.” Proc., 86th Annual Meeting of the Transportation Research Board, Washington, DC.
Salvucci, D. D., and Liu, A. (2002). “The time course of a lane change: Driver control and eye-movement behavior.” Transp. Res. Part F, 5(2), 123–132.
Sarvi, M., Ejtemai, O., and Zavabeti, A. (2011). “Modelling freeway weaving maneuver.” Proc., 34th Australasian Transport Research Forum (ATRF), South Australian Dept. for Transport, Energy and Infrastructure, and Univ. of South Australia, Adelaide, Australia.
Sarvi, M., and Kuwahara, M. (2007). “Microsimulation of freeway ramp merging processes under congested traffic conditions.” IEEE Trans. Intell. Transp. Syst., 8(3), 470–479.
Schakel, W. J., Knoop, V. L., and Arem, B. V. (2012). “LMRS: An integrated lane change model with relaxation and synchronization.” Proc., 91th Annual Meeting of the Transportation Research Board, Washington, DC.
Sun, D., and Kondyli, A. (2010). “Modeling vehicle interactions during lane-changing behavior on arterial streets.” Comput.-Aided Civ. Infrastruct. Eng., 25(8), 557–571.
Thiemann, C., Treiber, M., and Kesting, A. (2008). “Estimating acceleration and lane-changing dynamics based on NGSIM trajectory data.” Transp. Res. Rec., 2088, 90–101.
Toledo, T. (2002). “Integrated driving behavior models.” Ph.D. thesis, Dept. of Civil and Environmental Engineering, Massachusetts Institute of Technology, Cambridge, MA.
Wan, X., Jin, J., Zheng, L., Cheng, Y., and Ran, B. (2013). “Speed synchronization process of merging vehicles from the entrance ramp: empirical analysis.” Transp. Res. Rec., 2391, 11–21.
Wang, J., Liu, R., and Montgomery, F. (2005). “A simulation model for motorway merging behavior.” Proc., 16th Int. Symp. on Transportation and Traffic Theory, H. S. Mahmassani, ed., Elsevier, New York.
Winsum, V. W., Waard, D. D., and Brookhuis, A. K. (1999). “Lane change manoeuvres and safety margins.” Transp. Res. Part F, 2(3), 139–149.
Yeo, H., Skabardonis, A., Halkias, J., Colyar, J., and Vassili, A. (2008). “Oversaturated freeway flow algorithm for use in next generation simulation.” Transp. Res. Rec., 2088, 68–79.
Information & Authors
Information
Published In
Copyright
© 2016 American Society of Civil Engineers.
History
Received: Sep 12, 2014
Accepted: Feb 11, 2016
Published online: Apr 15, 2016
Published in print: Sep 1, 2016
Discussion open until: Sep 15, 2016
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.