Development of the Triangular Model for Pavement Evaluation Using the Rolling Wheel Deflectometer
Publication: Journal of Transportation Engineering
Volume 139, Issue 3
Abstract
Using the rolling wheel deflectometer (RWD), which measures pavement deflections at traffic speeds, offers the potential to characterize the structural capacity of the road network without major delays and to do so in a cost-effective way. To optimize using the RWD at the network level, an assessment tool is needed to incorporate RWD data into a current pavement management system (PMS) and to identify pavements in need of maintenance or rehabilitation. The objective of this study is to present the development of a screening tool, referred to as the pavement-assessment triangular model, to predict overall pavement conditions on the basis of RWD deflection, roughness measurements, and surface conditions as described by a pavement condition index (PCI). Formulation of the proposed tool and its application were based on data collected during evaluation and testing of RWDs in Louisiana. This screening tool may be used at the network level to identify sites in poor condition and to conduct additional testing using the falling weight deflectometer (FWD) on the identified sites or to select a rehabilitation treatment option based on RWD measurements and PMS data.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
The financial support provided by the Louisiana Transportation Research Center (LTRC) is greatly appreciated. The contents of this paper do not necessarily reflect the official views or policies of the Louisiana Department of Transportation and Development (LADOTD) or the Louisiana Transportation Research Center. The authors would like to acknowledge the assistance of R. Bandaru of Louisiana State University, D. Steele of ARA, Inc., and Ashley Horne, Christophe Fillastre, and James Lee of LADOTD.
References
AASHTO. (1993). “Guide for design of pavement structures.” Washington, DC.
Abdel-Khalek, A., Elseifi, M. A., Gaspard, K., and Zhang, Z. (2012). “A model to assess pavement structural conditions at the network level.” Transportation Research Record, Transportation Research Board, Washington, DC, in press.
ASTM. (2008). “Standard guide for general deflection measurements.”, West Conshohocken, PA.
ASTM. (2009). “Standard test method for deflections with a falling weight-type impulse load device.”, West Conshohocken, PA.
Briggs, R. C., Johnson, R. F., Stubstad, R. N., and Pierce, L. (2000). “A comparison of the rolling weight deflectometer with the falling weight deflectometer.” Nondestructive testing of pavements and back calculation of moduli, S. D. Tayabji and E. O. Lukanen, eds., Vol. 3, ASTM, West Conshohocken, PA, 444–456.
Elseifi, M. A., Abdel-Khalek, A., Gaspard, K., Zhang, Z., and Ismail, S. (2012). “Evaluation of continuous deflection testing using the rolling wheel deflectometer in Louisiana.” J. Transp. Eng., 138(4), 414–422.
Fugro Roadware. (2012). “Automatic Road Analyzer (ARAN).” 〈http://www.fugroroadware.com/related/down-loads/General_Brochure_01,2012〉 (May 2012).
Gedafa, D. S., Hossain, M., Miller, R., and Steele, D. (2008). “Network level pavement structural evaluation using rolling wheel deflectometer.” Proc., Transportation Research Board 87th Annual Meeting, Transportation Research Board, Washington, DC, 1–20.
Groog, M. G., and Hall, J. W. (2004). “Measuring pavement deflection at 55 mph.” Public Roads, 67(4), 18.
Hossain, M., Chowdhury, T., and Gisi, A. J. (2005). “Network pavement structural evaluation.” Proc., Transportation Research Board 78th Annual Meeting, Transportation Research Board, Washington, DC.
Huang, Y. H. (2004). Pavement analysis and design, 2nd Ed., Pearson, Upper Saddle River, NJ.
Khattak, M. J., Baladi, G. Y., Zhang, Z., and Ismail, S. (2008). “A review of the pavement management system of State of Louisiana: Phase I.”, Transportation Research Board, Washington, DC, 18–27.
Peekna, A. (2002). “Data reduction procedures and effects of propagation of errors for the rolling deflectometer.” Rev. Ing. Constr., 18(2), 79–85.
Shahin, M. Y. (2005). Pavement management for airports, roads, and parking lots, Springer Science, New York.
Steele, D., Hall, J., Stubstad, R., Peekna, A., and Walker, R. (2009). “Development of a high speed rolling wheel deflectometer.” Proc., Transportation Research Board 88th Annual Meeting, Transportation Research Board, Washington, DC.
Zaghloul, S., Marukic, I., Ahmed, Z., Vitillo, N. P., Sauber, R. W., and Jumikis, A. A. (2004). “Development of network-level structural adequacy index model for New Jersey Department of Transportation pavement management system.” Proc., Transportation Research Board 83rd Annual Meeting (CD-ROM), Transportation Research Board, Washington, DC.
Information & Authors
Information
Published In
Copyright
© 2013 American Society of Civil Engineers.
History
Received: Jan 14, 2012
Accepted: Sep 5, 2012
Published online: Sep 6, 2012
Published in print: Mar 1, 2013
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.