Critical Assessment of Detecting Asphalt Pavement Cracks under Different Lighting and Low Intensity Contrast Conditions Using Emerging 3D Laser Technology
Publication: Journal of Transportation Engineering
Volume 138, Issue 5
Abstract
After decades of research and development, a fully automated system for pavement crack detection with an intensity-based two-dimensional (2D) imaging data acquisition system under different lighting and low intensity contrast conditions still remains a challenge. With the advances of sensor technology, a three-dimensional (3D) laser technology that can collect high-resolution 3D continuous transverse pavement profiles for detecting cracks on the basis of their 3D elevation rather than 2D intensity has become available. This study, sponsored by the U.S. Department of Transportation (US DOT) Research Innovative Technology Administration (RITA) program, evaluates the feasibility of using emerging 3D laser technology to detect cracks under different lighting and poor intensity contrast conditions. For this purpose, 3D surface data from laboratory tests on cracks ranging from 1 to 5mm wide and tests on the actual pavement cracks of different widths and depths and under different lighting conditions were performed. The dynamic-optimization-based crack segmentation method was employed to detect cracks. A linear-buffered Hausdorff scoring method was used to quantitatively evaluate the crack segmentation performance by comparing the detected cracks with the manually established ground truth. The preliminary test results show that: (1) the 3D laser system can effectively detect cracks equal to and greater than 2 mm wide under controlled laboratory environment, (2) it can achieve consistent results when detecting cracks under different lighting conditions (i.e., nighttime, daytime with shadow, and daytime no shadow), and (3) it can detect cracks with low intensity contrast. Future research is recommended.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
The authors would like to thank the support provided the US DOT RITA program. This paper was sponsored by US DOT RITA program (DTOS59-10-H-0003). The writers also would like to thank Chengbo Ai and Ying Xu for their help in setting up and performing the tests. The authors would also like to give special thanks to Dr. Alekseychuk for allowing them to use the algorithm he developed. The views, opinions, findings and conclusions reflected in this presentation are the responsibility of the authors only and do not represent the official policy or position of the US DOT, RITA, or any state or other entity. In addition, the authors also would like to thank the support provided by the Program for Changjiang Scholars and Innovative Research Team in University (NO.1050) to exchange current Chinese pavement management practices.
References
Ahmed, M. F. M., and Haas, C.T. (2010). “The potential of low cost close range photogrammetry towards unified automatic pavement distress surveying.” Transportation Research Board Annual Meeting 2010 (CD-ROM).
Alekseychuk, O. (2006). “Detection of crack-like indications in digital radiography by global optimisation of a probabilistic estimation function.” Ph.D. thesis, BAM-Dissertationsreihe, Band 18, Dresden Univ. of Technology, Dresden, Germany.
EI-Korchi, T., Gennert, M. A., Ward, M. O., and Wittels, N. (1991). “Lighting design for automated pavement surface distress evaluation.” Transp. Res. Rec.TRREDM, 1311(1), 144–148.
Hou, Z., Wang, K. C. P., and Gong, W. (2007). “Experimentation of 3D pavement imaging through stereovision.” Proc. Int. Conf. on Transportation Engineering, ASCE, Reston, VA, 376–381.
Kaul, V., Tsai, Y., and Mersereau, R. M. (2010). “A quantitative performance evaluation of pavement distress segmentation algorithms.” Transp. Res. RecTRREDM, 2153(1), 106–113.
Laurent, J., Lefebvre, D., and Samson, E. (2008). “Development of a new 3d transverse laser profiling system for the automatic measurement of road cracks.” 6th Symposium on Pavement Surface Characteristics, SURF 2008, World Road Association, France.
Lee, H., and Kim, J. (2006). “Analysis of errors in ground truth indicators for evaluating the accuracy of automated pavement surface image collection and analysis system for asset management.” J. ASTM Int., 3(5), 13093.JAIOAD
Li, Q., Yao, M., Yao, X., and Xu, B. (2010). “A real-time 3d scanning system for pavement distortion inspection.” Meas. Sci. Technol., 21(1), 015702.MSTCEP
McGhee, K. H. (2004). “Automated pavement distress collection techniques: A synthesis of highway practice.” National Cooperative Highway Research Program (NCHRP) Synthesis 334, Washington, DC.
Mraz, A., Gunaratne, M., Nazef, A., and Choubane, B. (2006). “Experimental evaluation of a pavement imaging system: Florida Department of Transportation’s multipurpose survey vehicle.” Transp. Res. Rec.TRREDM, 1974(1), 97–106.
Raman, M., Hossain, M., Miller, R., Cumberledge, G., Lee, H., and Kang, K., (2004). “Assessment of image-based data collection and the AASHTO provisional standard for cracking on asphalt-surfaced pavements.” Transp. Res. Rec.TRREDM, 1889(1), 116–125.
Tsai, Y., Kaul, V., and Mersereau, R. M. (2010). “A critical assessment of pavement distress segmentation methods performance evaluation of pavement distress segmentation methods.” J. Transp. Eng., 136 (1), 11–19.JTPEDI
Wang, K. C. P. (2000). “Designs and implementations of automated systems for pavement surface distress survey.” J. Infrastruct. Syst., 6(1), 24–32.JITSE4
Wang, K. C. P., and Gong, W. (2002). “Real-time automated survey of pavement surface distress.” Proc. Int. Conf. Applications of Advanced Technologies in Transportation Engineering, ASCE, Reston, VA, 465–472.
Wang, K. C. P., and Tee, W. (2002). “Understanding of pavement profiling and validation of an implementation.” Proc. Int. Conf. Traffic and Transportation Studies, ASCE, Reston, VA, 817–824.
Wang, K. C. P. (2004). “Challenges and feasibility for comprehensive automated survey of pavement conditions.” Proc. Int. Conf. Applications of Advanced Technologies in Transportation Engineering, ASCE, Reston, VA, 531–536.
Wang, K. C. P., and Gong, W. (2005). “Real-time automated survey system of pavement cracking in parallel environment.” J. Infrastruct. Syst., 11(3), 154–164.JITSE4
Wang, K. C. P., Gong, W., and Hou, Z. (2008). “Automated cracking survey”. Proc. RILEM Int Conf. Cracking in Pavements, RILEM, Bagneux, France, 881–889.
Xu, B. (2005). “Artificial lighting for the automated pavement distress rating system.” Rep. FHWA/TX-06/0-4958-1, Center for Transportation Research, Univ. of Texas at Austin, Austin, TX.
Xu, B. (2007). “Summary of implementation of an artificial lighting system for automated visual distress rating system.” Rep. FHWA/TX-08/5-4958-01-1, Center for Transportation Research, Univ. of Texas at Austin, Austin, TX.
Information & Authors
Information
Published In
Copyright
© 2012. American Society of Civil Engineers.
History
Received: Mar 30, 2011
Accepted: Sep 12, 2011
Published online: Apr 16, 2012
Published in print: May 1, 2012
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.