Comparative Study on Temperature Stresses in Asphalt Material Using Nonlinear Viscoelastic Approach
Publication: Journal of Transportation Engineering
Volume 137, Issue 10
Abstract
An accurate estimate of temperature stress in asphalt pavements is an important consideration for colder regions. In asphalt, a viscoelastic material, the developed stress depends on the trend of temperature variation and the relaxation modulus of the asphalt mix. This paper presents a comparative study of the temperature stresses by considering different temperature profiles for the same temperature differential and different relaxation models for the same asphalt mix. A nonlinear viscoelastic approach was used for the stress calculation. From this study, it was concluded that both the temperature profile and the relaxation model significantly affect the stress profile. Also, for cases in which the rate of change of the temperature was nonlinear, the computed maximum stress value for a given temperature profile seemed to be different within few cycle periods.
Get full access to this article
View all available purchase options and get full access to this article.
References
Anderson, D. A., Lapalu, L., Marasteanu, M. O., Le Hir, Y. M., Planche, J. P., and Martin, D. (2001). “Low-temperature thermal cracking of asphalt binders as ranked by strength and fracture properties.” Transportation Research Record 1766, Transportation Research Board, Washington, DC, 1–6.
Barber, E. S. (1957). “Calculation of maximum pavement temperatures from weather reports.” Highway Research Board Bulletin 168, National Research Council, Washington, DC, 1–8.
Celauro, C. (2004). “Influence of the hourly variation of temperature on the estimation of fatigue damage and rutting in flexible pavement design.” Int. J. Pavement Eng., 5(4), 221–231.
Epps, A. (1998). “A comparison of measured and predicted low-temperature cracking conditions.” J. Assoc. Asphalt Paving Technol., 67, 277–310.
European Cooperation in the Field of Scientific and Technical Research. (1999). “Development of a new bituminous pavement design method.” Final Rep. of Action, COST 333, European Commission Directorate-General for Transport, Luxembourg.
Fabb, T. R. J. (1974). “The influence of mix composition, binder properties and cooling rate on asphalt cracking at low-temperature.” Proc. - Assoc. Asphalt Paving Technol., Tech. Sess., 43, 285–331.
Hills, J. F., and Brien, D. (1966). “The fracture of bitumens and asphalt mixes by temperature induced stresses.” Proc. - Assoc. Asphalt Paving Technol., Tech. Sess., 35, 292–309.
Hiltunen, D. R., and Roque, R. (1994). “A mechanistic-based prediction model for thermal cracking of asphalt concrete pavements.” J. Assoc. Asphalt Paving Technol., 63, 81–108.
Ho, S., Zanzotto, L., and MacLeod, D. (2002). “Impact of different types of modification on low-temperature tensile strength and of asphalt binders.” Transportation Research Record 1810, Transportation Research Board, Wasington, DC, 1–8.
Huang, Y. H. (2004). Pavement analysis and design, Person Prentice Hall, Upper Saddle River, NJ.
Hulsey, J. L., and Powell, D. (1993). “Rational weather model for highway structures.” Transportation Research Record 1393, Transportation Research Board, Wasington, DC, 54–64.
Jones, G. M., Darter, M. I., and Littlefield, G. (1968). “Thermal expansion-contraction of asphaltic concrete.” J. Assoc. Asphalt Paving Technol., 37, 56–97.
Jung, D. H., and Vinson, T. S. (1994). “Low-temperature cracking: Test selection.” SHRP-A-400, Strategic Highway Research Program, National Research Council, Washington, DC.
Kanerva, H. K., Vinson, T. S., and Zeng, H. (1994). “Low-temperature cracking: Field validation of the thermal stress restrained specimen test.” SHRP-A-401, Strategic Highway Research Program, Dept. of Civil Engineering, Oregon State Univ., Portland, OR.
Li, X., Zofka, A., Li, X., Marasteanu, M. O., and Clyne, T. R. (2006). “Investigation of the low-temperature fracture properties of three MnROAD asphalt mixtures.” Rep. No. MN/RC-2006-15, Dept. of Civil Engineering, Univ. of Minnesota, Minneapolis.
Marasteanu, M., et al. (2007). “Investigation of low temperature cracking in asphalt pavements.” National Pooled Fund Study 776, Rep. No. MN/RC 2007-43, Dept. of Civil Engineering, Univ. of Minnesota, Minneapolis.
National Cooperative Highway Research Program (NCHRP). (2004). “Mechanistic-empirical design of new and rehabilitated pavement structures.” NCHRP Design Guide, Project 1-37A, Transportation Research Board, Washington, DC, 〈http://www.trb.org/mepdg/guide.htm〉 (Dec. 2008).
Rajbongshi, P. (2008). “A comprehensive design approach for asphalt pavements using mechanistic-empirical framework.” Ph.D. thesis, Indian Institute of Technology, Kanpur, India.
Rajbongshi, P., and Das, A. (2009). “Estimation of temperature stress and low-temperature crack spacing in asphalt pavements.” J. Transp. Eng., 135(10), 745–752.
Robert, L. (2002). “Rheological and fatigue characterisation of asphalt concrete mixtures using uniaxial testing.” Research Rep. TRITA-VT FR 02:02, Licentiate thesis, Kungl Tekniska, Högskolan, Sweden.
Stoffels, S., and Kwanda, F. D. (1996). “Determination of the coefficient of thermal contraction of asphalt concrete using the resistant strain gage technique.” Proc. - Assoc. Asphalt Paving Technol., Tech. Sess., 65, 73–90.
Sugawara, T., and Moriyoshi, A. (1984). “Thermal fracture of bituminous mixtures.” Proc., Workshop in Paving in Cold Areas, Transportation Development Centre, Montréal, 291–320.
Williams, M. L., Landel, R. F., and Ferry, J. D. (1955). “The temperature dependence of relaxation mechanisms in amorphous polymers and other glass-forming liquids.” J. Am. Chem. Soc., 77(14), 3701–3707.
Zhai, H., and Salomon, D. (2005). “Evaluation of low-temperature properties and the fragility of asphalt binders with non-Arrhenius viscosity-temperature dependence.” Transportation Research Record 1901, Transportation Research Board, Washington, DC, 44–51.
Information & Authors
Information
Published In
Copyright
© 2011 American Society of Civil Engineers.
History
Received: Dec 24, 2009
Accepted: Dec 28, 2010
Published online: Dec 30, 2010
Published in print: Oct 1, 2011
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.