Evaluation and Enhancement of Robustness for Reinforced Concrete Buildings
Publication: Journal of Structural Engineering
Volume 148, Issue 1
Abstract
Since the events of September 11, 2001, the engineering community has devoted increased attention to evaluating the vulnerability of multistory buildings to disproportionate collapse, including substantial research and standards development. This paper reviews recent research conducted by the NIST on the robustness of RC buildings, including experimental validation of both high-fidelity and reduced-order modeling approaches using measurements from subsystems and an entire building tested under column removal scenarios. A robustness index was developed using pushdown analysis of a structure with initial damage to allow an evaluation and comparison of the disproportionate collapse potential of various structural systems using the validated modeling approaches. It is shown that the robustness index is sensitive to differences in the strength and detailing of the structural system, providing higher values for buildings with more stringent design requirements. Further, the paper presents a novel approach for enhancing the robustness of RC beams through local debonding of tensile reinforcing bars at the joints, where significant cracking occurs after a column loss. Experimental and computational studies were conducted to demonstrate the efficacy of this approach. It is shown that debonding of the bottom bars for a length of two beam depths on each side of a central column results in an improvement of more than 30% in the peak vertical load-carrying capacity under a column removal scenario.
Get full access to this article
View all available purchase options and get full access to this article.
Data Availability Statement
Some or all data, models, or code that support the findings of this study are available from the corresponding author upon reasonable request.
Acknowledgments
Disclaimer
Certain commercial entities, equipment, software, or materials may be identified in this document in order to describe an experimental procedure or concept adequately. Such identification is not intended to imply recommendation or endorsement by the National Institute of Standards and Technology, nor is it intended to imply that the entities, materials, or equipment are necessarily the best available for the purpose.
References
ACI (American Concrete Institute). 2008. Building code requirements for structural concrete and commentary. ACI 318-08. Farmington Hills, MI: ACI.
ASCE. 2002. Minimum design loads for buildings and other structures. ASCE/SEI 7-02. Reston, VA: ASCE.
Bao, Y., H. S. Lew, and S. K. Kunnath. 2014. “Modeling of reinforced concrete assemblies under column removal scenario.” J. Struct. Eng. 140 (1): 04013026. https://doi.org/10.1061/(ASCE)ST.1943-541X.0000773.
Bao, Y., H. S. Lew, F. Sadek, and J. A. Main. 2016. “A simple method of enhancing the robustness of R/C frame structures.” ACI Spec. Publ. 309 (1): 1–16.
Bao, Y., J. A. Main, and S. Noh. 2017. “Evaluation of structural robustness against column loss: Methodology and application to RC frame buildings.” J. Struct. Eng. 143 (8): 04017066. https://doi.org/10.1061/(ASCE)ST.1943-541X.0001795.
Dat, P. X., and K. H. Tan. 2013. “Membrane actions of RC slabs in mitigating progressive collapse of building structures.” Eng. Struct. 55 (Oct): 107–115. https://doi.org/10.1016/j.engstruct.2011.08.039.
de Witte, F. C. 2005. User’s manual: Release 9. Delft, Netherlands: TNO DIANA BV.
El-Tawil, S., H. Li, and S. Kunnath. 2014. “Computational simulation of gravity-induced progressive collapse of steel-frame buildings: Current trends and future research needs.” J. Struct. Eng. 140 (8): A2513001. https://doi.org/10.1061/(ASCE)ST.1943-541X.0000897.
Fascetti, A., S. K. Kunnath, and N. Nistico. 2015. “Robustness evaluation of RC frame buildings to progressive collapse.” Eng. Struct. 86 (Mar): 242–249. https://doi.org/10.1016/j.engstruct.2015.01.008.
Hallquist, J. 2007. LS-DYNA keyword user’s manual. Livermore, CA: Livermore Software Technology Corporation.
Izzuddin, B. A., A. G. Vlassis, A. Y. Elghazouli, and D. A. Nethercot. 2008. “Progressive collapse of multistory buildings due to sudden column loss: Part I: Simplified assessment framework.” Eng. Struct. 30 (5): 1308–1318. https://doi.org/10.1016/j.engstruct.2007.07.011.
Khandelwal, K., and S. El-Tawil. 2011. “Pushdown resistance as a measure of robustness in progressive collapse analysis.” Eng. Struct. 33 (9): 2653–2661. https://doi.org/10.1016/j.engstruct.2011.05.013.
Kwasniewski, L. 2010. “Nonlinear dynamic simulations of progressive collapse for a multistory building.” Eng. Struct. 32 (5): 1223–1235.
Lew, H. S., Y. Bao, S. Pujol, and M. A. Sozen. 2014. “Experimental study of reinforced concrete assemblies under column removal scenario.” ACI Struct. J. 111 (4): 881–892. https://doi.org/10.14359/51686739.
Lowes, L. N., N. Mitra, and A. Altoontash. 2004. A beam-column joint model for simulating the earthquake response of reinforced concrete frames. Berkeley, CA: Pacific Earthquake Engineering Research Center.
Main, J. A. 2014. “Composite floor systems under column loss: Collapse resistance and tie force requirements.” J. Struct. Eng. 140 (8): A4014003. https://doi.org/10.1061/(ASCE)ST.1943-541X.0000952.
Murray, Y. D., A. Abu-Odeh, and R. Bligh. 2007. Evaluation of LS-DYNA concrete material model 159. Mclean, VA: Federal Highway Administration.
Petrone, F., L. Shan, and S. K. Kunnath. 2016. “Modeling of RC frame buildings for progressive collapse analysis.” Int. J. Concr. Struct. Mater. 10 (1): 1–13. https://doi.org/10.1007/s40069-016-0126-y.
Powell, G. 2003. “Collapse analysis made easy (more or less).” In Proc. Annual Meeting of the Los Angeles Tall Buildings Structural Design Council, Progressive Collapse and Blast Resistant Design of Buildings. Los Angeles: Los Angeles Tall Buildings Structural Design Council.
Scott, B. D., R. Park, and M. J. N. Priestley. 1982. “Stress-strain behavior of concrete confined by overlapping hoops at low and high strain rates.” ACI J. Proc. 79 (1): 13–27.
Shen, Q., and S. K. Ghosh. 2006. Assessing ability of seismic structural systems to withstand progressive collapse: Design of reinforced concrete frame buildings. Gaithersburg, MD: Building and Fire Research Laboratory, National Institute of Standards and Technology.
Xiao, Y., S. K. Kunnath, F. W. Li, Y. B. Zhao, H. S. Lew, and Y. Bao. 2015. “Collapse test of three-story half-scale reinforced concrete frame building.” ACI Struct. J. 112 (4): 427–438.
Yu, J., and K. H. Tan. 2013. “Experimental and numerical investigation on progressive collapse resistance of reinforced concrete beam column sub-assemblies.” Eng. Struct. 55 (Oct): 90–106. https://doi.org/10.1016/j.engstruct.2011.08.040.
Zong, Z., S. K. Kunnath, and G. Monti. 2014. “Material model incorporating buckling of reinforcing bars in RC columns.” J. Struct. Eng. 140 (1): 04013032. https://doi.org/10.1061/(ASCE)ST.1943-541X.0000808.
Information & Authors
Information
Published In
Copyright
© 2021 American Society of Civil Engineers.
History
Received: Apr 5, 2021
Accepted: Aug 27, 2021
Published online: Oct 29, 2021
Published in print: Jan 1, 2022
Discussion open until: Mar 29, 2022
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.
Cited by
- Cosimo Pellecchia, Alessandro Cardoni, Gian Paolo Cimellaro, Marco Domaneschi, Farhad Ansari, Ahmed Amir Khalil, Progressive Collapse Analysis of the Champlain Towers South in Surfside, Florida, Journal of Structural Engineering, 10.1061/JSENDH.STENG-12485, 150, 1, (2024).
- Simos Gerasimidis, Bruce Ellingwood, Twenty Years of Advances in Disproportionate Collapse Research and Best Practices since 9/11/2001, Journal of Structural Engineering, 10.1061/JSENDH.STENG-12056, 149, 2, (2023).
- Aydın DEMİR, Türkiye Bina Deprem Yönetmeliğine Göre Tasarlanan Betonarme Binaların İlerlemeli Çökme Davranışları, Bitlis Eren Üniversitesi Fen Bilimleri Dergisi, 10.17798/bitlisfen.1094003, (2022).
- Junjie Wang, Ke Ke, Wei Wang, Structural robustness evaluation of steel frame buildings with different composite slabs using reduced-order modeling strategies, Journal of Constructional Steel Research, 10.1016/j.jcsr.2022.107371, 196, (107371), (2022).
- Foad Kiakojouri, Valerio De Biagi, Bernardino Chiaia, Mohammad Reza Sheidaii, Strengthening and retrofitting techniques to mitigate progressive collapse: A critical review and future research agenda, Engineering Structures, 10.1016/j.engstruct.2022.114274, 262, (114274), (2022).