Component and Cladding Wind Loads for Low-Slope Roofs on Low-Rise Buildings
Publication: Journal of Structural Engineering
Volume 144, Issue 4
Abstract
The component and cladding wind load provisions for low-sloped roofs on low-rise buildings in ASCE 7-10 were examined using measured pressure data from an aerodynamic database. It was found that both the design pressure coefficients and size of the roof zones in ASCE 7-10 are much smaller in magnitude than indicated by the data. The data indicate that building height is the most significant parameter affecting the size of the roof zones, while plan dimensions have a limited impact on this class of buildings. Recommendations for revised roof zones are developed, which include a modification to the shape of the corner zone, the addition of a new interior zone far from the roof edges, and a zone size definition that depends only on building height. However, even with increased roof zone sizes, the measured data indicate that the design pressure coefficients must also be increased in the corners and edges.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
The authors are grateful to the many colleagues on the ASCE 7-16 Wind Loads Subcommittee (WLSC) who provided feedback, comments, and support for this work, particularly, Drs. Tim Reinhold and Peter Vickery who helped with the ballot item on the WLSC, along with Dr. Jon Peterka who provided a detailed, independent review.
References
Akon, F. A., and Kopp, G. A. (2016). “Mean pressure distributions and reattachment lengths for roof-separation bubbles on low-rise buildings.” J. Wind Eng. Ind. Aerodyn., 155, 115–125.
ANSI (American National Standards Institute). (1994). “Minimum design loads for buildings and other structures.” ANSI A58.1-1982, New York.
ASCE. (1990). “Minimum design loads for buildings and other structures.” ASCE 7-88, Reston, VA.
ASCE. (2010). “Minimum design loads for buildings and other structures.” ASCE 7-10, Reston, VA.
Banks, D., and Meroney, R. N. (2001). “A model of roof-top surface pressures produced by conical vortices: Model development.” Wind Struct., 4(3), 227–246.
Cook, N. J., and Mayne, J. R. (1979). “A novel working approach to the assessment of wind loads for equivalent static design.” J. Wind Eng. Ind. Aerodyn., 4(2), 149–164.
Elsharawy, K., Galal, K., and Stathopoulos, T. (2014). “Comparison of wind tunnel measurements with NBCC 2010 wind-induced torsion provisions for low- and medium-rise buildings.” Can. J. Civ. Eng., 41(5), 409–420.
Ho, T. C. E., Surry, D., Morrish, D., and Kopp, G. A. (2005). “The UWO contribution to the NIST aerodynamic database for wind loads on low buildings. 1: Basic aerodynamic data and archiving.” J. Wind Eng. Ind. Aerodyn., 93(1), 1–30.
Kopp, G. A. (2014). “Wind loads on low-profile, tilted, solar arrays placed on large, flat, low-rise building roofs.” J. Struct. Eng., 04013057.
Lawson, T. V. (1976). “The design of cladding.” Build. Environ., 11(1), 37–38.
Lieblein, J. (1974). “Efficient methods of extreme-value methodology.” NBSIR 74-602, National Bureau of Standards, Washington, DC.
Lin, J. X., Surry, D., and Tieleman, H. W. (1995). “The distribution of pressure near roof corners of flat roof low buildings.” J. Wind Eng. Ind. Aerodyn., 56(2–3), 235–265.
NIST. (2008). “NIST aerodynamic database.” ⟨http://fris2.nist.gov/winddata/⟩ (Oct. 07, 2016).
SEAOC (Structural Engineers Association of California). (2012). “Wind design for low-profile solar photovoltaic arrays on flat roofs.” SEAOC-PV2, Sacramento, CA.
Stathopoulos, T. (1979). “Turbulent wind action on low-rise buildings.” Ph.D. thesis, Univ. of Western Ontario, London, ON, Canada.
St. Pierre, L. S., Kopp, G. A., Surry, D., and Ho, T. C. E. (2005). “The UWO contribution to the NIST aerodynamic database for wind loads on low buildings. 2: Comparison of data with wind load provisions.” J. Wind Eng. Ind. Aerodyn., 93(1), 31–59.
Surry, D. (1999). “Wind loads on low-rise buildings: Past, present and future.” Proc., 10th Int. Conf. Wind Engineering, International Association for Wind Engineering, Copenhagen, Denmark, 105–114.
Surry, D., Sinno, R. R., Nail, B., Ho, T. C. E., Farquhar, S., and Kopp, G. A. (2007). “Structurally effective static wind loads for roof panels.” J. Struct. Eng., 871–885.
Information & Authors
Information
Published In
Copyright
©2018 American Society of Civil Engineers.
History
Received: Nov 28, 2016
Accepted: Sep 18, 2017
Published online: Jan 31, 2018
Published in print: Apr 1, 2018
Discussion open until: Jun 30, 2018
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.