Seismic Performance Assessment of Corroded Reinforced Concrete Short Columns
Publication: Journal of Structural Engineering
Volume 144, Issue 4
Abstract
This paper presents an experimental study carried out on eight full-scale uncorroded and corroded reinforced concrete short columns subjected to the simulated seismic loading to investigate effects of corrosion on the seismic performance of short columns that failed in shear. The key variables are the corrosion level of reinforcement and the applied axial force ratio. The seismic behavior of test specimens was evaluated in terms of crack pattern, hysteretic response, shear strength, displacement ductility, drift capacity, and energy dissipation capacity. The experimental results highlighted that the corroded columns suffered a significant degradation of shear strength and deformation capacity as compared with uncorroded columns, especially when they are highly corroded and under high axial load ratio. Methods were proposed to estimate the shear strength of corroded short columns that failed in shear that consider the contribution reductions to the shear strength of transverse reinforcement and concrete due to corrosion. Among these methods, the shear strength of corroded RC short columns estimated based on both the average corrosion mass loss and average residual cross-sectional area was not conservative as compared with the test results. The shear strength of corroded short columns estimated using the minimum residual cross-sectional area of transverse reinforcement, however, showed good and reliable agreement with the test results in this study.
Get full access to this article
View all available purchase options and get full access to this article.
References
ACI (American Concrete Institute). (2014). “Building code requirements for structural concrete and commentary.” ACI 318-14, Farmington Hills, MI.
Andrade, C., et al. (2004). “Test methods for on-site corrosion rate measurement of steel reinforcement in concrete by means of the polarization resistance method.” Mater. Struct., 37(9), 623–643.
ASCE. (2014). “Seismic evaluation and retrofit of existing buildings.” ASCE/SEI 41-13, Reston, VA.
ASTM. (2003). “Standard practice for preparing, cleaning, and evaluating corrosion test specimens.” ASTM G1-03, West Conshohocken, PA.
Bousias, S. N., Triantafillou, T. C., Fardis, M. N., Spathis, L., and O’Regan, B. A. (2004). “Fiber-reinforced polymer retrofitting of rectangular reinforced concrete columns with or without corrosion.” ACI Struct. J., 101(4), 512–520.
Cairns, J., Plizzari, G. A., Du, Y., Law, D. W., and Franzoni, C. (2005). “Mechanical properties of corrosion-damaged reinforcement.” ACI Mater. J., 102(4), 256–264.
Du, Y. G., Clark, L. A., and Chan, A. H. C. (2005). “Residual capacity of corroded reinforcing bars.” Mag. Concr. Res., 57(3), 135–147.
El-Sayed, A. K., Hussain, R. R., and Shuraim, A. B. (2016). “Influence of stirrup corrosion on shear strength of reinforced concrete slender beams.” ACI Struct. J., 113(06), 1223.
Goksu, C., and Ilki, A. (2016). “Seismic behavior of reinforced concrete columns with corroded deformed reinforcing bars.” ACI Struct. J., 113(05), 1053.
Hong, Z., Leng, L., Ruiqiang, Z., Jianting, Z., Mao, Y., and Runchuan, X. (2016). “The non-destructive test of steel corrosion in reinforced concrete bridges using a micro-magnetic sensor.” Sensors, 16(9), 1–9.
Hsu, T. T. C., and Mo, Y. L. (2010). Unified theory of concrete structures, Wiley, Chichester, U.K.
Kobayashi, K., and Banthia, N. (2011). “Corrosion detection in reinforced concrete using induction heating and infrared thermography.” J. Civ. Struct. Health Monit., 1(1–2), 25–35.
Li, J., Gong, J., and Wang, L. (2009). “Seismic behavior of corrosion-damaged reinforced concrete columns strengthened using combined carbon fiber-reinforced polymer and steel jacket.” Constr. Build. Mater., 23(7), 2653–2663.
Mangat, P. S., and Elgarf, M. S. (1999). “Flexural strength of concrete beams with corroding reinforcement.” ACI Struct. J., 96(1), 149–158.
Meda, A., Mostosi, S., Rinaldi, Z., and Riva, P. (2014). “Experimental evaluation of the corrosion influence on the cyclic behaviour of RC columns.” Eng. Struct., 76, 112–123.
Meda, A., Mostosi, S., Rinaldi, Z., and Riva, P. (2016). “Corroded RC columns repair and strengthening with high performance fiber reinforced concrete jacket.” Mater. Struct., 49(5), 1967–1978.
Ou, Y.-C., and Chen, H.-H. (2014). “Cyclic behavior of reinforced concrete beams with corroded transverse steel reinforcement.” J. Struct. Eng., 04014050.
Ou, Y.-C., Susanto, Y. T. T., and Hwasung, R. (2016). “Tensile behavior of naturally and artificially corroded steel bars.” Constr. Build. Mater., 103, 93–104.
Pan, Z., and Li, B. (2013). “Truss-arch model for shear strength of shear-critical reinforced concrete columns.” J. Struct. Eng., 548–560.
Pham, T. P., and Li, B. (2013). “Seismic behaviour of RC columns with light transverse reinforcement under different loading directions.” ACI Struct. J., 110(5), 833–844.
Sezen, H., and Moehle, J. P. (2004). “Shear strength model for lightly reinforced concrete columns.” J. Struct. Eng., 1692–1703.
Stewart, M. G. (2009). “Mechanical behaviour of pitting corrosion of flexural and shear reinforcement and its effect on structural reliability of corroding RC beams.” Struct. Saf., 31(1), 19–30.
Torres-Acosta, A. A., Navarro-Gutierrez, S., and Teran-Guillen, J. (2007). “Residual flexure capacity of corroded reinforced concrete beams.” Eng. Struct., 29(6), 1145–1152.
Tran, C. T. N., and Li, B. (2015). “Experimental studies on the backbone curves of reinforced concrete columns with light transverse reinforcement.” J. Perform. Constr. Facil., 04014126.
Vu, N. S., Yu, B., and Li, B. (2016). “Predicting strength and drift capacities in corroded reinforced concrete columns.” J. Constr. Build. Mater., 115, 304–318.
Yang, S. Y., Song, X. B., Jia, H. X., Chen, X., and Liu, X. L. (2016). “Experimental research on hysteretic behaviors of corroded reinforced concrete columns with different maximum amounts of corrosion of rebar.” Constr. Build. Mater., 121, 319–327.
Yeih, W., and Huang, R. (1998). “Detection of the corrosion damage in reinforced concrete members by ultrasonic testing.” Cem. Concr. Res., 28(7), 1071–1083.
Yu, B., Yang, L., and Li, B. (2014). “Practical model for predicting corrosion rate of steel reinforcement in concrete structures.” J. Constr. Build. Mater., 54, 385–401.
Information & Authors
Information
Published In
Copyright
©2018 American Society of Civil Engineers.
History
Received: Mar 30, 2017
Accepted: Sep 25, 2017
Published online: Jan 30, 2018
Published in print: Apr 1, 2018
Discussion open until: Jun 30, 2018
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.