Effect of Sustained Load on Ultimate Strength of High-Strength Composite Columns Using 800-MPa Steel and 100-MPa Concrete
Publication: Journal of Structural Engineering
Volume 143, Issue 3
Abstract
To investigate the effect of sustained loads on the ultimate strength of high-strength composite columns using grade 800-MPa steel and 100-MPa concrete, ultimate load tests were performed after long-term loading. Two concrete-encased steel (CES) columns were tested under concentric loading, and a CES column and a concrete-filled steel tube (CFT) column were tested under eccentric loading. The test results showed that stress-relaxation in the concrete and gradual stress-transfer to the steel and longitudinal bars occurred, and the ultimate shrinkage strain and ultimate creep coefficient of the high-strength concrete were estimated as 553 μϵ and 1.44, which are lower than those of normal-strength concrete but belong to the ranges specified in concrete standards. To confirm the tests, a numerical parametric study was performed, considering the age-adjusted effective modulus and relaxation. The results of the experimental and numerical studies showed that, in the case of the high-strength composite columns, the sustained load increased deformation (axial strain and curvature) at service load conditions, but the detrimental effect on the ultimate strength was not significant. The factors for the long-term effect specified in current design codes gave good predictions for the long-term effective flexural stiffness.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
This research was supported by grants from the High-Tech Urban Development Program funded by the Ministry of Land, Transportation and Maritime Affairs of Korea (09 R&D A01), and the authors are grateful to the authority for the support.
References
ACI (American Concrete Institute). (1997). “Prediction of creep, shrinkage, and temperature effects in concrete structures.” ACI 209R-92, Farmington Hills, MI.
ACI (American Concrete Institute). (2010). “Report on high-strength concrete.” ACI 363R, Farmington Hills, MI.
ACI (American Concrete Institute). (2014). “Building code requirements for structural concrete and commentary.” ACI 318-14, Farmington Hills, MI.
Adrian, C. A., and Triantafillou, T. C. (1992). “Creep and shrinkage analysis of composite systems under axial load and biaxial bending.” Mater. Struct., 25(9), 543–551.
AISC. (2010). “Specification for structural steel buildings.” ANSI/AISC 360-10, Chicago.
ASTM. (2010). “Standard test method for creep of concrete in compression.” ASTM C512/C512M-10, West Conshohocken, PA.
ASTM. (2011). “Standard test method for compressive strength of cylindrical concrete specimens.” ASTM C39/C39M-11, West Conshohocken, PA.
ASTM. (2013). “Standard test methods for tension testing of metallic materials.” ASTM E8/E8M-13, West Conshohocken, PA.
Bazant, Z. P. (1972). “Prediction of concrete creep effects using age-adjusted effective modulus method.” ACI J., 69(4), 212–217.
Bradford, M. A., and Gilbert, R. I. (1990). “Time-dependent analysis and design of composite columns.” J. Struct. Eng., 3338–3357.
Bresler, B., and Selna, L. (1964). “Analysis of time-dependent behaviour of reinforced concrete structures.” ACI Spec. Publ., 9(5), 115–128.
Bridge, R. Q. (1979). “Composite columns under sustained load.” J. Struct. Div., 105(ST3), 563–576.
CEN (European Committee for Standardization). (2004). “Design of composite steel and concrete structures—Part 1-1: General rules and rules for buildings.” Eurocode 4, Brussels, Belgium.
CEN (European Committee for Standardization). (2008). “Design of concrete structures—Part 1-1: General rules and rules for buildings.” Eurocode 2, Brussels, Belgium.
Chacón, R., Mirambell, E., and Marí, A. (2007). “Long-term response of concrete-encased composite columns.” Struct. Build., 160(SB5), 273–285.
Chen, Z., and Dai, T. (2015). “Effects of sustained axial loads on steel-reinforced concrete columns.” HKIE Trans., 22(1), 16–22.
Chicoine, T., Massicotte, B., and Tremblay, R. (2003). “Long-term behavior and strength of partially encased composite columns made with built-up steel shapes.” J. Struct. Eng., 141–150.
fib (International Federation for Structural Concrete). (2013). “fib model code for concrete structures 2010.”, Ernst & Sohn, Lausanne, Switzerland.
Fintel, M., Ghosh, S. K., and Iyengar, H. (1987). Column shortening in tall structures—Prediction and compensation, Portland Cement Association, Skokie, IL.
Gilbert, R. I. (1988). Time effects in concrete structures, Elsevier, New York.
Han, L. H., Tao, Z., and Liu, W. (2004). “Effects of sustained load on concrete-filled hollow structural steel columns.” J. Struct. Eng., 1392–1404.
Huo, X. S., Al-Omaishi, N., and Tadros, M. K. (2001). “Creep, shrinkage, and modulus of elasticity of high-performance concrete.” ACI Mater. J., 98(6), 440–449.
Ichinose, L. H., Watanabe, E., and Nakai, H. (2001). “An experimental study on creep of concrete filled steel pipes.” J. Constr. Steel Res., 57(4), 453–466.
Kawano, A., Matsui, C., and Yukino, T. (1998). “Time-dependent effects on earthquake-resistant capacities of steel-concrete composite structures.” J. Struct. Constr. Eng., 508, 143–150 (in Japanese).
Kim, C. S., Park, H. G., Chung, K. S., and Choi, I. R. (2012). “Eccentric axial load testing for concrete-encased steel columns using 800-MPa steel and 100-MPa concrete.” J. Struct. Eng., 1019–1031.
Kim, C. S., Park, H. G., Chung, K. S., and Choi, I. R. (2014). “Eccentric axial load capacity of high-strength steel-concrete composite columns of various sectional shapes.” J. Struct. Eng., .
Kim, J. K. (2003). “Creep tests for CFT columns I—Study on long-term behavior of CFT columns with diaphragm.” Seminar on Construction Technology for CFT Structures, Architectural Institute of Korea, Seoul, 57–94 (in Korean).
Kwon, S. H., Kim, T. H., Kim, Y. Y., and Kim, J. K. (2007). “Long-term behavior of square concrete-filled steel tubular columns under axial service loads.” Mag. Concr. Res., 59(1), 53–68.
Liu, H., Wang, Y., He, M., Shi, Y., and Waisman, H. (2015). “Strength and ductility performance of concrete-filled steel tubular columns after long-term service loading.” Eng. Struct., 100, 308–325.
Löfgren, A. I., Kawano, A., and Warner, R. F. (1997). “Simplified design methods for slender composite columns under sustained and short term loads.” Concrete 97 Conf., Concrete Institute of Australia, North Sydney, 1–11.
Ma, Y., and Wang, Y. (2012). “Creep of high strength concrete filled steel tube columns.” Thin Walled Struct., 53, 91–98.
Mirza, S. A., and Tikka, T. K. (1999). “Flexural stiffness of composite columns subjected to major axis bending.” ACI Struct. J., 96(1), 19–28.
Morino, S., Kswanguchi, J., and Cao, Z. S. (1996). “Creep behavior of concrete-filled steel tubular members.” Proc., Engineering Foundation Conf. on Steel-Concrete Composite Structure, ASCE, Reston, VA, 514–525.
Naguib, W., and Mirmiran, A. (2003). “Creep modelling for concrete-filled steel tubes.” J. Constr. Steel Res., 59(11), 1327–1344.
Ranzi, G., Leoni, G., and Zandonini, R. (2013). “State of the art on the time-dependent behaviour of composite steel-concrete structures.” J. Constr. Steel Res., 80, 252–263.
Uy, B. (2001). “Static long-term effects in short concrete-filled steel box columns under sustained loading.” ACI Struct. J., 98(1), 96–104.
Uy, B., and Das, S. (1997). “Time effects in concrete-filled steel box columns in tall buildings.” Struct. Des. Tall Build., 6(1), 1–22.
Wang, Y., Geng, Y., Ranzi, G., and Zhang, S. (2001). “Time-dependent behaviour of expansive concrete-filled steel tubular columns.” J. Constr. Steel Res., 67(3), 471–483.
Zhang, D., Ma, Y., and Wang, Y. (2015). “Compressive behavior of concrete filled steel tubular columns subjected to long-term loading.” Thin Walled Struct., 89, 205–211.
Information & Authors
Information
Published In
Copyright
© 2016 American Society of Civil Engineers.
History
Received: Mar 21, 2016
Accepted: Aug 4, 2016
Published online: Sep 30, 2016
Discussion open until: Feb 28, 2017
Published in print: Mar 1, 2017
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.