Three-Degree-of-Freedom Coupled Numerical Technique for Extracting 18 Aerodynamic Derivatives of Bridge Decks
Publication: Journal of Structural Engineering
Volume 140, Issue 11
Abstract
A three-degrees of freedom (3-DOF) coupled numerical simulation technique for synchronously extracting 18 aerodynamic derivatives of bridge decks is proposed and evaluated in this study. Computations are performed with a finite volume unstructured computational flow dynamics (CFD) solver using two-dimensional (2D) hybrid meshes with fine near-wall resolution. The accuracy of the numerical model is verified by identifying the aerodynamic derivatives of one thin plate section with theoretical solutions. Further, for two typical deck sections (streamlined and bluff) of two long-span bridges, the extracted 18 aerodynamic derivatives from both coupled and uncoupled techniques are compared. The results showed good agreement with the experimental results. The proposed 3-DOF coupled method can provide almost the same level of accuracy as the 1-DOF method and saves about 67% of the computation time. The appropriateness of the linear superposition theorem for the aeroelastic forces generated by different motions (single and coupled mode) is examined, and found that there are significant differences in both aerostatic and aeroelastic forces. Various high-order aeroelastic force components are successfully captured by the newly presented coupled numerical simulation, and the aerodynamic derivatives are proved to be immune to the high-order components mathematically. This knowledge is essential for a thorough evaluation of aerodynamic derivatives identification accuracy. The proposed technique and the analytical viewpoints presented in this paper may serve as the building block for developing new numerical tools and analytical frameworks for rapid and accurate evaluation of aerodynamic derivatives, and the response of long-span flexible bridges to wind excitation.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
The research is jointly supported by the National Science Foundation of China (51178086) and a special major project of the Western Transportation Program of Ministry of Transport of China (2011318824140), which are gratefully acknowledged.
References
ANSYS FLUENT 6.3.26. [Computer software]. Canonsburg, PA, ANSYS, Inc.
Bartoli, G., Contri, S., Mannini, C., and Righi, M. (2009). “Toward an improvement in the identification of bridge deck flutter derivatives.” J. Eng. Mech., 771–785.
Batina, J. T. (1990). “Unsteady Euler airfoil solutions using unstructured dynamic meshes.” AIAA J., 28(8), 1381–1388.
Chen, X., and Kareem, A. (2002). “Advances in modeling of aerodynamic forces on bridge decks.” J. Eng. Mech., 1193–1205.
Chen, Z., Yu, X., Yang, G., and Spencer, B., Jr. (2005). “Wind-induced self-excited loads on bridges.” J. Struct. Eng., 1783–1793.
Diana, G., Resta, F., Zasso, A., Belloli, M., and Rocchi, D. (2004). “Forced motion and free motion aeroelastic tests on a new concept dynamometric section model of the Messina suspension bridge.” J. Wind Eng. Ind. Aerodyn., 92(6), 441–462.
Falco, M., Curami, A., and Zasso, A. (1992). “Nonlinear effects in sectional model aeroelastic parameters identification.” J. Wind Eng. Ind. Aerodyn., 42(1), 1321–1332.
Fransos, D., and Bruno, L. (2006). “Determination of the aeroelastic transfer functions for streamlined bodies by means of a Navier–Stokes solver.” Math. Comput. Model., 43(5), 506–529.
Guo, Z. (2006). “Three-degree-of-freedom forced vibration method for identification of aerodynamic derivatives of bridge decks.” Ph.D. thesis, Tongji Univ., Shanghai, China (in Chinese).
Hassan, M., Gerber, A., and Omar, H. (2010). “Numerical estimation of fluidelastic instability in tube arrays.” J. Pres. Vessel Technol., 132(4), 041307.
Larsen, A., and Walther, J. H. (1998). “Discrete vortex simulation of flow around five generic bridge deck sections.” J. Wind Eng. Ind. Aerodyn., 77–78, 591–602.
Li, Q. (1995). “Measuring flutter derivatives for bridge sectional models in water channel.” J. Eng. Mech., 90–101.
Mannini, C., and Bartoli, G. (2008). “Investigation on the dependence of bridge deck flutter derivatives on steady angle of attack.” Proc., BBAA VI Int. Colloquium on Bluff Bodies Aerodynamics and Applications, Milano, Italy.
Mannini, C., Šoda, A., Voß, R., and Schewe, G. (2010). “Unsteady RANS simulations of flow around a bridge section.” J. Wind Eng. Ind. Aerodyn., 98(12), 742–753.
Matsumoto, M., Shiraishi, N., Shirato, H., Shigetaka, K., and Niihara, Y. (1993). “Aerodynamic derivatives of coupled/hybrid flutter of fundamental structural sections.” J. Wind Eng. Ind. Aerodyn., 49(1), 575–584.
Menter, F. R. (1994). “Two-equation eddy-viscosity turbulence models for engineering applications.” AIAA J., 32(8), 1598–1605.
Mishra, S. S., Kumar, K., and Krishna, P. (2006). “Identification of 18 flutter derivatives by covariance driven stochastic subspace method.” Wind Struct., 9(2), 159–178.
Niu, H., Chen, Z., Liu, M., Han, Y., and Hua, X. (2007). “Development of the 3-DOF forced vibration device to measure the aerodynamic forces on section models.” Proc., 12th Int. Conf. on Wind Engineering, Cairns, Australia, 2247–2254.
Noda, M., Utsunomiya, H., Nagao, F., Kanda, M., and Shiraishi, N. (2003). “Effects of oscillation amplitude on aerodynamic derivatives.” J. Wind Eng. Ind. Aerodyn., 91(1), 101–111.
Sarkar, P. P., Caracoglia, L., Haan, F. L., Sato, H., and Murakoshi, J. (2009). “Comparative and sensitivity study of flutter derivatives of selected bridge deck sections, Part 1: Analysis of inter-laboratory experimental data.” Eng. Struct., 31(1), 158–169.
Šarkić, A., Fisch, R., Höffer, R., and Bletzinger, K. U. (2012). “Bridge flutter derivatives based on computed, validated pressure fields.” J. Wind Eng. Ind. Aerodyn., 104–106, 141–151.
Scanlan, R. H. (1997). “Amplitude and turbulence effects on bridge flutter derivatives.” J. Struct. Eng., 232–236.
Scanlan, R. H., and Tomko, J. (1971). “Air foil and bridge deck flutter derivatives.” J. Eng. Mech., 1717–1737.
Schneider, G., and Raw, M. (1987). “Control volume finite-element method for heat transfer and fluid flow using colocated variables—1. Computational procedure.” Numer. Heat Tran., 11(4), 363–390.
Shirai, S., and Ueda, T. (2003). “Aerodynamic simulation by CFD on flat box girder of super-long-span suspension bridge.” J. Wind Eng. Ind. Aerodyn., 91(1), 279–290.
Singh, L., Jones, N., Scanlan, R., and Lorendeaux, O. (1996). “Identification of lateral flutter derivatives of bridge decks.” J. Wind Eng. Ind. Aerodyn., 60, 81–89.
Ukeguchi, N., Sakata, H., and Nishitani, H. (1996). “An experimental investigation of the aeroelastic instability of the suspension bridges.” J. Japan Soc. Aeronaut. Eng., 14(146), 65–75.
Vairo, G. (2003). “A numerical model for wind loads simulation on long-span bridges.” Simulat. Model. Pract. Theor., 11(5–6), 315–351.
Walther, J. H., and Larsen, A. (1997). “Two dimensional discrete vortex method for application to bluff body aerodynamics.” J. Wind Eng. Ind. Aerodyn., 67, 183–193.
Zhou, Z., and Ma, R. (2010). “Numerical simulation study of the Reynolds number effect on two bridge decks based on the deterministic vortex method.” Wind Struct., 13(4), 347–362.
Zhu, Z., Gu, M., and Chen, Z. (2007). “Wind tunnel and CFD study on identification of flutter derivatives of a long-span self-anchored suspension bridge.” Comput. Aided Civ. Infrastruct. Eng., 22(8), 541–554.
Information & Authors
Information
Published In
Copyright
© 2014 American Society of Civil Engineers.
History
Received: Dec 28, 2012
Accepted: Nov 19, 2013
Published online: May 23, 2014
Discussion open until: Oct 23, 2014
Published in print: Nov 1, 2014
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.