Bond Behavior of Plain Round Bars Embedded in Concrete Subjected to Biaxial Lateral Tensile-Compressive Stresses
Publication: Journal of Structural Engineering
Volume 140, Issue 4
Abstract
Owing to its importance to the assessment and design of reinforced concrete structures, the bond behavior of steel bars in concrete has been extensively studied. This paper presents an experimental investigation into the bond behavior of plain round bars embedded in concrete subjected to biaxial orthogonal lateral tensile-compressive stresses. A total of 174 pull-out specimens with different strengths of concrete, bar diameters, and combinations of lateral stresses were tested. The experimental results showed that, for a given lateral compressive stress, the bond strength decreases, but the slip at the peak bond stress increases as the lateral tensile stress increases. For a given lateral tensile stress, the bond strength increases, but the slip at the peak bond stress decreases with an increase in lateral compressive stress. Based on the experimental results, an empirical bond stress-slip relationship is proposed. It is shown that, for different strengths of concrete, bar diameters, and combinations of lateral stresses, the empirical bond stress-slip relationship is in good agreement with the experimental results.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
The financial support from the National Natural Science Foundation with grant numbers 51078057 and 51121005; the Open Research Fund Program of State Key Laboratory of Hydroscience and Engineering with grant number sklhse-2008-D-03; and the Natural Science Foundation of Zhejiang Province with grant number LY12E08022, of the People’s Republic of China, is greatly acknowledged.
References
Abrams, D. A. (1913). “Tests of bond between concrete and steel.” Bulletin No. 71, Engineering Experiment Station, Univ. of Illinois, Urbana, IL, 240.
Baldwin, M. I., and Clark, L. A. (1995). “The assessment of reinforcing bars with inadequate anchorage.” Mag. Concr. Res., 47(171), 95–102.
Bamonte, P. F., and Gambarova, P. G. (2007). “High-bond bars in NSC and HPC: Study on size effect and on the local bond stress-slip law.” J. Struct. Eng., 225–234.
Comité Euro-Internationa du Béton (CEB-FIP). (1993). “CEB-FIP model code.” MC-90, London.
Comité Euro-Internationa du Béton (CEB-FIP). (2010). CEB-FIP model code 2010, MC-2010, Lausanne, Switzerland.
Eibl, J., Akkermann, J., Idda, K., and Lucero-Cimas, H. N. (1998). “Rotational behaviour of reinforced concrete corners and bond under lateral tension.” Comité Euro-International du Béton, Ductility of reinforced concrete structures, Bulletin d’information, Lausanne, 259–273.
Eligehausen, R., Popov, E. P., and Bertero, V. V. (1983). “Local bond stress-slip relationships of deformed bars under generalized excitations.” Rep. No. UCB/EERC-82-23, Earthquake Engineering Research Center, Univ. of California, Berkeley, CA.
Feldman, L. R., and Bartlett, F. M. (2005). “Bond strength variability in pullout specimens with plain reinforcement.” ACI Struct. J., 102(6), 860–867.
Feldman, L. R., and Bartlett, F. M. (2007). “Bond stresses along plain steel reinforcing bars in pullout specimens.” ACI Struct. J., 104(6), 685–692.
Fishburn, C. C. (1947). “Strength and slip under load of bent-bar anchorages and straight embedments in haydite concrete.” J. Am. Concr. Inst., 44(12), 289–306.
Khandaker, M. A. H. (2008). “Bond characteristics of plain and deformed bars in lightweight pumice concrete.” Constr. Build. Mater., 22(7), 1491–1499.
Kupfer, H., Hilsdorf, H. K., and Rusch, H. (1969). “Behavior of concrete under biaxial stresses.” J. Am. Concr. Inst., 66(8), 656–666.
Laldji, S., and Young, A. G. (1988). “Bond between steel strand and cement grout in ground anchorage.” Mag. Concr. Res., 40(143), 90–98.
Larrard, F. D., Schaller, I., and Fuchs, J. (1993). “Effect of bar diameter on the bond strength of passive reinforcement in high-performance concrete.” ACI Mater. J., 90(4), 333–339.
Lindorf, A., Lemnitzer, L., and Curbach, M. (2009). “Experimental investigations on bond behaviour of reinforced concrete under transverse tension and repeated loading.” Eng. Struct., 31(7), 1469–1476.
Malvar, L. J. (1992). “Bond of reinforcement under controlled confinement.” ACI Mater. J., 89(6), 593–601.
Malvar, L. J. (1995). “Tensile and bond properties of GFRP reinforcing bars.” ACI Mater. J., 92(3), 276–285.
Malvar, L. J., Cox, J. V., and Cochran, K. B. (2003). “Bond between carbon fiber reinforced polymer bars and concrete. I: Experimental study.” J. Compos. Constr., 154–163.
Moosavi, M., Jafari, A., and Khosravi, A. (2005). “Bond of cement grouted reinforcing bars under constant radial pressure.” Cem. Concr. Compos., 27(1), 103–109.
Navaratnarajah, V. (1982). “Influence of tensile release in concrete on transfer bond of reinforcement bars.” Proc., Int. Conf., Bond in Concrete, Applied Science, London, 250–255.
Navaratnarajah, V., and Speare, P. R. S. (1986). “An experimental study of the effects of lateral pressure on the transfer bond of reinforcing bars with variable cover.” Proc. Inst. Civ. Eng, 81(4), 697–715.
RILEM/CEB/FIP. (1983). “Bond test for reinforcing steel 2: Pullout test.” Recommendation RC6, E & FN SOPN, London, 218–220.
Robins, P. J., and Standish, I. G. (1982). “The effect of lateral pressure on the bond of round reinforcing bars in concrete.” Int. J. Adhes. Adhes., 2(2), 129–133.
Robins, P. J., and Standish, I. G. (1984). “The influence of lateral pressure upon anchorage bond.” Mag. Concr. Res., 36(129), 195–202.
Soroushian, P., and Choi, K. B. (1989). “Local bond of deformed bars with different diameters in confined concrete.” ACI Struct. J., 86(2), 217–222.
Taylor, H. P. J., and Clarke, J. L. (1976). “Some detailing problems in concrete frame structures.” Struct. Eng., 54(1), 19–32.
Untrauer, R. E., and Henry, R. L. (1965). “Influence of normal pressure on bond strength.” J. Am. Concr. Inst., 62(5), 577–585.
Verderame, G. M., De Carlo, G., Ricci, P., and Fabbrocino, G. (2009a). “Cyclic bond behaviour of plain bars. II: Analytical investigation.” Constr. Build. Mater., 23(12), 3512–3522.
Verderame, G. M., Ricci, P., Carlo, G. D., and Manfredi, G. (2009b). “Cyclic bond behaviour of plain bars. I: Experimental investigation.” Constr. Build. Mater., 23(12), 3499–3511.
Walker, P., Batayneh, M., and Regan, P. (1997). “Bond strength tests on deformed reinforcement in normal weight concrete.” Mater. Struct., 30(7), 424–429.
Xiao, J., and Falkner, H. (2007). “Bond behaviour between recycled aggregate concrete and steel rebars.” Constr. Build. Mater., 21(2), 395–401.
Xu, F., Wu, Z., Zheng, J., Hu, Y., and Li, Q. (2012). “Experimental study on the bond behavior of reinforcing bars embedded in concrete subjected to lateral pressure.” J. Mater. Civ. Eng., 125–133.
Information & Authors
Information
Published In
Copyright
© 2013 American Society of Civil Engineers.
History
Received: Apr 2, 2012
Accepted: May 10, 2013
Published online: May 14, 2013
Published in print: Apr 1, 2014
Discussion open until: Apr 28, 2014
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.