Out-of-Plane Strength of Confined Masonry Walls
Publication: Journal of Structural Engineering
Volume 138, Issue 11
Abstract
This paper presents the results of a study on the out-of-plane behavior of confined masonry walls. Six full-scale walls were tested in a laboratory under incremental uniform pressures. Walls with different aspect ratios, slenderness ratios, and in-plane stiffness of confining elements were considered. The spring-strut method was developed in this work to determine the out-of-plane strength of the walls. Experimental out-of-plane strengths are compared with those obtained with analytical models based on this spring-strut method, the yield line method, the failure line method, and the compressive strut method. Based on the experimental results, for walls with similar geometry, the out-plane strength depends mainly on the in-plane stiffness of the confining elements. From the comparison between experimental and analytical results, the out-of-plane strengths are well predicted with the model based on the spring-strut method, are underestimated with that based on the yield and failure line methods, and are overestimated with the model based on the compressive strut method.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
This research project was sponsored by CONACYT.
References
Abrams, D. P., Angel, R., and Uzarski, J. (1996). “Out-of-plane strength of unreinforced masonry infill panels.” Earthq. Spectra, 12(4), 825–844.
ASTM. (2003). “Standard test methods of conducting strength tests of panels for building construction.” ASTM E 72, West Conshohocken, PA.
Federal District Government (FDG). (2004). Mexico City concrete technical norm, Federal District Officail Gazette, Mexico City.
Dawe, J. L., and Seah, C. K. (1989). “Out-of-plane resistance of concrete masonry infilled panels.” Can. J. Civ. Eng., 16(6), 854–856.
Drysdale, R. G., and Essawy, A. S. (1998). “Out-of-plane bending of concrete block walls.” J. Struct. Eng., 144(1), 121–134.
Drysdale, R. G., Hamid, A. A., and Baker, L. R. (1999). Masonry structures: Behavior and design, 2nd Ed., The Masonry Society, Boulder, CO.
Flanagan, R. D., and Bennett, R. M. (1999). “Arching of masonry infilled frames: Comparison of analytical methods.” Pract. Period. Struct. Des. Constr., 4(3), 105–110.
Griffith, M., and Vaculik, J. (2007). “Out-of-plane flexural strength of unreinforced clay brick masonry walls.” TMS J., 25(1), 53–68.
Klingner, R. E., Rubiano, N. R., Bashandy, T. R., and Sweeney, S. C. (1996). “Evaluation and analytical verification of shaking table data from infilled frames part II: Out-of-plane behavior.” Proc., 7th North Am. Mason Conf., The Masonry Society, Longmont, CO, 521–532.
National Organization for Norms and Certification for Construction and Buildings (ONNCCE). (2001). “Construction industry—Cement—Determination of the compressive strength of hydraulic cements.” NMX-C-061-ONNCCE-2001, ONNCCE, Mexico City.
National Organization for Norms and Certification for Construction and Buildings (ONNCCE). (2002). “Construction industry—Concrete—Determination of the compressive strength of concrete cylinders.” NMX-C-083-ONNCCE-2002, ONNCCE, Mexico City.
National Organization for Norms and Certification for Construction and Buildings (ONNCCE). (2003). A preliminary norm on the determination of the compressive strength and the modulus of elasticity of clay and concrete masonry prisms, ONNCCE, Mexico City.
National Organization for Norms and Certification for Construction and Buildings (ONNCCE). (2004). “Construction industry—Blocks and bricks—Compressive strength—Test methods.” NMX-C-036-ONNCE-2004, ONNCCE, Mexico City.
SAP2000, Version 11.0.0 [Computer software]. Berkeley, CA, Computers and Structures.
Tu, Y. H., Liu, P. M., and Lin, H. P. (2007). “Out-of-plane seismic behavior of unreinforced masonry in-filled walls.” Proc., Sessions 2007 Struct. Cong., ASCE, Reston, VA.
Varela-Rivera, J. L., Navarrete-Macías, D., Fernández-Baqueiro, L. E., and Moreno, E. I. (2011). “Out-of-plane behaviour of confined masonry walls.” Eng. Struct., 33(5), 1734–1741.
Information & Authors
Information
Published In
Copyright
© 2012 American Society of Civil Engineers.
History
Received: Jun 14, 2011
Accepted: Feb 8, 2012
Published online: Feb 10, 2012
Published in print: Nov 1, 2012
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.