Effect of Reactant Injection Rate on Solidifying Aeolian Sand via Microbially Induced Calcite Precipitation
Publication: Journal of Materials in Civil Engineering
Volume 32, Issue 10
Abstract
Aeolian sand is a type of special soil with a loose structure, fine and uniform particles, and poor self-stabilization ability. These characteristics easily lead to sand dune movement and wind erosion in dry desert conditions. Therefore, reinforcement technology for aeolian sand is an important research topic. Microbially induced calcite precipitation (MICP) is a novel microbial soil-strengthening technique considered in this study with a focus on the effect of the reactant injection rate on the microbial solidification of aeolian sand. The aeolian sand was solidified using MICP with different injection rates of the cementing solution. The physical and mechanical properties as well as the microstructure of the solidified aeolian sand samples were analyzed. The experimental results show that using Sporosarcina pasteurii and the cementing solution (a mixture of urea and calcium chloride) can effectively solidify aeolian sand using the MICP technology. The engineering performance of the sand was effectively improved with an unconfined compressive strength that approached 14.01 MPa. The permeability coefficient of the solidified aeolian sand was significantly reduced, and the injection rate of the cementing solution significantly affected its uniformity. When the injection rate of the cementing solution was too low, most of the calcium carbonate was generated and accumulated at the top of the sand sample. Therefore, the upper part of the sample was relatively dense and strong, while the lower part had the opposite properties. When the injection rate of the cementing solution was too high, the roles of the upper and lower parts of the sample were reversed. When the injection rate of the cementing solution was , the solidified aeolian sand sample was relatively uniform and had a moderate unconfined compressive strength of . The uniform and high strength of the solidified aeolian sand was obtained by controlling the reactant injection rate. The optical microscope and SEM analyses indicated that the calcium carbonate crystals were rhombic hexahedral with sizes of approximately . The calcium carbonate crystals were generated from the MICP in the solidified aeolian sand, which cemented the sand particles together, filled the pores between particles, increased the density and strength of the sand, and reduced its permeability coefficient.
Get full access to this article
View all available purchase options and get full access to this article.
Data Availability Statement
No data, models, or code were generated or used during the study.
Acknowledgments
This research was funded by the National Key Research and Development Program of China (Grant Nos. 2017YFC0504703 and 2016YFE0203400) and the Shaanxi Science and Technology Coordination Innovation Project Plan (Grant No. 2013KTDZ03-03-01).
References
Abo-El-Enein, S. A., A. H. Ali, F. N. Talkhan, and H. A. Abdel-Gawwad. 2012. “Utilization of microbial induced calcite precipitation for sand consolidation and mortar crack remediation.” HBRC J. 8 (3): 185–192. https://doi.org/10.1016/j.hbrcj.2013.02.001.
Anagnostopoulos, C. A., T. Papaliangas, S. Manolopoulou, and T. Dimopoulos. 2011. “Physical and mechanical properties of chemically grouted sand.” Tunnelling Underground Space Technol. Incorporating Trenchless Technol. Res. 26 (6): 718–724. https://doi.org/10.1016/j.tust.2011.05.006.
Bang, S. S., J. K. Galinat, and V. Ramakrishnan. 2001. “Calcite precipitation induced by polyurethane-immobilized Bacillus pasteurii.” Enzyme Microb. Technol. 28 (4): 404–409. https://doi.org/10.1016/S0141-0229(00)00348-3.
Cheng, L., and R. Cord-Ruwisch. 2012. “In situ soil cementation with ureolytic bacteria by surface percolation.” Ecol. Eng. 42 (May): 64–72. https://doi.org/10.1016/j.ecoleng.2012.01.013.
Cheng, L., and R. Cord-Ruwisch. 2014. “Upscaling effects of soil improvement by microbially induced calcite precipitation by surface percolation.” Geomicrobiol. J. 31 (5): 396–406. https://doi.org/10.1080/01490451.2013.836579.
Cheng, L., R. Cord-Ruwisch, and M. A. Shahin. 2013. “Cementation of sand soil by microbially induced calcite precipitation at various degrees of saturation.” Can. Geotech. J. 50 (1): 81–90. https://doi.org/10.1139/cgj-2012-0023.
Choi, S. G., S. S. Park, S. F. Wu, and J. Chu. 2017. “Methods for calcium carbonate content measurement of biocemented soils.” J. Mater. Civ. Eng. 29 (11): 06017015. https://doi.org/10.1061/(ASCE)MT.1943-5533.0002064.
Chu, J., V. Ivanov, M. Naeimi, V. Stabnikov, and H. L. Liu. 2014. “Optimization of calcium-based bioclogging and biocementation of sand.” Acta Geotech. 9 (2): 277–285. https://doi.org/10.1007/s11440-013-0278-8.
DeJong, J. T., M. B. Fritzges, and K. Nüsslein. 2006. “Microbially induced cementation to control sand response to undrained shear.” J. Geotech. Geoenviron. Eng. 132 (11): 1381–1392. https://doi.org/10.1061/(ASCE)1090-0241(2006)132:11(1381).
DeJong, J. T., B. M. Mortensen, B. C. Martinez, and D. C. Nelson. 2010. “Bio-mediated soil improvement.” Ecol. Eng. 36 (2): 197–210. https://doi.org/10.1016/j.ecoleng.2008.12.029.
De Muynck, W., N. De Belie, and W. Verstraete. 2010. “Microbial carbonate precipitation in construction materials: A review.” Ecol. Eng. 36 (2): 118–136. https://doi.org/10.1016/j.ecoleng.2009.02.006.
Dhami, N. K., R. M. Sudhakara, and M. Abhijit. 2013. “Biomineralization of calcium carbonates and their engineered applications. A review.” Front. Microbiol. 4 (314): 314. https://doi.org/10.3389/fmicb.2013.00314.
Elipe, M. G. M., and L. Q. Susana. 2014. “Aeolian sands: Characterization, options of improvement and possible employment in construction—The state-of-the-art.” Constr.Build. Mater. 73 (Dec): 728–739. https://doi.org/10.1016/j.conbuildmat.2014.10.008.
Li, B. 2015. “Geotechnical properties of biocement treated sand and clay.” Ph.D. thesis, School of Civil and Environmental Engineering, Nanyang Technological Univ.
Li, D., K. L. Tian, H. L. Zhang, Y. Y. Wu, K. Y. Nie, and S. C. Zhang. 2018. “Experimental investigation of solidifying desert aeolian sand using microbially induced calcite precipitation.” Constr. Build. Mater. 172 (May): 251–262. https://doi.org/10.1016/j.conbuildmat.2018.03.255.
Lou, F. J., L. He, Z. Pan, W. H. Duan, X. L. Zhao, and C. Frank. 2013. “Effect of very fine particles on workability and strength of concrete made with dune sand.” Constr. Build. Mater. 47 (5): 131–137. https://doi.org/10.1016/j.conbuildmat.2013.05.005.
Mitchell, J. K., and J. C. Santamarina. 2005. “Biological considerations in geotechnical engineering.” J. Geotech. Geoenviron. Eng. 131 (10): 1222–1233. https://doi.org/10.1061/(ASCE)1090-0241(2005)131:10(1222).
Mujah, D., M. A. Shahin, and L. Cheng. 2017. “State-of-the-art review of biocementation by microbially induced calcite precipitation (MICP) for soil stabilization.” Geomicrobiol. J. 34 (6): 524–537. https://doi.org/10.1080/01490451.2016.1225866.
Qabany, A. A., and K. Soga. 2013. “Effect of chemical treatment used in MICP on engineering properties of cemented soils.” Géotechnique 63 (4): 331–339. https://doi.org/10.1680/geot.SIP13.P.022.
Ramachandran, S. K., V. Ramakrishnan, and S. S. Bang. 2001. “Remediation of concrete using micro-organisms.” ACI Mater. J. 98 (1): 3–9. https://doi.org/10.14359/10154.
Rong, H., and C. X. Qian. 2015. “Cementation process for bio-cement binding loose sand particles.” J. Adv. Microsc. Res. 10 (4): 254–259. https://doi.org/10.1166/jamr.2015.1272.
Rong, H., C. X. Qian, and L. Li. 2013. “Cementation mechanism of microbe cement.” [In Chinese.] J. Chin. Ceram. Soc. 41 (41): 314–319. https://doi.org/10.7521/j.issn.04545648.2013.03.07.
Tian, K. L., Y. Y. Wu, H. L. Zhang, D. Li, K. Y. Nie, and S. C. Zhang. 2018. “Increasing wind erosion resistance of aeolian sandy soil by microbially induced calcium carbonate precipitation.” Land Degrad. Dev. 29 (12): 4271–4281. https://doi.org/10.1002/ldr.3176.
Van Paassen, L. A., M. C. M. Loosdrecht, M. Pieron, A. Mulder, D. J. M. Ngan-Tillard, and T. J. M. Linden. 2009. “Strength and deformation of biologically cemented sandstone.” In Proc., ISRM Regional Symposium—EUROCK 2009. Salzburg, Austria: International Society for Rock Mechanics and Rock Engineering.
Wang, Z. Y., N. Zhang, G. J. Cai, Y. Jin, N. Ding, and D. J. Shen. 2017. “Review of ground improvement using microbial induced carbonate precipitation (MICP).” Mar. Georesour. Geotech. 38 (8): 1135–1146. https://doi.org/10.1080/1064119X.2017.1297877.
Whiffin, V. S. 2004. “Microbial CaCO3 precipitation for the production of biocement.” Ph.D. thesis, School of Biological and Biotechnology, Murdoch Univ.
Whiffin, V. S., L. A. Paassen, and M. P. Harkes. 2007. “Microbial carbonate precipitation as a soil improvement technique.” Geomicrobiol. J. 24 (5): 417–423. https://doi.org/10.1080/01490450701436505.
Zhenghu, D., X. Honglang, D. Zhibao, W. Gang, and S. Drake. 2007. “Morphological, physical and chemical properties of aeolian sandy soils in Northern China.” J. Arid. Environ. 68 (1): 66–76. https://doi.org/10.1016/j.jaridenv.2006.05.002.
Information & Authors
Information
Published In
Copyright
©2020 American Society of Civil Engineers.
History
Received: Jul 9, 2019
Accepted: Apr 7, 2020
Published online: Jul 28, 2020
Published in print: Oct 1, 2020
Discussion open until: Dec 28, 2020
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.