Performance Evaluation of Epoxy-Asphalt Mixture Blended with Glass Aggregate
Publication: Journal of Materials in Civil Engineering
Volume 31, Issue 6
Abstract
Applying glass aggregate in asphalt mixtures is an effective approach to addressing environmental pollution. In this research, epoxy asphalt was adopted instead of conventional asphalt. The experiments were performed to investigate the influence of glass aggregate on the performance of the epoxy–asphalt mixture compared with styrene-butadiene-styrene (SBS) copolymer modified asphalt. The results show that for the two asphalt mixtures, the optimum binder content, void, and density decrease with increases in glass aggregate content. The Marshall stability, soaked Marshall stability, tensile strength ratio, antirutting, and low-temperature property of the epoxy–asphalt mixture are slightly affected by the glass aggregate content, significantly different from those of the SBS-modified asphalt mixture. In addition, the epoxy–asphalt mixture blended with glass aggregate possesses good antifriction and reflective properties. Thus, in the epoxy–asphalt mixture, the high content of glass aggregate can be utilized to attain superior performance without an antistripping agent and mitigate increasing environmental pollution.
Get full access to this article
View all available purchase options and get full access to this article.
References
Androjić, I., and S. Dimter. 2014. “Properties of hot mix asphalt with substituted waste glass.” Mater. Struct. 49 (1–2): 249–259. https://doi.org/10.1617/s11527-014-0492-3.
Arabani, M. 2011. “Effect of glass cullet on the improvement of the dynamic behaviour of asphalt concrete.” Constr. Build. Mater. 25 (3): 1181–1185. https://doi.org/10.1016/j.conbuildmat.2010.09.043.
Arabani, M., R. Jamshidi, and M. Sadeghnejad. 2014. “Using of 2D finite element modeling to predict the glasphalt mixture rutting behavior.” Constr. Build. Mater. 68: 183–191. https://doi.org/10.1016/j.conbuildmat.2014.06.057.
ASTM. 2013a. Standard test method for measuring surface frictional properties using the British pendulum tester. ASTM E303-93. West Conshohocken, PA: ASTM.
ASTM. 2013b. Standard test method for penetration of bituminous materials. ASTM D5/D5M-13. West Conshohocken, PA: ASTM.
ASTM. 2014a. Standard test method for effect of moisture on asphalt concrete paving mixtures. ASTM D4867/D4867M-09. West Conshohocken, PA: ASTM.
ASTM. 2014b. Standard test method for softening point of bitumen. ASTM D36/D36M-14. West Conshohocken, PA: ASTM.
ASTM. 2014c. Standard test method for tensile properties of plastics. ASTM D4638-14. West Conshohocken, PA: ASTM.
ASTM. 2015. Standard test method formarshall stability and flow of asphalt mixtures. ASTM D6927. West Conshohocken, PA: ASTM.
ASTM. 2016. Standard test method for measurement of retroreflective signs using a portable retroreflectometer at a 0.2 degree observation angle. ASTM E1709. West Conshohocken, PA: ASTM.
ASTM. 2017. Standard test method for ductility of asphalt materials. ASTM D113-17. West Conshohocken, PA: ASTM.
Behbahani, H., H. Ziari, N. Kamboozia, A. Mansour Khaki, and S. M. Mirabdolazimi. 2015. “Evaluation of performance and moisture sensitivity of glasphalt mixtures modified with nanotechnology zycosoil as an anti-stripping additive.” Constr. Build. Mater. 78: 60–68. https://doi.org/10.1016/j.conbuildmat.2014.12.053.
Bocci, E., A. Graziani, and F. Canestrari. 2015. “Mechanical 3D characterization of epoxy asphalt concrete for pavement layers of orthotropic steel decks.” Constr. Build. Mater. 79: 145–152. https://doi.org/10.1016/j.conbuildmat.2014.12.120.
Code of China. 2005. Test methods of aggregate for highway engineering. JTG E42. Beijing: Code of China.
Code of China. 2009. Specification and test method for road traffic markings. GB/T16311. Beijing: Code of China.
Code of China. 2011. Standard test methods of bitumen and bituminous mixtures for highway engineering. JTG E20. Beijing: Code of China.
Code of China. 2014. General specification of epoxy asphalt materials for paving roads and bridges. GB/T30598. Beijing: Code of China.
Code of China. 2017. Specifications for design of highway asphalt pavement. JTG D50. Beijing: Code of China.
Huang, W., Z. Qian, G. Chen, and J. Yang. 2003. “Epoxy asphalt concrete paving on the deck of long-span steel bridges.” Chin. Sci. Bull. 48 (21): 2391. https://doi.org/10.1360/02ww0123.
Huang, Y., R. N. Bird, and O. Heidrich. 2007. “A review of the use of recycled solid waste materials in asphalt pavements.” Resour. Conserv. Recycl. 52 (1): 58–73. https://doi.org/10.1016/j.resconrec.2007.02.002.
Lu, H., W. Huang, K. Li, L. Liu, and L. Sun. 2011. “Glasphalt mixtures’ performance research and analysis.” In Proc., 3th Int. Conf. on Transportation Engineering (ICTE), 1427–1432. Reston, VA: ASCE.
Lu, Q., and J. Bors. 2015. “Alternate uses of epoxy asphalt on bridge decks and roadways.” Constr. Build. Mater. 78: 18–25. https://doi.org/10.1016/j.conbuildmat.2014.12.125.
Maupin, G. W. 1997. Glasphalt test sections in Virginia. Charlottesville, VA: Virginia Transportation Research Council.
Maupin, G. W. 1998. Effect of glass concentration on stripping of glasphalt. Charlottesville, VA: Virginia Transportation Research Council.
Min, Z., Y. Xia, X. Li, and Z. Tao. 2017. “Performances evaluation of epoxy asphalt mixture containing snow-melting agent.” Constr. Build. Mater. 155: 762–769. https://doi.org/10.1016/j.conbuildmat.2017.08.009.
Qian, Z., and Q. Lu. 2015. “Design and laboratory evaluation of small particle porous epoxy asphalt surface ixture for roadway pavements.” Constr. Build. Mater. 77: 110–116. https://doi.org/10.1016/j.conbuildmat.2014.12.056.
Song, C., J. X. Zhang, and J. Wang. 2011. “Laboratory study on road performance of glasphalt concrete.” [In Chinese.] J. Wuhan Univ. Technol. 33 (12): 32–36. https://doi.org/10.3963/j.issn.1671-4431.2011.12.008.
Su, N., and J. S. Chen. 2002. “Engineering properties of asphalt concrete made with recycled glass.” Resour. Conserv. Recycl. 35 (4): 259–274. https://doi.org/10.1016/S0921-3449(02)00007-1.
Tam, V. W. Y., and C. M. Tam. 2006. “A review on the viable technology for construction waste recycling.” Resour. Conserv. Recycl. 47 (3): 209–221. https://doi.org/10.1016/j.resconrec.2005.12.002.
Wu, S., W. Yang, and Y. Xue. 2004. Preparation and properties of glass-asphalt concrete. Wuham, China: Key Laboratory for Silicate Materials Science and Engineering of Ministry of Education.
Ziari, H., H. Behbahani, N. Kamboozia, and M. Ameri. 2015. “New achievements on positive effects of nanotechnology zyco-soil on rutting resistance and stiffness modulus of glasphalt mix.” Constr. Build. Mater. 101: 752–760. https://doi.org/10.1016/j.conbuildmat.2015.10.150.
Information & Authors
Information
Published In
Copyright
©2019 American Society of Civil Engineers.
History
Received: Jul 4, 2018
Accepted: Dec 10, 2018
Published online: Mar 30, 2019
Published in print: Jun 1, 2019
Discussion open until: Aug 30, 2019
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.