Numerical Study on Influence of Piezoelectric Energy Harvester on Asphalt Pavement Structural Responses
Publication: Journal of Materials in Civil Engineering
Volume 31, Issue 3
Abstract
In recent years, energy harvesting technologies have been applied in pavement engineering. Piezoelectric energy harvesting in pavement aims to take advantage of the vehicle load on a road. Most of the existing theoretical and experimental research focused on the materials, structures, and shape of the energy harvesters to improve the efficiency of the output energy. However, few investigations have analyzed the compatibility of piezoelectric energy harvesters (PEHs) and pavement. This study investigated the influence of PEHs on the structural response of asphalt pavement. Three-dimensional (3D) tire–pavement interaction finite-element models with and without a PEH were constructed according to a previous demonstration project. Several critical points within the pavement structures were selected and their mechanical responses induced by the passing tire were compared and discussed. A parametric study analyzed the pavement responses to different traffic speeds, tire loads, and bonding conditions between the PEHs and asphalt layers. Two potential optimization solutions for the PEH were explored. The results showed that the influence of the PEH on the asphalt pavement performance is significant in terms of the horizontal and vertical strains and von Mises stresses. A PEH causes potential permanent damage initiation in its adjacent area within the pavement structure. The maximum values of the horizontal tensile strains appeared at the bottom of the asphalt surface course in all pavement models with a PEH. These conclusions offer basic information for improving the practical design of PEHs in asphalt pavement.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
This paper is based on a part of a research project carried out at the request of the German Research Foundation (DFG) under research project No. OE 514/1-2 (FOR2089). The authors are solely responsible for the content.
References
Abaqus. 2014. Abaqus analysis user’s manual 6.14. Providence, RI: Dassault Systemes Simulia.
Batra, A. K., S. Bhattacharjee, A. K. Chilvery, M. D. Aggarwal, M. E. Edwards, and A. S. Bhalla. 2011. “Simulation of energy harvesting from roads via pyroelectricity.” J. Photonics Energy 1 (1): 014001. https://doi.org/10.1117/1.3656395.
Chae, S. 2006. Nonlinear finite element modeling and analysis of a truck tire. University Park, TX: Pennsylvania State Univ.
Chen, F., and S. R. Anton. 2017. “Towards an understanding of the structural performance of future electrified roads: A finite element simulation study.” Int. J. Pavement Eng. 20 (2): 204–215. https://doi.org/10.1080/10298436.2017.1279487.
Chen, Y., H. Zhang, Y. Zhang, C. Li, Q. Yang, H. Zheng, and C. Lv. 2016. “Mechanical energy harvesting from road pavements under vehicular load using embedded piezoelectric elements.” J. Appl. Mech.–Trans. the ASME 83 (8): 0810018. https://doi.org/10.1115/1.4033433.
Chiarelli, A., A. Dawson, and A. Garcia. 2015. “Analysis of the performance of an air-powered energy-harvesting pavement.” Transp. Res. Rec. 2523: 156–163. https://doi.org/10.3141/2523-17.
Dakessian, L., H. Harfoushian, D. Habib, G. R. Chehab, G. Saad, and I. Srour. 2016. “Finite element approach to assess the benefits of asphalt solar collectors.” Transp. Res. Rec. 2575 (1): 79–91. https://doi.org/10.3141/2575-09.
Faisal, F., N. Wu, and K. Kapoor. 2016. “Energy harvesting in pavement from passing vehicles with piezoelectric composite plate for ice melting.” In Proc., SPIE Bellingham: SPIE-Int. Society Optical Engineering. Bellingham, WA: Society of Photographic Instrumentation Engineers.
Galchev, T. V., J. Mccullagh, R. L. Peterson, and K. Najafi. 2011. “Harvesting traffic-induced vibrations for structural health monitoring of bridges.” J. Micromech. Microeng. 21 (10): 104005–104017. https://doi.org/10.1088/0960-1317/21/10/104005.
Huang, H., and K. Chen. 2016. “Design, analysis, and experimental studies of a novel PVDF-based piezoelectric energy harvester with beating mechanisms.” Sens. Actuators A Phys. 238: 317–328. https://doi.org/10.1016/j.sna.2015.11.036.
Kan, J., C. Fan, S. Wang, Z. Zhang, J. Wen, and L. Huang. 2016. “Study on a piezo-windmill for energy harvesting.” Renewable Energy 97: 210–217. https://doi.org/10.1016/j.renene.2016.05.055.
Karimi, M., A. H. Karimi, R. Tikani, and S. Ziaei-Rad. 2016. “Experimental and theoretical investigations on piezoelectric-based energy harvesting from bridge vibrations under travelling vehicles.” Int. J. Mech. Sci. 119: 1–11. https://doi.org/10.1016/j.ijmecsci.2016.09.029.
Lin, Y. J., and S. J. Hwang. 2004. “Temperature prediction of rolling tires by computer simulation.” Math. Comput. Simul. 67 (3): 235–249. https://doi.org/10.1016/j.matcom.2004.07.002.
Liu, P., F. Otto, D. Wang, M. Oeser, and H. Balck. 2017a. “Measurement and evaluation on deterioration of asphalt pavements by geophones.” Measurement 109: 223–232. https://doi.org/10.1016/j.measurement.2017.05.066.
Liu, P., V. Ravee, D. Wang, and M. Oeser. 2018a. “Study of the influence of pavement unevenness on the mechanical response of asphalt pavement by means of the finite element method.” J. Traffic Transp. Eng. 5 (3): 169–180. https://doi.org/10.1016/j.jtte.2017.12.001.
Liu, P., D. Wang, J. Hu, and M. Oeser. 2017b. “SAFEM—Software with graphical user interface for fast and accurate finite element analysis of asphalt pavements.” J. Test. Eval. 45 (4): 1301–1315. https://doi.org/10.1520/JTE20150456.
Liu, P., D. Wang, and M. Oeser. 2013. “Leistungsfähige semi-analytische Methoden zur Berechnung von Asphaltbefestigungen.” [In German.] In Proc., 3rd Dresdner Asphalttage, 12–13. Dresden, Germany: TU Dresden.
Liu, P., D. Wang, and M. Oeser. 2017c. “Application of semi-analytical finite element method to analyze asphalt pavement response under heavy traffic loads.” J. Traffic Transp. Eng. 4 (2): 206–214. https://doi.org/10.1016/j.jtte.2017.03.003.
Liu, P., D. Wang, F. Otto, and M. Oeser. 2018b. “Application of semi-analytical finite element method to analyze the bearing capacity of asphalt pavements under moving loads.” Front. Struct. Civ. Eng. 12 (2): 215–221. https://doi.org/10.1007/s11709-017-0401-2.
Lv, J., K. Yang, L. Sun, W. H. Chen, and Y. Q. Tan. 2015. “Finite element analysis of piezoelectric stack transducer embedded in asphalt pavement.” In Proc., 2015 Symp. on Piezoelectricity, Acoustic Waves and Device Applications, 152–156. Piscataway, NJ: IEEE.
Moure, A., M. I. Rodríguez, S. H. Rueda, A. Gonzalo, F. Rubio-Marcos, D. U. Cuadros, A. Pérez-Lepe, and J. F. Fernández. 2016. “Feasible integration in asphalt of piezoelectric cymbals for vibration energy harvesting.” Energy Convers. Manage. 112: 246–253. https://doi.org/10.1016/j.enconman.2016.01.030.
Roshani, H., S. Dessouky, A. Montoya, and A. T. Papagiannakis. 2016. “Energy harvesting from asphalt pavement roadways vehicle-induced stresses: A feasibility study.” Appl. Energy 182: 210–218. https://doi.org/10.1016/j.apenergy.2016.08.116.
Roshani, H., P. Jagtap, S. Dessouky, A. Montoya, and A. T. Papagiannakis. 2017. “Theoretical and experimental evaluation of two roadway piezoelectric-based energy harvesting prototypes.” J. Mater. Civ. Eng. 30 (2): 04017264. https://doi.org/10.1061/(ASCE)MT.1943-5533.0002112.
Sun, C. H., G. Q. Shang, Y. K. Zhang, and J. H. Du. 2013. “Designing piezoelectric harvesting unit from road vibration.” In Advanced materials research, 1368–1371. Stafa, Zurich: Trans Tech.
Wang, D., P. Liu, Z. Leng, C. Leng, G. Lu, M. Buch, and M. Oeser. 2017. “Suitability of PoroElastic Road Surface (PERS) for urban roads in cold regions: Mechanical and functional performance assessment.” J. Cleaner Prod. 165: 1340–1350. https://doi.org/10.1016/j.jclepro.2017.07.228.
Wischke, M., M. Masur, M. Kröner, and P. Woias. 2011. “Vibration harvesting in traffic tunnels to power wireless sensor nodes.” Smart Mater. Struct. 20 (8): 85014–85021. https://doi.org/10.1088/0964-1726/20/8/085014.
Xiong, H., and L. Wang. 2016. “Piezoelectric energy harvester for public roadway: On-site installation and evaluation.” Appl. Energy 174: 101–107. https://doi.org/10.1016/j.apenergy.2016.04.031.
Yang, H., M. Guo, L. Wang, Y. Hou, Q. Zhao, D. Cao, B. Zhou, and D. Wang. 2017a. “Investigation on the factors influencing the performance of piezoelectric energy harvester.” Supplement, Road Mater. Pavement Des. 18 (S3): 180–189. https://doi.org/10.1080/14680629.2017.1329873.
Yang, H., L. Wang, Y. Hou, M. Guo, Z. Ye, X. Tong, and D. Wang. 2017b. “Development in stacked-array-type piezoelectric energy harvester in asphalt pavement.” J. Mater. Civ. Eng. 2 (11): 04017224. https://doi.org/10.1061/(ASCE)MT.1943-5533.0002079.
Yang, H., L. Wang, B. Zhou, Y. Wei, and Q. Zhao. 2018. “A preliminary study on the highway piezoelectric power supply system.” Int. J. Pavement Res. Technol. 11 (2): 168–175. https://doi.org/10.1016/j.ijprt.2017.08.006.
Yesner, G., M. Kuciej, A. Safari, A. Jasim, H. Wang, and A. Maher. 2016. “Piezoelectric energy harvesting using a novel cymbal transducer design.” In Proc., Joint IEEE Int. Symp. on the Applications of Ferroelectrics, European Conf. on Application of Polar Dielectrics, and Piezoelectric Force Microscopy Workshop (ISAF/ECAPD/PFM). Red Hook, NY: Curran Associates.
Zhao, S., and A. Erturk. 2013. “Energy harvesting from harmonic and noise excitation of multilayer piezoelectric stacks: Modeling and experiment.” In Vol. 8688 of Proc., SPIE Bellingham: SPIE-Integrated Systems, 86881Q. Washington, DC: International Society for Optical and Engineering.
Zhao, Q., Y. Liu, L. Wang, H. Yang, and D. Cao. 2017. “Design method for piezoelectric cantilever beam structure under low frequency condition.” Int. J. Pavement Res. Technol. 11 (2): 153–159. https://doi.org/10.1016/j.ijprt.2017.08.001.
Zhao, H., Y. Tao, Y. Niu, and J. Ling. 2014. “Harvesting energy from asphalt pavement by piezoelectric generator.” J. Wuhan Univ. Technol.–Mater. Sci. Ed. 29 (5): 933–937. https://doi.org/10.1007/s11595-014-1023-3.
Zhao, H., J. Yu, and J. Ling. 2010. “Finite element analysis of Cymbal piezoelectric transducers for harvesting energy from asphalt pavement.” J. Ceram. Soc. Jpn. 118 (1382): 909–915. https://doi.org/10.2109/jcersj2.118.909.
Information & Authors
Information
Published In
Copyright
©2019 American Society of Civil Engineers.
History
Received: Jul 13, 2018
Accepted: Sep 12, 2018
Published online: Jan 14, 2019
Published in print: Mar 1, 2019
Discussion open until: Jun 14, 2019
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.