Mechanical Behavior of Bitumen and Hot-Mix Asphalt Modified with Zinc Oxide Nanoparticle
Publication: Journal of Materials in Civil Engineering
Volume 31, Issue 3
Abstract
This study evaluates the effect of zinc oxide nanoparticle (ZnONP) on permanent deformation of modified bitumen. The moisture susceptibility was also evaluated in hot-mix asphalt (HMA) prepared by nano-ZnO modified bitumen. Bitumen modification was conducted using a high shear mixer at contents of 1%, 3%, and 5% by weight. Permanent deformation was evaluated using the parameter obtained from dynamic shear rheometer (DSR) test results for modified bitumen. Compaction was conducted by a Superpave gyratory compactor, and moisture susceptibility was using the modified Lottman procedure. The dispersion of nanomaterials was analyzed by scanning electron microscopy (SEM). The best performance was obtained by ZnONP 5% modification. The performance grade was determined as PG 64-22 after all modifications. Optimum bitumen content (OBCs) were decreased by modification except the 1% mix (which had the same results as the reference sample). Asphalt mixtures were found to be highly resistant against moisture for all nanomodifications. Lower performance was determined just for the 1% ZnONP modified HMA as compared to the reference sample. After SEM analysis, the dispersion of nanomaterials in the mixture was homogenous. Up to 4 μm agglomeration was displayed in the mix.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
This work was supported by Suleyman Demirel University (Project No. 4211-D2-14).
References
AASHTO. 2000a. Accelerated aging of asphalt binder using a pressurized aging vessel (PAV). AASHTO R28. Washington, DC: AASHTO.
AASHTO. 2000b. Determining the flexural creep stiffness of asphalt binder using the bending beam rheometer (BBR). AASHTO T313. Washington, DC: AASHTO.
AASHTO. 2000c. Determining the rheological properties of asphalt binder using a dynamic shear rheometer (DSR). AASHTO T315. Washington, DC: AASHTO.
AASHTO. 2000d. Effect of heat and air on a moving film of asphalt (rolling thin-film oven test). AASHTO T240. Washington, DC: AASHTO.
AASHTO. 2000e. Standard specification for performance graded asphalt binder. AASHTO MP1. Washington, DC: AASHTO.
AASHTO. 2000f. Viscosity determination of asphalt binder using rotational viscometer. AASHTO T316. Washington, DC: AASHTO.
AASHTO. 2007. Resistance of compacted bituminous mixture to moisture induced damage for superpave. AASHTO T283. Washington, DC: AASHTO.
ASTM. 1989. Standard test method for specification gravity and absorption of fine aggregate. ASTM C128-88. West Conshohocken, PA: ASTM.
ASTM. 2001. Standard test method for density, relative density (specific gravity), and absorption of coarse aggregate. ASTM C127-88. West Conshohocken, PA: ASTM.
ASTM. 2013. Standard test method for penetration of bituminous materials. ASTM D5/D5M-13. West Conshohocken, PA: ASTM.
ASTM. 2014a. Standard test method for resistance to degradation of small-size coarse aggregate by abrasion and impact in the Los Angeles machine. ASTM C131. West Conshohocken, PA: ASTM.
ASTM. 2014b. Standard test method for softening point of bitumen (Ring-and-Ball apparatus). ASTM D36/D36M-14e1. West Conshohocken, PA: ASTM.
Azarhoosh, A. R., F. M. Nejad, and A. Khodaii. 2016a. “Evaluation of the effect of nano- on the adhesion between aggregate and asphalt binder in hot mix asphalt.” Eur. J. Environ. Civ. Eng. 22 (8): 946–961. https://doi.org/10.1080/19648189.2016.1229227.
Azarhoosh, A. R., F. M. Nejad, and A. Khodaii. 2016b. “Nanomaterial and fatigue cracking of hot mix asphalt.” Road Mater. Pavement Des. 19 (2): 353–366. https://doi.org/10.1080/14680629.2016.1261724.
Azarhoosh, A. R., F. M. Nejad, and A. Khodaii. 2016c. “Using the surface free energy method to evaluate the effects of nanomaterial on the fatigue life of hot mix asphalt.” J. Mater. Civ. Eng. 28 (10): 04016098. https://doi.org/10.1061/(ASCE)MT.1943-533.0001614.
Enieb, M., and A. Diab. 2017. “Characteristics of asphalt binder and mixture containing nanosilica.” Int. J. Pavement Res. Technol. 10 (2): 148–157. https://doi.org/10.1016/j.ijprt.2016.11.009.
Galooyak, S. S., M. Palassi, A. Goli, and H. Z. Farahani. 2015. “Performance evaluation of nano-silica modified bitumen.” Int. J. Transp. Eng. 3 (1): 55–66. https://doi.org/10.22119/IJTE.2015.13377.
Hamedi, G. H., F. M. Nejad, and K. Oveisi. 2016. “Estimating the moisture damage of asphalt mixture modified with nano zinc oxide.” Mater. Struct. 49 (4): 1165–1174. https://doi.org/10.1617/s11527-015-0566-x.
Jahromi, S. G. 2016. “Introduction of a simple method for prediction of the rutting resistance factor of nanoclay-modified bitumen.” Int. J. Pavement Eng. 20 (2): 216–221. https://doi.org/10.1080/10298436.2017.1279488.
Li, R., F. Xiao, S. Amirkhanian, Z. You, and J. Huang. 2017. “Developments of nano materials and technologies on asphalt materials: A review.” Constr. Build. Mater. 143: 633–648. https://doi.org/10.1016/j.conbuildmat.2017.03.158.
Mostafa, A. E. A. 2016. “Examining the performance of hot mix asphalt using nano-materials.” IOSR J. Eng. 6 (2): 25–34.
Motlagh, A. A., A. Kiasat, E. Mirzaei, and F. O. Birgani. 2012. “Bitumen modification using carbon nanotubes.” World Appl. Sci. J. 18 (4): 594–599. https://doi.org/10.5829/idosi.wasj.2012.18.04.1443.
Shafabakhsh, G. H., and O. J. Ani. 2015. “Experimental investigation of effect of nano modified bitumen on the rutting and fatigue performance of asphalt mixtures containing steel slag aggregates.” Constr. Build. Mater. 98: 692–702. https://doi.org/10.1016/j.conbuildmat.2015.08.083.
Shafabakhsh, G. H., S. M. Mirabdolazimi, and M. Sadeghnejad. 2014. “Evaluation the effect of nano- on the rutting and fatigue behavior of asphalt mixtures.” Constr. Build. Mater. 54: 566–571. https://doi.org/10.1016/j.conbuildmat.2013.12.064.
Sun, L., X. Xin, and J. Ren. 2017. “Asphalt modification using nano-materials and polymers composite considering high and low temperature performance.” Constr. Build. Mater. 133: 358–366. https://doi.org/10.1016/j.conbuildmat.2016.12.073.
Tanzadeh, J., F. Vahedi, P. Kheiry, and R. Tanzadeh. 2013. “Laboratory study on the effect of nano- on rutting performance of asphalt pavements.” Adv. Mater. Res. 622–623: 990–994. https://doi.org/10.4028/www.scientific.net/AMR.622-623.990.
Turkey Standards Institute. 2008a. Bitumen and bituminous binders—Determination of needle penetration. TS-EN-1426. Ankara, Turkey: Turkey Standards Institute.
Turkey Standards Institute. 2008b. Bitumen and bituminous binders—Determination of the softening point—Ring and Ball method. TS-EN-1427. Ankara, Turkey: Turkey Standards Institute.
Xiao, F., A. N. Amirkhanian, and S. N. Amirkhanian. 2011. “Influence of carbon nanoparticles on the rheological characteristics of short-term aged asphalt binders.” J. Mater. Civ. Eng. 23 (4): 423–431. https://doi.org/10.1061/(ASCE)MT.1943-5533.0000184.
Yao, H., Z. You, L. Li, C. H. Lee, D. Wingard, Y. K. Yap, X. Shi, and S. W. Goh. 2013. “Rheological properties and chemical bonding of asphalt modified with nanosilica.” J. Mater. Civ. Eng. 25 (11): 1619–1630. https://doi.org/10.1061/(ASCE)MT.1943-5533.0000690.
Yilmaz, A., and S. Sargin. 2012. “Water effect on deteriorations of asphalt pavements.” Online J. Sci. Technol. 2 (1): 1–6.
Yusoff, N. I. M., A. A. S. Breem, H. N. M. Alattug, A. Hamim, and J. Ahmad. 2014. “The effects of moisture susceptibility and ageing conditions on nano-silica/polymer-modified asphalt mixtures.” Constr. Build. Mater. 72: 139–147. https://doi.org/10.1016/j.conbuildmat.2014.09.014.
Zafari, F., M. Rahi, N. Moshtagh, and H. Nazockdast. 2014. “The improvement of bitumen properties by adding nanosilica.” Study Civ. Eng. Archit. 3 (1): 62–69.
Zalnezhad, H., S. S. Galooyak, H. Farahani, and A. Goli. 2015. “Investigating the effect of nano-silica on the specification of the sasobit warm mix asphalt.” Pet. Coal 57 (5): 509–515.
Ziari, H., H. Farahani, A. Goli, and S. S. Galooyak. 2014. “The investigation of the impact of carbon nano tube on bitumen and HMA performance.” Pet. Sci. Technol. 32 (17): 2102–2108. https://doi.org/10.1080/10916466.2013.763827.
Information & Authors
Information
Published In
Copyright
©2018 American Society of Civil Engineers.
History
Received: May 11, 2018
Accepted: Aug 29, 2018
Published online: Dec 24, 2018
Published in print: Mar 1, 2019
Discussion open until: May 24, 2019
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.