Abstract
This paper presents an experimental study that sought to characterize the effect of corrosion and fatigue load on the behavior of reinforcing steel bars. The surface profiles of corroded steel bars and the relationship between fatigue life and corrosion morphology were investigated. First, the corrosion process was accelerated by applying external direct current. Next, fatigue tests were performed on uncorroded specimens and precorroded specimens, and the results are presented and analyzed. A method for calculating the three-dimensional (3D) corrosion morphology coefficient of corroded steel bar is proposed. The fatigue life of corroded bars is significantly reduced because of corrosion morphology, and a logarithmic linear relationship exists between fatigue life and the corrosion morphology coefficient. Considering the corrosion morphology of corroded steel bars, a method is provided to calculate the fatigue life of a corroded steel bar based on the properties of uncorroded steel bar and the 3D surface morphology coefficient of corroded steel bars. The prediction results for corroded steel bars agree well with the experimental observations.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
The authors gratefully acknowledge the financial support provided by the following agencies: the National Basic Research Program of China (973 Program) (Grant No. 2015cb057704) and the National Science Foundation of China (Grant No. 51378081).
References
Apostolopoulos, C. A. 2007. “Mechanical behavior of corroded reinforcing steel bars S500s tempcore under low cycle fatigue.” Constr. Build. Mater. 21 (7): 1447–1456. https://doi.org/10.1016/j.conbuildmat.2006.07.008.
Azevedo, C., and E. R. Marques. 2010. “Three-dimensional analysis of fracture, corrosion and wear surfaces.” Eng. Fail. Anal. 17 (1): 286–300. https://doi.org/10.1016/j.engfailanal.2009.06.010.
Caprili, S., and W. Salvatore. 2015. “Cyclic behavior of uncorroded and corroded steel reinforcing bars.” Constr. Build. Mater. 76: 168–186. https://doi.org/10.1016/j.conbuildmat.2014.11.025.
Du, Y., M. Cullen, and C. Li. 2013. “Structural performance of RC beams under simultaneous loading and reinforcement corrosion.” Constr. Build. Mater. 38: 472–481. https://doi.org/10.1016/j.conbuildmat.2012.08.010.
Jiang, N., Y. Deng, and Y. Liy. 2016. “A calculation method of flexural stiffness of RC beam under sustained load coupled with corrosion.” J. Highway Transp. Res. Dev. 33 (4): 66–72. https://doi.org/10.3969/j.issn.1002-0268.2016.04.011.
Kashani, M. M., P. Alagheband, R. Khan, and S. Davis. 2015. “Impact of corrosion on low-cycle fatigue degradation of reinforcing bars with the effect of inelastic buckling.” Int. J. Fatigue 77: 174–185. https://doi.org/10.1016/j.ijfatigue.2015.03.013.
Li, F., X. Luo, K. Wang, and Y. Ji. 2017a. “Pitting damage characteristics on prestressing steel strands by combined action of fatigue load and chloride corrosion.” J. Bridge Eng. 22 (7): 04017023. https://doi.org/10.1061/(ASCE)BE.1943-5592.0001057.
Li, S., H. Tang, Q. Gui, and J. Ma. 2017b. “Fatigue behavior of naturally corroded plain reinforcing bars.” Costr. Build. Mater. 152 (15): 933–942. https://doi.org/10.1016/j.conbuildmat.2017.06.173.
Li, S., W. Zhang, and X. Gu. 2010. “Experimental study on fatigue properties of corrosion-accelerated steel bars.” J. China Railway Soc. 32 (5): 93–97. https://doi.org/10.3969/j.issn.1001-8360.2010.05.017.
Luo, X., Y. Ou, Z. Zhou, and Y. Bing. 2015. “Experimental study on axial tensile fatigue properties of artificially corroded steel bars.” J. Build. Mater. 3 (13): 21–30. https://doi.org/10.3969/j.issn.1007-9629.2015.06.009.
Ma, Y., L. Wang, J. Zhang, Y. Xiang, T. Peng, and Y. Liu. 2014. “Hybrid uncertainty quantification for probabilistic corrosion damage prediction for aging RC bridges.” J. Mater. Civ. Eng. 27 (4): 04014152. https://doi.org/10.1061/(ASCE)MT.1943-5533.0001096.
Ma, Y., J. Zhang, L. Wang, and Y. Liu. 2013. “Probabilistic prediction with Bayesian updating for strength degradation of RC bridge beams.” Struct. Saf. 44: 102–109. https://doi.org/10.1016/j.strusafe.2013.07.006.
Nakamura, S., and K. Suzumura. 2012. “Experimental study on fatigue strength of corroded bridge wires.” J. Bridge Eng. 18 (3): 200–209. https://doi.org/10.1061/(ASCE)BE.1943-5592.0000366.
Saharan, A., M. Ostoja-Starzewski, and S. Koric. 2013. “Fractal geometric characterization of functionally graded materials.” J. Nanomech. Micromech. 3 (4): 04013001. https://doi.org/10.1061/(ASCE)NM.2153-5477.0000058.
Sajedi, S., and Q. Huang. 2015. “Probabilistic prediction model for average bond strength at steel-concrete interface considering corrosion effect.” Eng. Struct. 99: 120–131. https://doi.org/10.1016/j.engstruct.2015.04.036.
Sun, J., Q. Huang, and Y. Ren. 2015. “Performance deterioration of corroded RC beams and reinforcing bars under repeated loading.” Constr. Build. Mater. 96: 404–415. https://doi.org/10.1016/j.conbuildmat.2015.08.066.
Underwood, E. E., and K. Banerji. 1987. “Quantitative fractography.” In Vol. 12 of ASM handbook, 193–210. Novelty, OH: ASM International.
Vidal, T., A. Castel, and R. Francois. 2004. “Analyzing crack width to predict corrosion in reinforced concrete.” Cem. Concr. Res. 34 (1): 165–174. https://doi.org/10.1016/S0008-8846(03)00246-1.
Xu, Y., C. Qian, L. Bian, and Y. Chen. 2012. “Fractal based characterization of non-uniform corroded surface profile in steel bars.” J. Basic Sci. Eng. 20 (2): 296–303. https://doi.org/10.3969/j.issn.1005-0930.2012.02.013.
Yang, L., J. Nan, and D. Yang. 2016. “Flexural experiment and stiffness investigation of reinforced concrete beam under chloride penetration and sustained.” Constr. Build. Mater. 117: 229–243. https://doi.org/10.1016/j.conbuildmat.2016.04.135.
Yang, Q., J. Ding, and Z. Shen. 2000. “Investigation on fouling behaviors of low-energy surface and fouling fractal characteristics.” Chem. Eng. Sci. 55 (4):797–805. https://doi.org/10.1016/S0009-2509(99)00394-2.
Yu, F., J. Jia, D. Yao, and F. Wu. 2014. “Experimental analyses on fatigue properties of corroded prestressing strand.” J. Harbin Eng. Univ. 35 (12): 1–7. https://doi.org/10.3969/ji.ssn.10067-043.2013.08.054.
Zhang, C., Y. Chen, and W. Yao. 2014. “The use of fractal dimensions in the prediction of residual fatigue life of pre-corroded aluminum alloy specimens.” Int. J. Fatigue 59: 282–291. https://doi.org/10.1016/j.ijfatigue.2013.08.008.
Zhang, W., S. Li, and X. Gu. 2009. “Experiment on axial tensile fatigue of naturally corroded steel bar.” China J. Highway Transp. 22 (2): 53–58.
Zhang, W., D. Shang, and X. Gu. 2006. “Stress-strain relationship of corroded steel bars.” J. Tongji Univ. 34 (5): 586–592. https://doi.org/10.3321/j.issn:0253-374X.2006.05.004.
Zhang, Y., and W. Guan. 2011. “Empirical study of fractal characteristics of traffic time series.” J. Highway Transp. Res. Dev. (English Ed.) 5 (2): 110–114. https://doi.org/10.1061/JHTRCQ.0000074.
Information & Authors
Information
Published In
Copyright
©2018 American Society of Civil Engineers.
History
Received: Jul 4, 2017
Accepted: Mar 13, 2018
Published online: Jul 3, 2018
Published in print: Sep 1, 2018
Discussion open until: Dec 3, 2018
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.