Effects of Polyacrylamide on the Consolidation Behavior of Dredged Clay
Publication: Journal of Materials in Civil Engineering
Volume 30, Issue 3
Abstract
Dealing with dredged clay with high water content has become a difficult issue in recent years. The admixture addition of polyacrylamide (PAM) to dredged clay to improve its poor engineering properties has become a trend. This study presents a laboratory investigation of the effects of the addition of polyacrylamide on the consolidation behavior of dredged clay. A series of oedometer tests was conducted on PAM specimens in both normally consolidated (NC) and overconsolidated (OC) states. The test results show that in the NC state, the weak engineering properties of dredged clay were improved by the PAM addition. The initial water content of the samples with PAM after filtration tests decreased by 45% compared to natural samples without PAM. The structural yield stress and coefficient of consolidation of samples with PAM were two times higher than those of untreated samples. A predictable model of the coefficient of secondary compression was obtained for Tianjin Binhai dredged clay. In the OC state, the coefficient of consolidation decreased with the increase in PAM content. An overconsolidation ratio (OCR) of 2.0 is the threshold value for evaluating the critical settlement between primary and secondary compression. The coefficient of secondary compression decreased linearly with increasing OCR and a linear model for predicting secondary compression is proposed. The addition of PAM can be beneficial ( for Tianjin Binhai dredged clay) to accelerate the consolidation process, reduce secondary compression, and reduce project costs.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
The authors would like to acknowledge the National Natural Science Foundation of China (NSFC) (Grant Nos. 51578371 and 51378344), the Tianjin Research Program of Application Foundation and Advanced Technology (Grant No. 14JCYBJC21700), and Beijing-Tianjin-Hebei Special Projects of Cooperation (Grant No. 16JCJDJC40000) for their financial support.
References
ASTM. (2011a). “Standard practice for classification of soils for engineering purposes (Unified Soil Classification System).” ASTM D2487, West Conshohocken, PA.
ASTM. (2011b). “Standard test methods for one-dimensional consolidation properties of soils using incremental loading.” ASTM D2435-11, West Conshohocken, PA.
Bhardwaj, A. K., McLaughlin, R. A., and Levy, G. J. (2010). “Depositional seals in polyacrylamide-amended soils of varying clay mineralogy and texture.” J. Soils Sediments, 10(3), 494–504.
Bishop, M. D. (2013). “Strength and deformation of ‘tunable’ clay-polymer composites.” M.S. thesis, Univ. of Tennessee, Knoxville, TN.
Cai, Y. Q., Wang, J., Ma, J., Wang, P., and Fu, H. (2016). “A new method to improve the effectiveness of vacuum preloading on the consolidation of dredged fill in Wenzhou.” Jpn. Geotech. Soc. Spec. Publ., 2(51), 1794–1797.
Casagrande, A., and Fadum, R. E. (1940). Notes on soil testing for engineering purposes, Harvard Univ., Cambridge, MA.
Chai, J. C., Carter, J. P., and Hayashi, S. (2005). “Ground deformation induced by vacuum consolidation.” J. Geotech. Geoenviron. Eng., 1552–1561.
Coduto, D. P. (1999). Geotechnical engineering: Principles and practice, Prentice-Hall, Upper Saddle River, NJ.
Consoli, N. C., Dalla, R. A., Corte, M. B., Lopes, J. L. D. S., and Consoli, B. S. (2011). “Porosity-cement ratio controlling strength of artificially cemented clays.” J. Mater. Civ. Eng., 1249–1254.
Consoli, N. C., Samaniego, R. A. Q., and Villalba, N. M. K. (2016). “Durability, strength, and stiffness of dispersive clay-lime blends.” J. Mater. Civ. Eng., 04016124.
Deng, Y. F., Liu, S. Y., Huang, J. A., Li, K., Du, Y. J., and Jing, F. (2012). “Strength and permeability of cemented soil with PAM.” Proc., 4th Int. Conf. on Grouting and Deep Mixing, Deep Foundations Institute, Hawthorne, NJ.
Ghobadi, M. H., Abdilor, Y., and Babazadeh, R. (2014). “Stabilization of clay soils using lime and effect of pH variations on shear strength parameters.” Bull. Eng. Geol. Environ., 73(2), 611–619.
Green, V. S., and Stott, D. E. (2001). “Polyacrylamide: A review of the use, effectiveness, and cost of a soil erosion control amendment.” 10th Int. Soil Conservation Organizational Meeting, International Soil Conservation Organization, Honolulu.
Kang, G., Tsuchida, T., and Athapaththu, A. M. R. G. (2016). “Engineering behavior of cement-treated marine dredged clay during early and later stages of curing.” Eng. Geol., 209, 163–174.
Kim, S., and Palomino, A. M. (2009). “Polyacrylamide-treated kaolin: A fabric study.” Appl. Clay Sci., 45(4), 270–279.
Kjellman, W. (1952). “Consolidation of clay by means of atmospheric pressure.” Proc., Conf. on Soil Stabilization, MIT Press, Cambridge, MA, 258–263.
Kumar, A., and Gupta, D. (2016). “Behavior of cement-stabilized fiber-reinforced pond ash, rice husk ash-soil mixtures.” Geotext. Geomembr., 44(3), 466–474.
Li, L. H., Wang, Q., Wang, N. X., and Wang, J. P. (2009). “Vacuum dewatering and horizontal drainage blankets: A method for layered soil reclamation.” Bull. Eng. Geol. Environ., 68(2), 277–285.
Li, Z., Liu, K., Cheng, X., and Guo, X. (2015). “Research on the influence of K-PAM on the microstructure of cement slurry.” Adv. Cem. Res., 27(9), 526–531.
Mesri, G., and Khan, A. Q. (2012). “Ground improvement using vacuum loading together with vertical drains.” J. Geotech. Geoenviron. Eng., 680–689.
Rekik, B., and Boutouil, M. (2009). “Geotechnical properties of dredged marine sediments treated at high water/cement ratio.” Geo-Mar. Lett., 29(3), 171–179.
Saowapakpiboon, J., Bergado, D. T., Voottipruex, P., Lam, L. G., and Nakakuma, K. (2011). “PVD improvement combined with surcharge and vacuum preloading including simulations.” Geotext. Geomembr., 29(1), 74–82.
Seybold, C. A. (1994). “Polyacrylamide review: Soil conditioning and environmental fate.” Commun. Soil Sci. Plant Anal., 25(11–12), 2171–2185.
Sharma, R. S., Phanikumar, B. R., and Rao, B. V. (2008). “Engineering behavior of a remolded expansive clay blended with lime, calcium chloride, and rice-husk ash.” J. Mater. Civ. Eng., 509–515.
Shen, S. L., Cui, Q. L., Ho, E. C., and Xu, Y. S. (2016). “Ground response to multiple parallel microtunneling operations in cemented silty clay and sand.” J. Geotech. Geoenviron. Eng., 04016001.
Shen, S. L., Wang, J. P., Wu, H. N., Xu, Y. S., Ye, G. L., and Yin, Z. Y. (2015). “Evaluation of hydraulic conductivity for both marine and deltaic deposit based on piezocone test.” Ocean. Eng., 110(2015), 174–182.
Shen, S. L., Wang, Z. F., and Cheng, W. C. (2017). “Estimation of lateral displacement induced by jet grouting in clayey soils.” Geotechnique, 67(7), 621–630.
Shen, S. L., Wang, Z. F., Yang, J., and Ho, E. C. (2013). “Generalized approach for prediction of jet grout column diameter.” J. Geotech. Geoenviron. Eng., 2060–2069.
Shen, S. L., Wu, H. N., Cui, Y. J., and Yin, Z. Y. (2014). “Long-term settlement behavior of the metro tunnel in Shanghai.” Tunnelling Underground Space Technol., 40(2014), 309–323.
Shen, S. L., and Xu, Y. S. (2011). “Numerical evaluation of land subsidence induced by groundwater pumping in Shanghai.” Can. Geotech. J., 48(9), 1378–1392.
Taylor, D. W. (1942). Research on consolidation of clays, Massachusetts Institute of Technology, Cambridge, MA.
Wang, D., Abriak, N. E., and Zentar, R. (2013). “Strength and deformation properties of Dunkirk marine sediments solidified with cement, lime and fly ash.” Eng. Geol., 166, 90–99.
Wang, J., Ma, J., Wang, P., and Fu, H. (2016). “A new method to improve the effectiveness of vacuum preloading on the consolidation of dredged fill in Wenzhou.” Jpn. Geotech. Soc. Spec. Publ., 2(51), 1794–1797.
Wareham, D. G., and Mackechnie, J. R. (2006). “Solidification of New Zealand harbor sediments using cementitious materials.” J. Mater. Civ. Eng., 311–315.
Wu, H. N., Shen, S. L., Liao, S. M., and Yin, Z. Y. (2015a). “Longitudinal structural modelling of shield tunnels considering shearing dislocation between segmental rings.” Tunnelling Underground Space Technol., 50(2015), 317–323.
Wu, H. N., Shen, S. L., Ma, L., Yin, Z. Y., and Horpibulsuk, S. (2015b). “Evaluation of the strength increase of marine clay under staged embankment loading: A case study.” Mar. Georesour. Geotech., 33(6), 532–541.
Wu, Y. X., Shen, S. L., and Yuan, D. J. (2016). “Characteristics of dewatering induced drawdown curve under barrier effect of retaining wall in aquifer.” J. Hydrol., 539(2016), 554–566.
Xia, B., Cao, Y. P., Wang, Z. F., Ding, G. Q., and Lei, G. H. (2017). “Effect of super-absorbent polymer on the undrained shear behavior of cemented dredged clay with high water content.” J. Mater. Civ. Eng., 04017023.
Xu, Y. S., Shen, S. L., Ren, D. J., and Wu, H. N. (2016). “Factor analysis of land subsidence in Shanghai: A view based on strategic environmental assessment.” Sustainability, 8(6), 573.
Zhang, N., Shen, S. L., Wu, H. N., Chai, J. C., and Yin, Z. Y. (2015). “Evaluation of effect of basal geotextile reinforcement under embankment loading on soft marine deposits.” Geotext. Geomembr., 43(6), 506–514.
Zhang, R. J., Santoso, A. M., Tan, T. S., and Phoon, K. K. (2013). “Strength of high water-content marine clay stabilized by low amount of cement.” J. Geotech. Geoenviron. Eng., 2170–2181.
Zhao, H., Liu, J., Guo, J., Zhao, C., and Gong, B. W. (2014). “Reexamination of lime stabilization mechanisms of expansive clay.” J. Mater. Civ. Eng., 04014108.
Information & Authors
Information
Published In
Journal of Materials in Civil Engineering
Volume 30 • Issue 3 • March 2018
Copyright
©2018 American Society of Civil Engineers.
History
Received: Apr 15, 2017
Accepted: Sep 13, 2017
Published online: Jan 12, 2018
Published in print: Mar 1, 2018
Discussion open until: Jun 12, 2018
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.