Performance Characterization of Half Warm Mix Asphalt Using Foaming Technology
Publication: Journal of Materials in Civil Engineering
Volume 25, Issue 3
Abstract
The objective of this study was to evaluate the moisture susceptibility, rutting, and fatigue resistance of laboratory-made half warm mix asphalt (HWMA) mixtures containing moist aggregates and recycled materials such as manufactured roofing shingles and reclaimed asphalt pavement (RAP). The test properties evaluated in this study included weight loss (%), indirect tensile strength (ITS), tensile strength ratio (TSR), wet flow, wet toughness, percent toughness loss, rut depth of dry and wet conditioned specimens, rut index, and beam fatigue life. The experimental design in this study included the use of foaming technology and three hydrated lime contents (0, 1, and 2% by weight of aggregate), three aggregate sources (designated as A, B, and C), three fractioned RAP sources from the same aggregate sources, and one PG 64-22 binder. A total of 27 mixtures was designed, and a total of 120 ITS samples, 162 asphalt pavement analyzer (APA) samples, and 36 fatigue beams were tested in this study. Results indicated that the addition of recycled materials such as RAP or roofing shingles can be effectively employed in HWMA mixtures, which did not reduce wet ITS and TSR values, although the compaction temperature was only 85°C. The influence of the moist aggregate used in HWMA on rut depth can be neglected and even results in a better rut resistance when incorporating recycled materials. Stiffness values of mixtures with recycled materials were generally dependent on the aggregate type. Based on the statistical analysis for the selected aggregates, no significant difference in fatigue life was observed for mixtures with recycled materials and control mixtures.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
The authors would like to acknowledge the support of the Civil Engineering Department Chair, Dr. Nadim M. Aziz for his challenge to the authors to address more sustainable asphalt paving technologies that are based on scientific evidence. Financial support was made through a grant from South Carolina’s Department of Health and Environment Control (SCDHEC) through the Asphalt Rubber Technology Service (ARTS) of the Glenn Department of Civil Engineering at Clemson University.
References
AASHTO. (2007a). “Standard method of test for determining the fatigue life of compacted hot mix asphalt (HMA) subjected to repeated flexural bending.” T321, Washington, DC.
AASHTO. (2007b). “Standard method of test for resistance of compacted hot mix asphalt (HMA) to moisture-induced damage.” T283, Washington, DC.
AASHTO. (2010). “Standard method of test for determining the rutting susceptibility of hot mix asphalt (APA) using the asphalt pavement analyzer (APA).” T340-10, Washington, DC.
Anderson, R. M., Turner, P. A., Perterson, R. L., and Mallick, R. B. (2002). “Relationship of superpave gyratory compaction properties to HMA rutting behavior.”, Transportation Research Board, Washington, DC.
Bennert, T., Maher, A., and Sauber, R. (2011). “Influence of production temperature and aggregate moisture content on the performance of warm mix asphalt (WMA).”, Transportation Research Board, Washington, DC.
Cooper, S. B., III, Mohammad, L. N., and Elseifi, M. A. (2011). “Laboratory performance characteristics of sulfur-modified warm-mix asphalt.” J. Mater. Civ. Eng., 23(9), 1338–1345.
Copeland, A., Jones, C., and Bukowski, J. (2010). “Reclaiming roads.”, Vol. 73, No. (5), Federal Highway Administration, McLean, VA.
Gaudefroy, V., Olard, F., Cazacliu, B., de La Roche, C., Beduneau, E., and Antoine, J. P. (2007). “Laboratory investigations of mechanical performance of foamed bitumen mixes that use half-warm aggregates.”, Transportation Research Board, Washington, DC.
Jenkins, K. J., Molenaar, A. A. A., de Groot, J. L. A., and van de Ven, M. F. C. (2002). “Foamed asphalt produced using warmed aggregates.” J. Assoc. Asphalt Paving Technol., 71, 468–492.
National Asphalt Pavement Association (NAPA). (2000). “Recycling practices for HMA.”, NAPA, Lanham, MD.
Prowell, B. D., Hurley, G. C., and Crews, E. (2007). “Field performance of warm-mix asphalt at National Center for Asphalt Technology test track.”, Transportation Research Board, Washington, DC.
Punith, V. S., Xiao, F., and Amirkhanian, S. N. (2011a). “Performance of warm mix asphalt mixtures containing recycled coal ash and roofing shingles with moist aggregates for low volume roads.”, Transportation Research Board, Washington, DC.
Punith, V. S., Xiao, F., and Amirkhanian, S. N. (2011b). “Effects of moist aggregates on the performance of warm mix asphalt mixtures containing non-foaming additives.” J. Test. Eval., 39(5), 847–857.
Romier, A., Audéon, M., David, J., Martineau, Y., and Olard, F. (2006). “Low-energy asphalt with performance of hot-mix asphalt.”, Transportation Research Board, Washington, DC.
Soenen, H., De Visscher, J., Vervaecke, F., Vanelstraete, A., and Redelius, P. (2010). “Foamed bitumen in half-warm asphalt: A laboratory study.” Int. J. Pavement Res. Technol., 3(4), 199–206.
United States Department of Transportation. (2005). “Warm mix asphalt technologies and research.” Federal Highway Administration, 〈http://www.fhwa.dot.gov/pavement/asphalt/wma.cfm〉 (Dec. 5, 2011).
USGS. (2012). “South Carolina geology.” Mineral resources online spatial data, Reston, VA, 〈http://www.mrdata.usgs.gov/sgmc/sc.html〉 (Dec. 1, 2011).
Van De Ven, M. F. C., Jenkins, K. J., Voskuilen, J. L. M., and Van Den Beemt, R. (2007). “Development of (half) warm foamed bitumen mixes: State of the art.” Int. J. Pavement Eng., 8(2), 163–175.
Xiao, F., Amirkhanian, S. N., and Putman, B. J. (2010). “Evaluation of rutting resistance in warm mix asphalts containing moist aggregate.”, Transportation Research Board, Washington, DC.
Xiao, F., Jordan, J., and Amirkhanian, S. N. (2009). “Laboratory investigation of moisture damage in warm-mix asphalt containing moist aggregate.”, Transportation Research Board, Washington, DC.
Xiao, F., Punith, V. S., Putman, B., and Amirkhanian, S. N. (2011). “Utilization of foaming technology in warm mix asphalt mixtures containing moist aggregates.” J. Mater. Civ. Eng., 23(9), 1328–1337.
Information & Authors
Information
Published In
Copyright
© 2013 American Society of Civil Engineers.
History
Received: Dec 14, 2011
Accepted: May 22, 2012
Published online: May 24, 2012
Published in print: Mar 1, 2013
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.