Investigations on Pastes and Mortars of Ordinary Portland Cement Admixed with Wollastonite and Microsilica
Publication: Journal of Materials in Civil Engineering
Volume 22, Issue 4
Abstract
Wollastonite is abundantly available in Rajasthan, Tamil Nadu, Uttarakhand, and Andhra Pradesh states of the Indian Union as a low-cost material. In this study, investigations were made on pastes and mortars to evaluate its potential as a new material for admixing with ordinary portland cement with or without microsilica. Its physical and chemical properties were analyzed. Wollastonite consists of 45.6% of CaO and 48% of , mostly in amorphous form. It has an average specific surface area of and retention on 45-micron sieve of 3.20%. When ground to fine powder, it attains an average particle size of 4 microns which is about 4.5 times finer than ordinary portland cement. Scanning electron microscope images show that wollastonite particles were solid, acicular in shape, and have rough surfaces. Several cementitious mix proportions of ordinary portland cement, wollastonite, and microsilica were investigated for normal consistency, initial and final setting time of paste, and compressive strength of mortar. Test results indicate that the mortar, which contains 82.5% cement, 10% wollastonite, and 7.5% microsilica, as cementitious material attains the highest compressive strength. The mortar, which contains 77.5% cement, 15% wollastonite, and 7.5% microsilica, as cementitious material achieves compressive strength higher than the conventional OPC mortar along with rendering maximum cement replacement for better economy of concrete work. It was observed that the compressive strength of mortar varied logarithmically with the days of moist curing and linearly with the proportion of admixing. Suitable predictive models are presented accordingly.
Get full access to this article
View all available purchase options and get full access to this article.
References
American Concrete Institute (ACI). (2000). “ACI 232.2R use of flyash in concrete.” ACI 232.2R, Detroit.
ASTM. (2004). “Standard test method for normal consistency of hydraulic cement.” C187, West Conshohocken, Pa.
ASTM. (2007). “Standard specification for portland cement.” C150, West Conshohocken, Pa.
ASTM. (2008a). “Standard test methods for time of setting of hydraulic cement by Vicat needle.” C191, West Conshohocken, Pa.
ASTM. (2008b). “Standard specification for coal fly ash and raw or calcined natural pozzolan for use in concrete.” C618, West Conshohocken, Pa.
Babu, K. G., and Prakash, P. V. S. (1995). “Efficiency of silica fume in concrete.” Cem. Concr. Res., 25(6), 1273–1283.
Bentz, D. P., and Stutzman, P. E. (1994). “Evolution of porosity and calcium hydroxide in laboratory concretes containing silica fume.” Cem. Concr. Res., 24(6), 1044–1050.
Bonen, D., and Khayat, K. H. (1995). “Characterization and pozzolanic properties of silica fume stored in an open pond.” Cem. Concr. Res., 25(2), 395–407.
Chai, J., and Boonmark, R. (2003). “Cementing material from calcium carbide residue-rice husk ash.” J. Mater. Civ. Eng., 15(5), 470–475.
Cheng-yi, H., and Feldman, R. F. (1985). “Hydration reactions in portland cement-silica fume blends.” Cem. Concr. Res., 15(4), 585–592.
Cohen, M. D. (1990). “A look at silica fume and its actions in portland cement concrete.” Indian Concr. J., 64(9), 429–438.
Cohen, M. D., and Klitsika, M. (1986). “Mechanisms of hydration and strength developments in portland cement composites containing silica fume particles.” Indian Concr. J., 60(11), 296–299.
Feldman, R. F., and Cheng-yi, H. (1985). “Properties of portland cement silica fume pastes: II. Mechanical properties.” Cem. Concr. Res., 15(6), 943–952.
Ganesan, K., Rajagopal, K., and Thangavel, K, (2007). “Rice hush ash blended cement: Assessment of optimal level of replacement for strength and permeability properties of concrete.” Constr. Build. Mater., 22(8), 1675–1683.
Kenai, S., Soboyejo, W., and Soboyejo, A. (2004). “Some engineering properties of limestone concrete.” Mater. Manuf. Processes, 19(5), 949–961.
Larbi, J. J., Fraay, A. L. A., and Bijen, J. M. J. M. (1990). “The chemistry of the pore fluid of silica fume-blended cement systems.” Cem. Concr. Res., 20(4), 506–516.
Malhotra, V. M., Ramachandran, V. S., Feldman, R. F., and Aitcin, P. C. (1987). Condensed silica fume in concrete, CRC, Boca Raton, Fla.
Massazza, F. (1993). “Pozzolanic cements.” Cem. Concr. Compos., 15(4), 185–214.
Mathur, R., Mishra, A. K., and Goel, P. (2007). “Marble slurry dust and wollastonite inert mineral admixtures for cement concrete.” Indian Highways, 35(12), 41–46.
Mehta, P. K. (1981). “Studies on blended portland cements containing Santorin earth.” Cem. Concr. Res., 11(4), 507–518.
Monteiro, P. J. M., and Mehta, P. K. (1986). “Improvement of the aggregate cement paste transition zone by grain refinement of hydration product.” Proc., 8th Int. Congress on the Chemistry of Cement, Vol. 2, Rio de Janeiro, Brazil, 433–437.
Neville, A. M. (1995). Properties of concrete, 4th Ed., Pearson Education, Inc., and Dorling Kindersley Publishing, Inc., New Delhi, India.
Paul, F. K. (1977). “Mineral descriptions—Wollastonite. Optical mineralogy, 4th Ed., McGraw-Hill, New York.
Ramachandran, V. S., Feldman, R. F., and Beaudoin, J. J. (1981). The system CaO– . Concrete science: Treatise on concurrent research, Heyden & Son, London.
Ransinchung, G. D., Kumar, B., and Kumar, V. (2009). “Assessment of water absorption and chloride ion penetration of pavement quality concrete admixed with wollastonite and microsilica.” Constr. Build. Mater., 23(2), 1168–1177.
Rao, G. A. (2003). “Investigations on the performance of silica fume-incorporated cement pastes and mortars.” Cem. Concr. Res., 33(11), 1765–1770.
Tagnit-Hamou, A., Pertove, N., and Luke, K. (2003). “Properties of concrete containing diatomaceous earth.” ACI Mater. J., 100(1), 73–78.
Temiz, H., Kose, M. M., and Koksal, S. (2007). “Effects of portland composite and composite cements on durability of mortar and permeability of concrete.” Constr. Build. Mater., 21(6), 1170–1176.
Uzal, B., and Turanli, L. (2003). “Studies on blended cements containing a high volume of natural pozzolans.” Cem. Concr. Res., 33(11), 1777–1781.
Wolkem India Limited. (2003). Leaders in wollastonite and calcite, “From mines to market,” Wolkem India Ltd., Udaipur, India.
Zhang, M. H., Lastra, R., and Malhotra, V. M. (1996). “Rice husk ash paste and concrete: Some aspects of hydration and the microstructure of the interfacial zone between the aggregate and the paste.” Cem. Concr. Res., 26(6), 963–977.
Information & Authors
Information
Published In
Copyright
© 2010 ASCE.
History
Received: Oct 15, 2008
Accepted: May 18, 2009
Published online: May 19, 2009
Published in print: Apr 2010
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.