Numerical and Experimental Analysis for the Interlayer Behavior of Double-Layered Asphalt Pavement Specimens
Publication: Journal of Materials in Civil Engineering
Volume 23, Issue 1
Abstract
Bonding characteristics between pavement layers have an important influence on responses of pavement structures. This paper deals with this subject by analyzing the interlayer behavior of double-layered asphalt (DLA) specimens taken from an in-service motorway using a coaxial shear test (CAST) and a layer-parallel direct shear (LPDS) test. To analyze and model the influence of the interlayer condition, finite-element simulations of CAST DLA specimens were conducted. In the models, both idealized fully bonded and no-bonding assumptions were used to characterize the interlayer behavior of DLA specimens. Experimental results presented for CAST and LPDS tests demonstrate that there is a strong influence of temperature in the interlayer bonding mechanism. At lower temperatures, there is an increase on the bonding strength produced by the binder stiffening and aggregate interlocking. Further, it was observed that comparisons of CAST experimental and numerical results indicate that the interlayer can be close to the fully bonded condition at low temperatures below while the interlayer, at higher temperatures, behaves between fully bonded and no-bonding idealized conditions.
Get full access to this article
View all available purchase options and get full access to this article.
References
Canestrari, F., Ferrotti, G., Partl, M. N., and Santagata, F. (2005). “Advanced testing and characterization of interlayer shear resistance.” Transp. Res. Rec., 1929, 68–78.
Canestrari, F., and Santagata, E. (2005). “Temperature effects on the shear behaviour of tack coat emulsions used in flexible pavements.” Int. J. Pavement Eng., 6(1), 39–46.
Khweir, K., and Fordyce, D. (2003). “Influence of layer bonding on the prediction of pavement life.” Proc., Institution of Civil Engineers-Transport, 156(2), 73–83.
Kim, H., and Buttlar, W. G. (2009a). “Finite-element cohesive fracture modeling of airport pavements at low temperature.” Cold Regions Sci. Technol., 57(2–3), 123–130.
Kim, H., and Buttlar, W. G. (2009b). “Discrete fracture modeling of asphalt concrete.” Int. J. Solids Struct., 46(13), 2593–2604.
Kruntcheva, M. R., Collop, A. C., and Thom, N. H. (2006). “Properties of asphalt concrete layer interfaces.” J. Mater. Civ. Eng., 18(3), 467–471.
Leutner, R. (1979). “Untersuchungen des schichtenverbunds beim bituminösen Oberbau.” Bitumen, 3, 84–91.
Mohammad, L. N., Raqib, M. A., Wu, Z., and Huang, B. (2002). “Measurement of interlayer bond strength through shear tests.” Proc., 3rd Int. Conf. Bituminous Mixtures and Pavements, Thessaloniki, Greece.
Partl, M. N., Canestrari, F., Grilli, A., and Gubler, R. (2008). “Characterization of water sensitivity of asphalt mixtures with coaxial shear test.” Road materials and pavement design, Vol. 9, Hermes Science Publications, 247–278.
Partl, M. N., and Fritz, H. W. (1997). “Do superpave binder tests reflect long term pavement performance better than traditional tests?” Proc., 8th Int. Conf. on Asphalt Pavements, Vol. 2, ISAP, Seattle, 1279–1288.
Partl, M. N., and Raab, C. (1999). “Shear adhesion between top layers of fresh asphalt pavements in Switzerland. ” Proc., 7th CAPSA Conf. on Asphalt Pavements for Southern Africa, Victory Falls, Zimbabwe.
Raab, C., and Partl, M. N. (1998). “Shear strength properties between asphalt pavement layers.” Archives of Civil Engineering, XLIV(3), 353–366.
Raab, C., and Partl, M. N. (1999). “Methoden zur beurteilung des schichtenverbunds von asphaltbelägen.” ASTRA-Project FA 12/94, Rep. No. 442-118, ASTRA Swiss Road Authority.
Raab, C., and Partl, M. N. (2008). “Investigation on long-term interlayer bonding of asphalt pavements.” The Baltic Journal of Road and Bridge Engineering, 3(2), 65–70.
Romanoschi, S. A., and Metcalf, J. B. (2001). “Characterization of asphalt concrete layer interfaces.” Transp. Res. Rec., 1778, 132–139.
Santagata, F. A., Partl, M. N., Ferrotti, G., Canestrari, F., and Flisch, A. (2008). “Layer characteristics affecting interlayer shear resistance in flexible pavements.” J. Assoc. Asph. Paving Technol., 77, 221–254.
Sokolov, K., Gubler, R., and Partl, M. N. (2005). “Extended numerical modeling and application of the coaxial shear test for asphalt pavements.” Mater. Struct., 279, 515–522.
Stöckert, U. (2001). “Schichtenverbund—Prüfung und bewertungshintergrund.” Str. Autob., 11, 324–631.
Uzan, J., Livneh, M., and Eshed, Y. (1978). “Investigation of adhesion properties between asphaltic-concrete layers.” Proc., Annual Meeting of the Association of Asphalt Paving Technologists, Vol. 47, 495–521.
West, R. C., Zhang, J., and Moore, J. (2005). “Evaluation of bond strength between pavement layers.” NCAT Rep. No. 05-08, National Center for Asphalt Technology, Auburn University, Auburn, Ala.
Witczak, M. W., Andrei, D., and Mirza, W. (1999). “Development of revised predictive model for the dynamic (complex) modulus of asphalt mixtures.” Inter-team Technical Rep., NCHRP Project No. 1-37A, Univ. of Maryland, Md.
Information & Authors
Information
Published In
Copyright
© 2011 ASCE.
History
Received: Apr 9, 2009
Accepted: Oct 9, 2009
Published online: Feb 5, 2010
Published in print: Jan 2011
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.