Three-Dimensional Numerical Modeling of Urban Green Stormwater Infrastructure Curb Inlets
Publication: Journal of Irrigation and Drainage Engineering
Volume 147, Issue 9
Abstract
The current equations for curb inlet opening sizing often inaccurately estimate the capture efficiency of small urban green stormwater infrastructure (GSI) curb inlets. Most of these equations are based on studies with openings much larger than typical urban GSI curb inlets (i.e., less than 0.6 m). This study introduces a new, three-dimensional (3D) numerical approach for evaluating curb efficiency using the ANSYS Fluent computational fluid dynamics (CFD) model that can be applied to a wide range of curb inlet conditions. Simulated curb efficiency results for typical urban curb inlet openings are verified by laboratory experiments of field-scale conditions. A high prediction accuracy is obtained (Nash-Sutcliffe efficiency ) between the observed and the CFD model results. The CFD model also performs better than three commonly used methods for estimating curb inlet efficiency; the Hydraulic Engineering Circular No. 22, and the 2009 and 2012 Comport and Thornton equations. The high level of accuracy observed in this study makes 3D CFD modeling a more effective alternative to existing equations for evaluating GSI curb inlet efficiency. The quick simulation times realized in this study also demonstrate that CFD modeling of GSI inlets has an added benefit of quickly evaluating several design alternatives without a need for costly full-scale or on-site testing often performed to assess such inlets.
Get full access to this article
View all available purchase options and get full access to this article.
Data Availability Statement
All data, models, or code that support the findings of this study are available from the corresponding author upon reasonable request.
Acknowledgments
This research was partially funded by the Philadelphia Water Department as part of the of the Green City Clean Waters Research Center (GCCWRC) project. The authors would like to thank Dr. Gerald Zaremba for assisting with setting up the laboratory experiments and Madhat Fares for assisting with running the experiments.
Disclaimer
The opinions presented in this publication are those of the authors and do not necessarily express the opinions of the Philadelphia Water Department. Reference in this report to any commercial product, process, or service, or the use of any trade, firm, or corporation name is for general informational purposes only and does not constitute an endorsement or certification of any kind by the authors. This project is a research initiative of the Villanova Center for Resilient Water Systems.
References
Agrawal, S. K., W. E. Meyer, and J. J. Henry. 1977. “Measurement of hydroplaning potential.” Accessed May 7, 2020. http://onlinebooks.library.upenn.edu/webbin/book/lookupid?key=ha005469982.
ANSYS. 2017. ANSYS (R) workbench, release 18.1, ANSYS documentation. Canonsburg, PA: ANSYS.
Baker, C., D. Flynn, H. Hemida, A. Quinn, D. Soper, and M. Sterling. 2019. “Computational techniques.” In Train aerodynamics; fundamentals and applications, 53–71. Amsterdam, Netherlands: Elsevier.
Bauer, W. J., and D. C. Woo. 1964. “Hydraulic design of depressed curb opening inlets.” Highway Res. Rec. 58: 61–80.
Bazin, P. H., H. Nakagawa, K. Kawaike, A. Paquier, and E. Mignot. 2014. “Modeling flow exchanges between a street and an underground drainage pipe during urban floods.” J. Hydraul. Eng. 140 (10): 04014051. https://doi.org/10.1061/(ASCE)HY.1943-7900.0000917.
Brown, S. A., J. D. Schall, J. L. Morris, C. L. Doherty, S. M. Stein, and J. C. Warner. 2013. Urban drainage design manual hydraulic engineering circular 22. 3rd ed. Washington, DC: USDOT, Federal Highway Administration.
Burgi, P. H., and D. E. Gober. 1978. “Hydraulic and safety characteristics of selected grate inlets.” Transp. Res. Rec. 685: 29–31.
Charbeneau, R. J., J. Jeong, and M. E. Barrett. 2009. “Physical modeling of sheet flow on rough impervious surfaces.” J. Hydraul. Eng. 135 (6): 487–494. https://doi.org/10.1061/(ASCE)HY.1943-7900.0000043.
City of Detroit. 2018. “Stormwater management design manual.” Accessed May 9, 2020. https://detroitmi.gov/sites/detroitmi.localhost/files/2018-11/StormwaterMgmtDesignManual2018-11.pdf.
Comport, B., C. I. Thornton, and A. L. Cox. 2009. Hydraulic efficiency of grate and curb inlets for urban storm drainage. Fort Collins, CO: Colorado State Univ.
Comport, B. C., and C. I. Thornton. 2012. “Hydraulic efficiency of grate and curb inlets for urban storm drainage.” J. Hydraul. Eng. 138 (10): 878–884. https://doi.org/10.1061/(ASCE)HY.1943-7900.0000552.
Fang, X., S. Jiang, and S. R. Alam. 2010. “Numerical simulations of efficiency of curb-opening inlets.” J. Hydraul. Eng. 136 (1): 62–66. https://doi.org/10.1061/(ASCE)HY.1943-7900.0000131.
Forbes, H. J. C. 1976. “Capacity of lateral stormwater inlets.” Civ. Eng. South-Africa 18 (9): 195–205.
Hammond, M. J., A. S. Chen, S. Djordjević, D. Butler, and O. Mark. 2015. “Urban flood impact assessment: A state-of-the-art review.” Urban Water J. 12 (1): 14–29. https://doi.org/10.1080/1573062X.2013.857421.
Hammonds, M. A., and E. R. Holley. 1995. Hydraulic characteristics of flush depressed curb inlets and bridge deck drains. No. Phase 2. Austin, TX: Univ. of Texas at Austin.
He, C., J. Wood, J. Marsalek, and Q. Rochfort. 2008. “Using CFD modeling to improve the inlet hydraulics and performance of a storm-water clarifier.” J. Environ. Eng. 134 (9): 722–730. https://doi.org/10.1061/(ASCE)0733-9372(2008)134:9(722).
Hirt, C. W., and B. D. Nichols. 1981. “Volume of fluid (VOF) method for the dynamics of free boundaries.” J. Comput. Phys. 39 (1): 201–225. https://doi.org/10.1016/0021-9991(81)90145-5.
Izzard, C. F. 1946. “Hydraulics of runoff from developed surfaces.” In Vol. 26 of Proc., 26th Annual Meeting of Highway Research Board, 129–150. Washington, DC: Highway Research Board.
Izzard, C. F. 1950. Tentative results on capacity of curb opening inlets. Washington, DC: Highway Research Board.
Jeong, J., and R. J. Charbeneau. 2010. “Diffusion wave model for simulating storm-water runoff on highway pavement surfaces at superelevation transition.” J. Hydraul. Eng. 136 (10): 770–778. https://doi.org/10.1061/(ASCE)HY.1943-7900.0000253.
Karthik, R., U. Kumar, and A. K. Barbhuiya. 2019. “Two-dimensional analysis of flow field and associated scour parameters at downstream of weir with and without sloping apron.” Int. J. Eng. Adv. Technol. 8 (6): 1027–1036. https://doi.org/10.35940/ijeat.F8285.088619.
Launder, B. E., and B. I. Sharma. 1974. “Application of the energy dissipation model of turbulence to the calculation of flow near a spinning disc.” Lett. Heat Mass Transfer 1 (2): 131–137. https://doi.org/10.1016/0094-4548(74)90150-7.
Launder, B. E., and D. B. Spalding. 1974. “The numerical computation of turbulent flows.” Comput. Methods Appl. Mech. Eng. 3 (2): 269–289. https://doi.org/10.1016/0045-7825(74)90029-2.
Leschziner, M. A., and B. E. Launder. 1993. “Two-equation models for high-Reynolds-number flow.” In Introduction to the modeling of turbulence, 16. Amsterdam, Netherlands: Elsevier.
Li, W.-H., K. K. Sorteberg, and J. C. Geyer. 1951. “Hydraulic behavior of storm-water inlets: II. Flow into curb-opening inlets.” Sewage Ind. Wastes 23 (6): 722–738.
Li, X., X. Fang, G. Chen, Y. Gong, J. Wang, and J. Li. 2019. “Evaluating curb inlet efficiency for urban drainage and road bioretention facilities.” Water 11 (4): 851. https://doi.org/10.3390/w11040851.
Moody, L. 1944. “Friction factors for pipe flow.” Trans. Am. Soc. Mech. Eng. 66: 671–678.
Pathapati, S., and J. Sansalone. 2007. “Application of computational fluid dynamics (CFD) to stormwater clarification systems.” In Proc., World Environmental and Water Resources Congress 2007, 1–9. Reston, VA: ASCE. https://doi.org/doi:10.1061/40927(243)54.
Philadelphia Water Department. 2018. “Green stormwater infrastructure planning & design manual.” Accessed May 9, 2020. http://documents.philadelphiawater.org/gsi/GSI_Planning_and_Design_Manual.pdf.
Reynolds, O. 1894. On the dynamical theory of incompressible viscous fluids and the determination of the criterion. London: Royal Society.
Russo, B., and M. Gomez. 2014. “Hydraulic efficiency of grate and curb inlets for urban storm drainage.” J. Hydraul. Eng. 140 (1): 121–122. https://doi.org/10.1061/(ASCE)HY.1943-7900.0000759.
Seyoum, S. D., Z. Vojinovic, R. K. Price, and S. Weesakul. 2012. “Coupled 1D and noninertia 2D flood inundation model for simulation of urban flooding.” J. Hydraul. Eng. 138 (1): 23–34. https://doi.org/10.1061/(ASCE)HY.1943-7900.0000485.
Smith, K., M. Kennedy, W. Sarah, J. San Antonio, and W. Robert. 2015. “Hydraulics manual.” Accessed May 9, 2020. https://vtrans.vermont.gov/sites/aot/files/highway/documents/structures/VTransHydraulicsManual.pdf.
Song, Y. H., R. Yun, E. H. Lee, and J. H. Lee. 2018. “Predicting sedimentation in urban sewer conduits.” Water 10 (4): 462. https://doi.org/10.3390/w10040462.
Stoolmiller, S., A. Ebrahimian, B. M. Wadzuk, and S. White. 2021. “Improving the design of curb openings in green stormwater infrastructure.” In Int. Low Impact Development Conf. 2018, 168–175. Reston, VA: ASCE. https://doi.org/doi:10.1061/9780784481783.020.
Uyumaz, A. 1992. “Discharge capacity for curb-opening inlets.” J. Hydraul. Eng. 118 (7): 1048–1051. https://doi.org/10.1061/(ASCE)0733-9429(1992)118:7(1048).
Uyumaz, A. 2002. “Urban drainage with curb-opening inlets.” In Proc., 9th Int. Conf. on Urban Drainage (9ICUD). Beijing: International Association for Hydro-Environment Engineering and Research. https://doi.org/10.1061/40644%282002%29299.
Wilcox, D. C. 1998. Turbulence modeling for CFD. Ananheim, CA: DCW Industries.
Ying, G., S. Pathapati, H. C. Cho, J. Y. Kim, B. Liu, and J. Sansalone. 2013. “Application of a quasi-steady flow CFD model to simulate BMP response.” In Proc., 2013 Congress: World Environmental and Water Resources Congress 2013: Showcasing the Future, 87–98. Reston, VA: ASCE. https://doi.org/10.1061/9780784412947.009.
Ying, G., J. Sansalone, S. Pathapati, G. Garofalo, M. Maglionico, A. Bolognesi, and A. Artina. 2012. “Stormwater treatment: Examples of computational fluid dynamics modeling.” Front. Environ. Sci. Eng. 6 (5): 638–648. https://doi.org/10.1007/s11783-012-0442-7.
Information & Authors
Information
Published In
Copyright
© 2021 American Society of Civil Engineers.
History
Received: Aug 26, 2020
Accepted: Mar 9, 2021
Published online: Jul 13, 2021
Published in print: Sep 1, 2021
Discussion open until: Dec 13, 2021
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.
Cited by
- Hossein Hosseiny, Richard Ampomah, Madhat Fares, Angela Cotugno, Bridget Wadzuk, Virginia Smith, An Ensemble of Methods for Determining the Efficiency of Curb Inlets for Green Stormwater Infrastructure, Journal of Sustainable Water in the Built Environment, 10.1061/JSWBAY.0000998, 9, 1, (2023).
- Jinbing Zhang, Huiru Zhu, Pengyan Zhang, Yongpeng Song, Ying Zhang, Yanyan Li, Tianqi Rong, Zhenyue Liu, Dan Yang, Yuanyuan Lou, Construction of GI Network Based on MSPA and PLUS Model in the Main Urban Area of Zhengzhou: A Case Study, Frontiers in Environmental Science, 10.3389/fenvs.2022.878656, 10, (2022).
- Md Abdullah Al Mehedi, Virginia Smith, Hossein Hosseiny, Xun Jiao, Unraveling the complexities of urban fluvial flood hydraulics through AI, Scientific Reports, 10.1038/s41598-022-23214-9, 12, 1, (2022).