Design of Settling Basins in Irrigation Network Using Simulation and Mathematical Programming
Publication: Journal of Irrigation and Drainage Engineering
Volume 136, Issue 2
Abstract
One of the problems in irrigation structures is sedimentation control in the inlet to the irrigation networks. Water quality for agriculture requires that the sediments be controlled at their entrance point to the networks. This is possible by constructing a settling basin (SB). The bigger the basins, the better the retardation of the sediments but the expenses are higher too. Different mathematical models are developed for SBs. Most of these models show the relationship between efficiency and effective parameters with mathematical formulas. In this research, a computer simulation model was written for calculating the efficiency of a SB. Using this model, another computer program was developed in which design parameters (length, width, depth, slope, and water velocity in the basin) were determined such that the basin has the specified characteristics and minimum construction costs. In this respect, operations research and a lexicographic enumeration algorithm was used. Validation of the computer simulation was performed by applying it to two SBs in Nekouabad diversion dam, west of Isfahan, Iran. The average actual efficiencies of right and left Nekouabad SBs were 31.2 and 36.2%, respectively, while the average calculated efficiencies for right and left SBs were 35.4 and 40.2%, respectively. Application of this program for designing an optimum SB for Nekouabad diversion dam was shown to be promising.
Get full access to this article
View all available purchase options and get full access to this article.
References
Beirami, M. K. (1997). Water conveyance structures, Isfahan University of Technology, Isfahan, Iran.
Bradley, S. P., Hax, A. C., and Magnanti, T. L. (1977). Applied mathematical programming, Addison-Wesley, Reading, Mass.
Camp, T. R. (1943). “The effect of turbulence on retarding settling.” Proc., 2nd Hydraulics Conf., University of Iowa Studies in Engineering, 307–317.
Camp, T. R. (1946). “Sedimentation and the design of settling tanks.” Trans. Am. Soc. Civ. Eng., 111, 895–936.
Cheng, N. S. (1997). “A simplified settling velocity formula for sediment particle.” J. Hydraul. Eng., 123(2), 149–152.
Einstein, H. A. (1968). “Deposition of suspended particles in a gravel bed.” J. Hydr. Div., 94(5), 1197–1205.
Garde, R. J., and Ranga Raju, K. G. (1977). Mechanics of sediment transportation and alluvial stream problems, Wiley, New York.
Garde, R. J., Ranga Raju, K. G., and Sujidi, A. W. R. (1990). “Design of settling basins.” J. Hydraul. Res., 208(1), 81–91.
Gauss for Windows. (2004). Kernel rev. 9.0.0, build 1108, Aptech Systems Inc., Techplot Edge Visualization Software, Bellevue, Wash.
Hazen, A. (1904). “On sedimentation.” Trans. Am. Soc. Civ. Eng., 53, 45–88.
Hsu, N. S., Kuo, J. T., and Chiu, S. K. (2008). “Optimal design of a settling basin for a small-scale drainage area.” J. Irrig. Drain. Eng., 134(3), 372–379.
Jin, Y. S., Guo, Q. C., and Viraraghavan, T. (2000). “Modeling of class-I settling tanks.” J. Environ. Eng., 126(8), 754–760.
Jin, Y. S., Lu, F., and Badruzzaman, Md. (2005). “Simplified model for the class-I settling tanks design.” J. Environ. Eng., 131(12), 1755–1759.
Ming Li, R., and Shen, H. W. (1975). “Solid particle settlement in open-channel flow.” J. Hydr. Div., 101(7), 917–931.
Pemberton, E. L., and Lara, J. M. (1971). “A procedure to determine sediment deposition in a settling basin.” Bureau of Reclamation Sedimentation Investigations Technical Guidance Series, Section E, Part 2, U.S. Department of the Interior, Denver.
Ranga Raju, K. G., Kothyari, U. C., Srivastav, S., and Saxena, M. (1999). “Sediment removal efficiency of settling basins.” J. Irrig. Drain. Eng., 125(5), 308–314.
Rouse, H. (1950). Engineering hydraulics, Wiley, New York.
Sabbagh, M. S. (1984). “A generalized lexicographic partial enumeration algorithm for the solution of integer nonlinear programming problems.” D.Sc. dissertation, George Washington Univ., Washington, D.C.
Sarikaya, H. Z. (1977). “Numerical model for discrete settling.” J. Hydr. Div., 103, 865–876.
Singh, K. K., Pal, M., Ojha, C. S. P., and Singh, V. P. (2008). “Estimation of removal efficiency for settling basins using neural networks and support vector machines.” J. Hydrol. Eng., 13(3), 146–155.
Straub, L. G. (1935). “Some observations for sorting of river sediments.” Trans. Am. Geophys. Union, 16, 463–467.
Sumer, M. S. (1977). “Settlement of solid particles in open-channel flow.” J. Hydr. Div., 103(11), 1323–1337.
Vanoni, V. A. (1975). “Sedimentation engineering.” ASCE manuals and reports on engineering practice, No. 54, ASCE, Reston, Va., 582–587.
Vittal, N., and Raghav, M. S. (1997). “Design of single-chamber settling basins.” J. Hydraul. Eng., 123(5), 469–471.
Information & Authors
Information
Published In
Copyright
© 2010 ASCE.
History
Received: Jan 19, 2009
Accepted: Jul 23, 2009
Published online: Jul 25, 2009
Published in print: Feb 2010
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.