Simulation of Radial Collector Well in Shallow Alluvial Riverbed Aquifer Using Analytic Element Method
Publication: Journal of Irrigation and Drainage Engineering
Volume 136, Issue 2
Abstract
To withdraw large quantities of groundwater from the alluvial aquifers for various uses near riverbeds, radial collector (RC) wells are often preferable to the installation of several small diameter tube wells. In regions where rivers are not perennial or have low flow conditions during most part of the year, the RC wells are placed in the riverbed to obtain uninterrupted supply of naturally filtered groundwater through highly permeable saturated riverbed aquifers. Due to the complexities of flow, no exact analytical solution exists to provide steady state discharge drawdown relationship for RC well. Numerical model construction using finite difference or finite element method is quite cumbersome because of the radial orientation of laterals. To overcome these difficulties, in this study a steady state simulation model based on analytic element method (AEM) is developed to simulate the discharge-drawdown relation for RC well in an unconfined riverbed aquifer. In the model, line-sink elements are used to represent stream as well as radial laterals with specified conductance. The model is used to study the effects of different lateral configurations, hydraulic conductivity of riverbed aquifer, radius of influence and conductance of laterals on the well discharge, and consequent drawdown. Further based on the results of simulations using the AEM model, an approximate empirical equation is developed to obtain the discharge of RC well readily for design purpose. Further, the developed model has been applied to a field study and results are obtained for different plausible configurations of radial wells. The proposed methodology based on the application of AEM modeling tool, has been found to be efficient in constructing riverbed aquifer model with RC well. The proposed model is recommended in designing new collector well by providing minimum length of laterals for the sustained yield.
Get full access to this article
View all available purchase options and get full access to this article.
References
Driscoll, F. G. (1986). Groundwater and wells, Johnson Division, St. Paul, Minnesota.
Haitjema, H. M. (1995). Analytic element modeling of groundwater flow, Academic, San Diego.
Hantush, M. S. (1964). “Hydraulics of wells.” Advances in hydrosciences, V. T. Chow, ed., Academic, New York, 281–432.
Hantush, M. S., and Papadopulos, I. S. (1962). “Flow of groundwater to collector wells.” J. Hydr. Div., 88(5), 221–244.
Hiscock, K. M., and Grischek, T. (2002). “Attenuation of groundwater pollution by bank filtration.” J. Hydrol., 266, 139–144.
Hunt, H., Schubert, J., and Ray, C. (2002). “Conceptual design of riverbank filtration system.” Riverbank filtration improving source-water quality, C. Ray, G. Melin, and R. B. Linskty, eds., Kluwer Academic, Boston.
Kordas, B. (1960). “Conference d'Hydraulique.” Proc., Conf. d’Hydraulique, Assoc. d'Hydraulique, Budapest, Hungary.
McDonald, M. G. and Harbaugh, A. W. (1988). “A modular three-dimensional finite-difference ground-water flow model.” U.S. Geol. Survey Open File Rep. No. 83–875.
McWhorter, D. b., and Sunada, D. K. (1977). Groundwater hydrology and hydraulics, Water Resources Publication, Englewood, Colo.
Mikels, F. C., and Klaer, F. H., Jr. (1956). “Application of groundwater hydraulics to the development of water supplies by induced infiltration.” Proc., Int. Association of Scientific Hydrology Symp., Int. Assoc. of Hydrology, Darcy, Dijon, France, Publ. 41.
Milojevic, M. (1963a). “Discussion on flow of groundwater to collector wells.” J. Hydr. Div., 89(2), 193–194.
Milojevic, M. (1963b). “Radial collector wells adjacent to the riverbank.” J. Hydr. Div., 89(6), 133–151.
Patel, H. M., Shah, C. R., and Shah, D. L. (1998). “Modeling of radial collector well for sustained yield: A case study.” Proc., Int. Conf. MODFLOW 98, Vol. 1, IGWMC, Golden, Colo., 97–103.
Petrovic, S.(1956). Snabdevanje naselja vodom, Water Supplies, Beograd, Serbia.
Ray, C., Grischek, T., Schubert, J., Wang, J., and Speth, T. F. (2002). “A perspective of riverbank filtration.” J. Am. Water Works Assoc., 94(4), 149–160.
Rushton, K. R. (2003). Groundwater hydrology: Conceptual and computational models, Wiley, West Sussex, U.K.
Strack, O. D. L. (1989). Groundwater mechanics, Prentice-Hall, Englewood Cliffs, N.J.
Walton, W. C. (1992). Groundwater modeling utilities, Lewis, Boca Raton, Fla.
Information & Authors
Information
Published In
Copyright
© 2010 ASCE.
History
Received: Apr 12, 2008
Accepted: Jul 1, 2009
Published online: Jan 15, 2010
Published in print: Feb 2010
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.