Investigation of Hazard Potential of Oil Industry Wastes and Products for Better Management Practices
Publication: Journal of Hazardous, Toxic, and Radioactive Waste
Volume 22, Issue 4
Abstract
Polychlorinated biphenyl (PCB), metal, and chlorine contents of samples—including waste mineral oil, engine oil, edible oil, oily waste (industrial/domestic), and number 10 lube (NTL)—were investigated to evaluate possible hazards to the environment. Analyses were conducted using Turkish and United States Environmental Protection Agency standards. The results showed an uneven distribution of pollutants among all type of samples or samples that were collected from the same area at different time intervals. Although PCB usage was banned in Turkey many years ago, indicator PCB congeners were observed in NTL samples that were predominantly used as alternative fuel in heavy duty diesel engines. Waste oil and oily waste samples should be recycled as raw materials and/or recovered as an energy source, but the findings of this study yields disposal as a hazardous material due to high metal (Cr) content. The overall results of the study show that uncontrolled combustion of waste oil and oily wastes may cause environmental problems, and use of these wastes and products should be controlled and managed by strict precautions.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
This study was funded by the Scientific and Technological Research Council of Turkey (Project No. 112Y175) and the Scientific Research Projects Coordination Unit of Akdeniz University (Grant Nos. 2014.01.0102.006 and FDK-2014-24). Hence, the authors are grateful to TUBITAK and Akdeniz University for their financial support. In addition, the authors would like to thank to chemist Murat Kılıç from the Food Safety and Agricultural Research Center (Akdeniz University) for valuable support in ICP-MS analysis.
References
Alade, A. O., A. T. Jameel, S. A. Muyubi, M. I. A. Karim, and M. Z. Alam. 2011. “Removal of oil and grease as emerging pollutants of concern (EPC) in wastewater stream.” IIUM Eng. J. 12 (4): 161–169.
Baars, A., M. Bakker, R. Baumann, P. Boon, J. Freijer, L. Hoogenboom, R. Hoogerbrugge, J. Van Klaveren, A. Liem, and W. Traag. 2004. “Dioxins, dioxin-like PCBs and nondioxin-like PCBs in foodstuffs: Occurrence and dietary intake in the Netherlands.” Toxicol. Lett. 151 (1): 51–61. https://doi.org/10.1016/j.toxlet.2004.01.028.
Canakci, M., and İ. Akinci. 2007. “Antalya ili seralarında kullanılan havalandırma ve isıtma sistemleri.” Akdeniz Üniversitesi Ziraat Fakültesi Dergisi 20 (2): 241–252.
Cheung, K., L. Ntziachristos, T. Tzamkiozis, J. Schauer, Z. Samaras, K. Moore, and C. Sioutas. 2010. “Emissions of particulate trace elements, metals and organic species from gasoline, diesel, and biodiesel passenger vehicles and their relation to oxidative potential.” Aerosol Sci. Technol. 44 (7): 500–513. https://doi.org/10.1080/02786821003758294.
COB (The Ministry of Environment and Forestry of Turkey). 2008. Atik yaglarinkontrolu yonetmeligi. COB 26952. Ankara, Turkey: COB.
De Araujo, C. D. M., C. C. De Andrade, E. D. E. Silva, and F. A. Dupas. 2013. “Biodiesel production from used cooking oil: A review.” Renewable Sustainable Energy Rev. 27 (1): 445–452. https://doi.org/10.1016/j.rser.2013.06.014.
Dorsey, A. S., Jr., C. Rabe, and S. Thampi. 1997. Toxicological profile for used mineral-based crankcase oil. Atlanta: Division of Toxicology/Toxicology Information Branch.
Fontcuberta, M., J. Arqués, J. Villalbi, M. Martinez, F. Centrich, E. Serrahima, L. Pineda, J. Duran, and C. Casas. 2008. “Chlorinated organic pesticides in marketed food: Barcelona, 2001-06.” Sci. Total Environ. 389 (1): 52–57. https://doi.org/10.1016/j.scitotenv.2007.08.043.
Gedik, K., and Y. Uzun. 2015. “Characterization of the properties of diesel-base oil-solvent-waste oil blends used as generic fuel in diesel engines.” Fuel Process. Technol. 139 (1): 135–141. https://doi.org/10.1016/j.fuproc.2015.07.032.
Gedik, K., and M. Yurdakul. 2014. “Assessment of chemical content of base oil blends used as alternative diesel fuel for environmental safety.” Transp. Res. Part D: Transp. Environ. 30 (1): 86–94. https://doi.org/10.1016/j.trd.2014.05.010.
Gulyurtlu, I., H. Lopes, and I. Cabrita. 1996. “The determination of emissions of pollutants from burning waste oils.” Fuel 75 (8): 940–944. https://doi.org/10.1016/0016-2361(96)00051-8.
Hall, R. E., W. M. Cooke, and R. L. Barbour. 1983. “Comparison of air pollutant emissions from vaporizing and air atomizing waste oil heaters.” J. Air Pollut. Control Assoc. 33 (7): 683–687. https://doi.org/10.1080/00022470.1983.10465627.
Milestone, M. 2009. Start D and SK-10 segmented rotor operator manual. Italy: Milestone.
Mitsch, W. J., and S. E. Jorgensen. 2003. “Ecological engineering: A field whose time has come.” Ecol. Eng. 20 (5): 363–377. https://doi.org/10.1016/j.ecoleng.2003.05.001.
Roszko, M., A. Szterk, K. Szymczyk, and B. Waszkiewicz-Robak. 2012. “PAHs, PCBs, PBDEs and pesticides in cold-pressed vegetable oils.” J. Am. Oil Chem. Soc. 89 (3): 389–400. https://doi.org/10.1007/s11746-011-1926-5.
TSE (Turkish Standards Institution). 2003. Petroleum products and used oils—Determination of PCBs and related products. Part 1: Separation and determination of selected PCB congeners by gas chromatography (GC) using an electron capture detector (ECD). TS EN 12766. Ankara, Turkey: TSE.
UNEP (United Nations Environment Programme). 1999. Guidelines for the identification of PCBs and materials containing PCBs. Geneva: UNEP.
USEPA (US Environmental Protection Agency). 1994. Test methods for total chlorine in new and used petroleum products (field test kit methods). Washington, DC: USEPA.
USEPA (US Environmental Protection Agency). 2007. Microwave assisted acid digestion of sediments, sludges, and oils. Washington, DC: USEPA.
Wu, L., G. Ge, and J. B. Wan. 2009. “Biodegradation of oil wastewater by free and immobilized Yarrowia lipolytica W29.” J. Environ. Sci. 21 (2): 237–242. https://doi.org/10.1016/S1001-0742(08)62257-3.
Information & Authors
Information
Published In
Copyright
©2018 American Society of Civil Engineers.
History
Received: Oct 2, 2017
Accepted: Apr 10, 2018
Published online: Aug 11, 2018
Published in print: Oct 1, 2018
Discussion open until: Jan 11, 2019
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.