Seepage and Boiling around a Sheet Pile under Different Experimental Configuration
Publication: Journal of Hydrologic Engineering
Volume 21, Issue 12
Abstract
The sheet piles are used below hydraulic structures to reduce seepage flow rate and hydraulic gradients at the outlet of such structures that are rested on the permeable foundations. Up to now, for analysis of seepage under hydraulic structures, a number of research works have been conducted in the form of numerical models. However, less field and laboratory works have been done to study the boiling phenomenon for the evaluation of the numerical models. In the present research work, a laboratory model was made to simulate seepage flow and its behavior downstream of a sheet pile under vertical and inclined configurations. The model consisted of a flume 2.2 m long, 0.8 m deep, and 0.4 m wide, in which vertical and inclined sheet piles were provided by cast acrylic sheet. The flume was made of steel frame and Perspex as well as thick glass sheets. Fine clean sand was used as an alluvial foundation and then compacted to a uniform density at the bottom of 40 cm of flume. Perspex sheets were used as sheet pile variable depth. The piezometric heads were measured both downstream and upstream of the sheet pile using small-diameter clear plastic tubes. The results indicated that the optimal ratio of sheet pile depths for both vertical and inclined sheet piles to reduce boiling under maximum upstream water level were and , respectively. Finally, it could be concluded that the inclined configuration with the angle of 60° (to the horizontal direction) performed well to reduce boiling compared with the vertical case.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
The authors wish to express their deepest gratitude to Yasouj University for their financial and technical support of the project.
References
Benmebarek, N., Benmebarek, S., and Kastner, R. (2005). “Numerical studies of seepage failure of sand within a cofferdam.” Comput. Geotech., 32(4), 264–273.
Bennet, P. T. (1946). “The effect of blankets on seepage through pervious foundation.” Trans. ASCE, 111(1), 215–228.
Bligh, W. G. (1910). “Dams, barrages and weirs on porous foundations.” Eng. News, 64(26), 708–710.
Chang, D. S., and Zhang, L. M. (2013). “Critical hydraulic gradients of internal erosion under complex stress states.” J. Geotech. Geoenviron. Eng., 1454–1467.
Chen, L., Zhao, J., Li, G., Zhan, L., Lei, W. (2013). “Experimental study of seawall piping under water level fluctuation.” Eur. J. Environ. Civil. Eng., 17(sup1), s1–s22.
Elkholy, M., Sharif, Y., Hanif Chaudhry, M., and Imran, J. (2015). “Effect of soil composition on piping of earthen levees.” J. Hydraul. Res., 53(4), 478–487.
FLAC-2D [Computer software]. ITASCA Consulting Group, Inc., Minneapolis.
Fleshman, M., and Rice, J. (2014). “Laboratory modeling of the mechanisms of piping erosion initiation.” J. Geotech. Geoenviron. Eng., 04014017.
Fontana, N. (2008). “Experimental analysis of heaving phenomena in sandy soils.” J. Hydraul. Eng., 794–799.
Javan, M., and Farjood, M. R. (1993). “Evaluation of foundation seepage at Doroodzan earth dam.” Proc., Int. Conf. on Environmental Management, Geo-Water and Engineering Aspects, A.A Balkema, Rotterdam, Netherlands.
Koo, M. H., and Leap, D. I. (1998). “Modeling three-dimensional ground water flows by the body-fitted coordinate (BFC) method. II: Free and moving boundary problems.” Transp. Porous Media, 30(3), 345–362.
Lane, E. W. (1935). “Security from under-seepage-masonry dams on earth foundations.” Trans. ASCE, 100(1), 1235–1272.
Lee, K. K., and Leap, D. I. (1997). “Simulation of a free-surface and seepage face using boundary-fitted coordinate system method.” J. Hydrol., 196(1–4), 297–309.
McNamee, J. (1949). “Seepage into a sheeted excavation.” Geotechnique, 1(4), 229–241.
Mishra G., and Reddy A. (1983) “Exit gradient in anisotropic porous medium.” J. Hydraul. Eng., 897–904.
Mishra, G., and Singh, A. (2005). “Seepage through a levee.” Int. J. Geomech., 74–79.
MSEEP version 1.0 [Computer software]. GeoDelft, Netherlands.
Neuman, S. P., and Witherspoon, P. A. (1970). “Finite element method for analyzing steady seepage with a free surface.” Water Resour. Res., 6(3), 889–897.
Ojha, C. S. P., Singh, V. P., and Adrian, D. D. (2001). “Influence of porosity on piping models of levee failure.” J. Geotech. Geoenviron. Eng., 1071–1074.
Ojha, C. S. P., Singh, V. P., and Adrian, D. H. (2003). “Determination of the critical head in soil piping.” J. Hydraul. Eng., 511–518.
Rahimi, H. (2003). Embankments dams, Tehran University Press, Tehran, Iran (in Persian).
Richards, K., and Reddy, K. (2007). “Critical appraisal of piping phenomena in earth dams.” Bull. Eng. Geol. Environ., 66(4), 381–402.
Sedghi-Asl, M., Parvizi, M., Armin, M., and Flores-Berrones, R. (2015). “Internal erosion under a spillway rested on an embankment dam.” Int. J. Min. Geo-Eng., 49(2), 269–279.
Sedghi-Asl, M., Rahimi, H., and Khaleghi, H. (2010). “Experimental analysis of seepage flow under coastal dikes.” Exp. Tech., 34(4), 49–54.
Sedghi-Asl, M., Rahimi, H., and Khaleghi, H. (2012). “Laboratory investigation of the seepage control measures under coastal dikes.” Exp. Tech., 36(1), 61–71.
Sellmeijer, J. B., and Koenders, M. A. (1991). “A mathematical model for piping.” Appl. Math. Model., 15(11–12), 646–651.
Sharif, Y., Elkholy, M., Hanif Chaudhry, M., and Imran, J. (2015). “Experimental study on the piping erosion process in earthen embankments.” J. Hydraul. Eng., 04015012.
Streeter, V. L., and Wylie, E. B. (1981). Fluid mechanics, McGraw-Hill Ryerson, Toronto.
Tanaka, T., Takashima, W., Pham, T. T. H., Utra, K., and Uemura, N. (2012). “A case study on seepage failure of bottom soil within a double-sheet-pile-wall-type ditch.” ICSE6 Paris, Societe Hydrotechnique de France, France.
Tanaka, T., and Verruijt, A. (1999). “Seepage failure of sand behind sheet piles—The mechanism and practical approach to analyze.” Soils Found., 39(3), 27–35.
Tanaka, T., and Yokoyama, T. (2006). “Effects of jet grouting under sheet piles on seepage failure stability of soil.” Proc., 5th Int. Symp. on Geotechnical Aspects of Underground Construction in Soft Ground, ISSMGE, Taylor & Francis Group, London.
Terzaghi, K. (1943). Theoretical soil mechanics, Wiley, New York.
USBR (United States Department of the Interior, Bureau of Reclamation). (1977). “Design of small dams.” Washington, DC.
Information & Authors
Information
Published In
Copyright
© 2016 American Society of Civil Engineers.
History
Received: Jul 15, 2015
Accepted: Jun 24, 2016
Published online: Aug 12, 2016
Published in print: Dec 1, 2016
Discussion open until: Jan 12, 2017
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.