Effect of Loading Frequency on Volumetric Strain Accumulation and Stiffness Improvement in Sand under Drained Cyclic Direct Simple Shear Tests
Publication: Journal of Geotechnical and Geoenvironmental Engineering
Volume 147, Issue 12
Abstract
The effect of the loading frequency on the volumetric strain accumulation, stiffness improvement, and damping ratio of silica sand during cyclic shearing of the silica sand was investigated by performing drained cyclic strain-controlled direct simple shear tests. Cyclic shear strain amplitudes () of 0.5% and 1.0%; vertical effective stresses () of 100, 200, and 300 kPa; and loading frequencies () of 0.05, 0.1, 0.5, and 1 Hz were considered. Sand samples were prepared in the loose () and dense () states using dry Nakdong River sand. For loose sand tested at and 200 kPa, the test results showed that the rate of volumetric strain accumulation decreased with increasing , and the decrease was independent of and more obvious at the higher value. The maximum decrease in the volumetric strain accumulation was 60%, which corresponded to a 20-fold increase in , from 0.05 to 1 Hz. For dense sand tested at , the accumulated rate of volumetric strain was essentially identical, especially at . The shear modulus ratio always increased with the increase of for both loose and dense sand, but the difference between shear modulus ratios at different was reduced with the increase of , when the samples were sheared at . The improvement parameter , which is proposed in this study and which represents the increase in the rate of cyclic stiffness with the number of cycles (), increased linearly with . For loose sand, it increased by approximately 56% and 12% at and 1.0%, regardless of , respectively. The normalized damping ratio () was independent of , , , and , and the relationship between and was well expressed by a power function. The effect of the loading frequency on Nakdong River sand inferred from a drained test was similar to that indicated by an undrained test.
Get full access to this article
View all available purchase options and get full access to this article.
Data Availability Statement
Some or all data, models, or codes generated or used during the study are available from the corresponding author by request.
Acknowledgments
This work was supported by the National Research Foundation of Korea (NRF) grant funded by the Korean government (NRF-2019R1F1A1058869 and NRF-2021R1I1A3059731) and the National Natural Science Foundation of China grant funded by the Chinese government (Grant No. 51979128).
References
Bhattacharya, S., G. Nikitas, and N. Vimalan. 2019. “Dynamic SSI of monopile-supported offshore wind turbines.” In Geotechnical design and practice. Berlin: Springer.
Duku, P. M., J. P. Stewart, D. H. Whang, and R. Venugopal. 2007. “Digitally controlled simple shear apparatus for dynamic soil testing.” Geotech. Test. J. 30 (5): 368–377. https://doi.org/10.1520/GTJ100518.
Duku, P. M., J. P. Stewart, D. H. Whang, and E. Yee. 2008. “Volumetric strains of clean sands subject to cyclic loads.” J. Geotech. Geoenviron. Eng. 138 (8): 1073–1085. https://doi.org/10.1061/(ASCE)1090-0241(2008)134:8(1073).
Dyvik, R., T. Berre, S. Lacasse, and B. Raadim. 1987. “Comparison of truly undrained and constant volume direct simple shear tests.” Géotechnique 37 (1): 3–10. https://doi.org/10.1680/geot.1987.37.1.3.
Idriss, I. M., R. Dobry, and R. D. Singh. 1978. “Nonlinear behavior of soft clays during cyclic loading.” J. Geotech. Eng. Div. 104 (12): 1427–1447. https://doi.org/10.1061/AJGEB6.0000727.
Lee, K. L., and J. A. Fitton. 1969. “Factors affecting the cyclic loading strength of soil.” In Vibration effects of earthquakes on soils and foundations, 71–95. West Conshohocken, PA: ASTM.
Mortezaie, A. R. 2012. “Cyclic threshold strains in clays versus sands and the change of secant shear modulus and pore water pressure at small cyclic strains.” Ph.D. thesis, Dept. of Civil and Environmental Engineering, Univ. of California.
Mortezaie, A. R., and M. Vucetic. 2012. “Small-strain cyclic testing with standard NGI simple shear device.” Geotech. Test. J. 35 (6): 46–60. https://doi.org/10.1520/GTJ20120007.
Mortezaie, A. R., and M. Vucetic. 2013. “Effect of frequency and vertical stress on cyclic degradation and pore water pressure in clay in the NGI simple shear device.” J. Geotech. Geoenviron. Eng. 139 (10): 1727–1737. https://doi.org/10.1061/(ASCE)GT.1943-5606.0000922.
Nong, Z., S.-S. Park, S.-W. Jeong, and D.-E. Lee. 2020. “Effect of cyclic loading frequency on liquefaction prediction of sand.” Appl. Sci. 10 (13): 4502. https://doi.org/10.3390/app10134502.
Normandeau, D. E., and T. F. Zimmie. 1991. “The effect of frequency of cyclic loading on earth structures and foundation soils.” In Proc., 2nd Int. Conf., on Recent Advances in Geotechnical Earthquake Engineering and Soil Dynamics. St. Louis, MI: Scholars’ Mine.
Peacock, W. H., and H. B. Seed. 1968. “Sand liquefaction under cyclic loading simple shear conditions.” J. Soil Mech. Found. Div. 94 (3): 689–708. https://doi.org/10.1061/JSFEAQ.0001135.
Peralta, P. 2010. “Investigations on the behavior of large diameter piles under long-term lateral cyclic loading in cohesionless soil.” Ph.D. thesis, Institute for Geotechnical Engineering, Leibniz Univ.
Polito, C. P. 1999. The effects of non-plastic and plastic fines on the liquefaction of sandy soils. Blacksburg, VA: Virginia Polytechnic Institute and State Univ.
Silver, M. L., and H. B. Seed. 1971. “Volume changes in sand during cyclic loading.” J. Soil Mech. Found. Div. 97 (9): 1171–1182. https://doi.org/10.1061/JSFEAQ.0001658.
Sriskandakumar, S. 2000. Cyclic loading response of Fraser River sand for validation of numerical models simulating centrifuge tests. Vancouver, BC, Canada: Univ. of British Columbia.
Stewart, J. P., J. D. Bray, D. J. McMahon, P. M. Smith, and A. L. Kropp. 2001. “Seismic performance of hillside fills.” J. Geotech. Geoenviron. Eng. 127 (11): 905–919. https://doi.org/10.1061/(ASCE)1090-0241(2001)127:11(905).
Sze, H. Y. 2010. “Initial shear and confining stress effects on cyclic behaviour and liquefaction resistance of sands.” Ph.D. thesis, Dept. of Civil Engineering, Hong Kong Univ.
Tatsuoka, F., S. Maeda, S. Fujii, and S. I. Yamada. 1983. “Cyclic undrained strength of saturated sand under random and uniform loading and their relation.” In Bulletin of earthquake resistant structure research center, institute of industrial science, 11–31. Tokyo: Univ. of Tokyo.
Wang, X. H., and H. L. Zhou. 2003. “Study on dynamic steady state strength of sand liquefaction.” [In Chinese.] J. Rock Mech. Eng. 22 (1): 96–102.
Wartman, J., A. Rodriguez-Marek, P. C. Repetto, D. K. Keefer, E. Rondinel, J. Zegarra-Pellane, and D. Baures. 2003. “Ground failure.” Earthquake Spectra 19 (1): 35–56. https://doi.org/10.1193/1.1737250.
Whang, D. H., J. P. Stewart, and J. D. Bray. 2004. “Effect of compaction conditions on the seismic compression of compacted fill soils.” Geotech. Test. J. 27 (4): 371–379. https://doi.org/10.1520/GTJ11810.
Wu, Z.-X., Z.-Y. Yin, C. Dano, and P.-Y. Hicher. 2020. “Cyclic volumetric strain accumulation for sand under drained simple shear condition.” Appl. Ocean Res. 101 (Aug): 102200. https://doi.org/10.1016/j.apor.2020.102200.
Youd, T. L. 1972. “Compaction of sands by repeated shear straining.” J. Soil Mech. Found. Div. 98 (7): 709–725. https://doi.org/10.1061/JSFEAQ.0001762.
Zhang, S., Y. F. Zhang, L. K. Zhang, and C. J. Liu. 2015. “Influence of confining pressure and vibration frequency on the liquefaction strength of the saturated gravel sand.” [In Chinese.] J. Xinjiang Agric. Univ. 38 (1): 68–71.
Information & Authors
Information
Published In
Copyright
© 2021 American Society of Civil Engineers.
History
Received: Mar 9, 2021
Accepted: Aug 20, 2021
Published online: Sep 30, 2021
Published in print: Dec 1, 2021
Discussion open until: Feb 28, 2022
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.