Dense Granular Columns in Liquefiable Ground. II: Effects on Deformations
Publication: Journal of Geotechnical and Geoenvironmental Engineering
Volume 142, Issue 7
Abstract
Dense granular columns can be used to mitigate liquefaction hazards through a combination of densification, increases in lateral stress, reinforcement, and drainage effects. Three-dimensional (3D) nonlinear dynamic finite-element analyses are used to examine the effectiveness of dense granular columns for reducing liquefaction-induced deformations in the event that the triggering of liquefaction in the native soils is not prevented. The finite-element analyses consider unit cells with dense granular columns (improved case) and without granular columns (unimproved case). Parametric analyses are used to isolate aspects related to the different improvement mechanisms. The parametric studies consider a range of area replacement ratios, shear modulus ratios, diameter of granular columns, liquefiable soil depth, hydraulic conductivity, surface pressures, slope angle, penetration resistances in the native soil, and spatial variations in those penetration resistances. A set of 10 acceleration time histories were used as input motions. Dense granular columns were shown to be effective in reducing lateral spreading displacements of sloping ground, even if liquefaction triggering is not prevented. The reductions in lateral spreading displacement are primarily attributable to the reinforcing and strengthening effects of the granular columns, with drainage being a secondary benefit for cleaner sand profiles. The effect of spatially varying penetration resistances as develops around a column are examined and recommendations are developed for selecting an equivalent uniform value for design.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
This research is funded by Oregon Transportation Research and Education Consortium (OTREC), Oregon Department of Transportation (ODOT), and Pacific Earthquake Engineering Research (PEER) Center. Their support is gratefully acknowledged. The first author is also thankful to Dr. Jinchi Lu for his help with OpenSeesPL. The authors also appreciate the suggestions and comments received from Dr. Lisheng Shao and Dr. Armin W. Stuedlein during different phases of this research.
References
Adalier, K., and Elgamal, A. (2004). “Mitigation of liquefaction and associated ground deformations by granular columns.” Eng. Geol., 72(3–4), 275–291.
Adalier, K., Elgamal, A., Meneses, J., and Baez, J. I. (2003). “Granular columns as liquefaction counter-measure in non-plastic silty soils.” Soil Dyn. Earthquake. Eng., 23(7), 571–584.
Asgari, A., Oliaei, M., and Bagheri, M. (2013). “Numerical simulation of improvement of a liquefiable soil layer using granular column and pile-pinning techniques.” Soil Dyn. Earthquake. Eng., 51, 77–96.
Ashford, S. A., Rollins, K. M., Bradford, S. C., Weaver, T. J., and Baez, J. I. (2000). “Liquefaction mitigation using granular columns around deep foundations: Full scale test results.” Transp. Res. Rec., 1736, 110–118.
Baez, J. I. (1995). “A design model for the reduction of soil liquefaction by using vibro-granular columns.” Ph.D. thesis, Univ. of Southern California, Los Angeles.
Boulanger, R. W., Idriss, I. M., Stewart, D. P., Hashash, Y., and Schmidt, B. (1998). “Drainage capacity of stone columns or gravel drains for mitigating liquefaction.” Proc., Geotechnical Earthquake Engineering and Soil Dynamics III, P. Dakoulas, M. Yegian, and R. D. Holtz, eds., ASCE, Reston, VA, 678–690.
Chan, A. H. C. (1988). “A unified finite element solution to static and dynamic problems in geomechanics.” Ph.D. thesis, Univ. College of Swansea, Swansea, U.K.
Elgamal, A., Lu, J., and Forcellini, D. (2009). “Mitigation of liquefaction-induced lateral deformation in a sloping stratum: Three-dimensional numerical simulation.” J. Geotech. Geoenviron. Eng., 1672–1682.
Elgamal, W. A., Yang, Z., Parra, E., and Ragheb, A. (2003). “Modeling of cyclic mobility in saturated cohesionless soils.” Int. J. Plast., 19(6), 883–905.
GEER (Geotechnical Extreme Events Reconnaissance). (2010). “Geotechnical engineering reconnaissance of the 2010 Haiti earthquake.” 〈http://www.geerassociation.org/〉 (Aug. 15, 2013).
GEER (Geotechnical Extreme Events Reconnaissance). (2011a). “Geotechnical quick report on the Kanto plain region during the March 11, 2011, off pacific coast of Tohoku earthquake, Japan.” 〈http://www.geerassociation.org/〉 (Aug. 15, 2013).
GEER (Geotechnical Extreme Events Reconnaissance). (2011b). “Geotechnical reconnaissance of the 2011 Christchurch, New Zealand earthquake.” 〈http://www.geerassociation.org/〉 (Aug. 15, 2013).
Hayden, R. F., and Baez, J. I. (1994). “State of practice for liquefaction mitigation in North America.” Proc., 4th US–Japan Workshop on Soil Liquefaction: Remedial Treatment of Potentially Liquefiable Soils, Public Works Research Institute, Tsukuba Science City, Japan.
Idriss, I. M., and Boulanger, R. W. (2008). “Soil liquefaction during earthquakes.”, Earthquake Engineering Research Institute, Oakland, CA.
Ishihara, K., and Yoshimine, M. (1992). “Evaluation of settlements in sand deposits following liquefaction during earthquakes.” Soils Found., 32(1), 173–188.
Lu, J., Yang, Z., and Elgamal, A. (2006). “OpenSeesPL three-dimensional lateral pile–ground interaction version 1.00 user’s manual.”, Dept. of Structural Engineering, Univ. of California, San Diego.
Mazzoni, S., McKenna, F., Scott, M. H., and Fenves, G. L. (2009). Open system for earthquake engineering simulation user manual, Univ. of California, Berkeley, CA.
McKenna, F., Scott, M. H., and Fenves, G. L. (2010). “Nonlinear finite-element analysis software architecture using object composition.” J. Comput. Civ. Eng., 95–107.
Mitchell, J. K., Christopher, D. P. B., and Travis, C. M. (1995). “Performance of improved ground during earthquakes.” Soil Improvement for Earthquake Hazard Mitigation, ASCE, Reston, VA, 1–36.
OpenSees version 2.4.0 [Computer software]. Univ. of California, Berkeley, CA.
Rayamajhi, D., Ashford, S. A., Boulanger, R. W., and Elgamal, A. (2016). “Dense granular columns in liquefiable soils: Shear reinforcement and cyclic stress ratio reductions.” J. Geotech. Geoenviron. Eng., 04016023.
Saxena, D. S., and Hussin, J. D. (1997). “Granular column improved and piezocone tested site supports mid rise building complex—A case history.” ASCE, Reston, VA.
Shenthan, T., Thevanayagam, S., and Martin, G. R. (2004). “Densification of saturated silty soils using composite granular columns for liquefaction mitigation.” Proc., 13th World Conf. on Earthquake Engineering (DVD), Vancouver, BC, Canada.
Yang, Z., Elgamal, A., and Parra, E. (2003). “A computational model for cyclic mobility and associated shear deformation.” J. Geotech. Geoenviron. Eng., 1119–1127.
Yang, Z., Lu, J., and Elgamal, A. (2008). “OpenSees soil models and solid-fluid fully coupled elements: User’s manual.” Dept. of Structural Engineering, Univ. of California, San Diego.
Zienkiewicz, O. C., Chan, A. H. C., Pastor, M., Paul, D. K., and Shiomi, T. (1990). “Static and dynamic behavior of soils: A rational approach to quantitative solutions: I. Fully saturated problems.” Proc. R. Soc. London, Series A, 429(1877), 285–309.
Ziotopoulou, K., and Boulanger, R. W. (2013). “Numerical modeling issues in predicting post-liquefaction reconsolidation strains and settlements.” 10th Int. Conf. on Urban Earthquake Engineering, Tokyo Institute of Technology, Tokyo, 469–475.
Ziotopoulou, K., Maharjan, M., Boulanger, R. W., Beaty, M. H., Armstrong, R. J., and Takahashi, A. (2014). “Constitutive modeling of liquefaction effects in sloping ground.” 10th U.S. National Conf. on Earthquake Engineering, Earthquake Engineering Research Institute, Oakland, CA.
Information & Authors
Information
Published In
Copyright
© 2016 American Society of Civil Engineers.
History
Received: Aug 25, 2014
Accepted: Dec 1, 2015
Published online: Mar 17, 2016
Published in print: Jul 1, 2016
Discussion open until: Aug 17, 2016
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.