Abstract
The installation of dense granular columns by various construction techniques can be used to mitigate liquefaction through a combination of densification, increase of lateral stresses, reinforcement, and drainage. The contributing mechanism of shear reinforcement is isolated and explored using nonlinear three-dimensional (3D) finite-element (FE) analysis. FE models representing both dry and saturated conditions were developed to evaluate cases with and without generation and dissipation of excess pore-water pressures. The shear stress and strain distributions between the granular columns and surrounding soil, and the level of shear stress reduction, were investigated for a practical range of treatment geometries, relative stiffness ratios, vertical stresses, and relative densities of the surrounding soil. A set of 10 acceleration time histories were used as input motions. The FE results show that granular columns undergo a shear strain deformation pattern that is noncompatible with the surrounding soil. As such, the achieved reduction in cyclic stress ratios imposed on the treated soil is far less than that predicted by the conventional shear strain compatibility design approach. Reductions in cyclic stress ratios are insensitive to the applied surface pressure, granular column length/diameter ratio (L/D), and relative density of the surrounding soil for the range of area replacement ratio and column–soil shear modulus ratio examined. A modified design equation to estimate the reduction in cyclic stress ratio provided by dense granular columns is shown to provide good agreement with the FE simulation results.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
This research is funded by Oregon Transportation Research and Education Consortium (OTREC), Oregon Department of Transportation (ODOT), and Pacific Earthquake Engineering Research (PEER) Center. Any opinions or conclusions expressed herein are those of the authors and do not necessarily reflect the views of any of the above organizations. The authors appreciate the assistance with OpenSeesPL provided by Dr. Jinchi Lu and the suggestions and comments received from Dr. Lisheng Shao and Dr. Armin W. Stuedlein during different phases of this research.
References
Adalier, K., Elgamal, A., Meneses, J., and Baez, J. I. (2003). “Stone columns as liquefaction counter-measure in non-plastic silty soils.” Soil Dyn. Earthquake. Eng., 23(7), 571–584.
Andrus, R., and Stokoe, K., II (2000). “Liquefaction resistance of soils from shear-wave velocity.” J. Geotech. Geoenviron. Eng., 1015–1025.
Asgari, A., Oliaei, M., and Bagheri, M. (2013). “Numerical simulation of improvement of a liquefiable soil layer using stone column and pile-pinning techniques.” Soil Dyn. Earthquake. Eng., 51, 77–96.
Ashford, S. A., Rollins, K. M., Bradford, S. C., Weaver, T. J., and Baez, J. I. (2000). “Liquefaction mitigation using stone columns around deep foundations: Full scale test results.” Transp. Res. Rec., 1736, 110–118.
Baez, J. I. (1995). “A design model for the reduction of soil liquefaction by using vibro-stone columns.” Ph.D. thesis, Univ. of Southern California, Los Angels.
Baker, J. W., Lin, T., Shahi, S. K., and Jayaram, N. (2011). “New ground motion selection procedures and selected motions for the PEER transportation research program.”, Berkeley, CA, 106.
Boore, D., and Atkinson, G. (2008). “Ground-motion prediction equations for the average horizontal component of PGA, PGV, and 5%-damped PSA at spectral periods between 0.01 s and 10.0 s.” Earthquake Spectra, 24(1), 99–138.
Bouckovalas, G. D., Papadimitriou, A. G., Kondis, A., and Bakas, G. J. (2006). “Equivalent-uniform soil model for the seismic response analysis of sites improved with inclusions.” Proc., 6th European Conf. on Numerical Methods in Geotechnical Engineering, Taylor & Francis, London, 801–807.
Boulanger, R. W., and Idriss, I. M. (2014). “CPT and SPT based liquefaction triggering procedures.”, Center for Geotechnical Modeling, Dept. of Civil and Environmental Engineering, Univ. of California, Davis, CA, 134.
Boulanger, R. W., Idriss, I. M., Stewart, D. P., Hashash, Y., and Schmidt, B. (1998). “Drainage capacity of stone columns or gravel drains for mitigating liquefaction.” Proc., Geotechnical Earthquake Engineering and Soil Dynamics III, P. Dakoulas, M. Yegian, and R. D. Holtz, eds., ASCE, Reston, VA, 678–690.
Chan, A. H. C. (1988). “A unified finite element solution to static and dynamic problems in geomechanics.” Ph.D. thesis, Univ. College of Swansea, Swansea, U.K.
Duncan, J. M., et al. (2007). “Densities and friction angles of granular materials with standard gradations 21b and #57.”, Center for Geotechnical Practice and Research, Virginia Polytechnic Institute, Blacksburg, VA.
Elgamal, A., Lu, J., and Forcellini, D. (2009). “Mitigation of liquefaction-induced lateral deformation in a sloping stratum: Three-dimensional numerical simulation.” J. Geotech. Geoenviron. Eng., 1672–1682.
Elgamal, W. A., Yang, Z., Parra, E., and Ragheb, A. (2003). “Modeling of cyclic mobility in saturated cohesionless soils.” Int. J. Plast., 19(6), 883–905.
EPRI (Electric Power Research Institute). (1993). “Guidelines for determining design basis ground motions.”, Electric Power Research Institute, Palo Alto, CA.
Goughnour, R. R., and Pestana, J. M. (1998). “Mechanical behavior of stone columns under seismic loading.” Proc., 2nd Int. Conf. on Ground Improvement Techniques, CI-Premier, Singapore, 157–162.
Green, R. A., Olgun, C. G., and Wissmann, K. J. (2008). “Shear stress redistribution as a mechanism to mitigate the risk of liquefaction.” Geotechnical Earthquake Engineering and Soil Dynamics IV, GSP 181, ASCE, Reston, VA.
Idriss, I. M., and Boulanger, R. W. (2008). “Soil liquefaction during earthquakes.” Monograph MNO-12, Earthquake Engineering Research Institute, Oakland, CA, 261.
Khosravifar, A. (2012). “Analysis and design for inelastic structural response of extended pile shaft foundations in laterally spreading ground during earthquakes.” Ph.D. thesis, Univ. of California, Davis, CA.
Kulhawy, F. H., and Mayne, P. W. (1990). “Manual on estimating soil properties for foundation design.”, Electric Power Research Institute, Palo Alto, CA.
Law, H. K., and Lam, I. P. (2001). “Application of periodic boundary for large pile group.” J. Geotech. Geoenviron. Eng., 889–892.
Lu, J., Yang, Z., and Elgamal, A. (2006). “OpenSeesPL three-dimensional lateral pile–ground interaction version 1.00 user’s manual.”, Dept. of Structural Engineering, Univ. of California, San Diego.
Mazzoni, S., McKenna, F., Scott, M. H., and Fenves, G. L. (2009). “Open system for earthquake engineering simulation user manual.” Univ. of California, Berkeley, CA.
McKenna, F., Scott, M. H., and Fenves, G. L. (2010). “Nonlinear finite-element analysis software architecture using object composition.” J. Comput. Civ. Eng., 24(1), 95–107.
Mitchell, J. K., Christopher, D. P. B., and Travis, C. M. (1995). “Performance of improved ground during earthquakes.” Soil improvement for earthquake hazard mitigation, Vol. 49, ASCE, Reston, VA, 1–36.
Olgun, C. G., and Martin, J. R. (2008). “Numerical modeling of the seismic response of columnar reinforced ground.” Geotechnical Earthquake Engineering and Soil Dynamics IV, ASCE, Reston, VA.
OpenSees Version 2.4.0 [Computer software]. Univ. of California, Berkeley, CA.
Parra, E. (1996). “Numerical modeling of liquefaction and lateral ground deformation including cyclic mobility and dilation response in soil systems.” Ph.D. thesis, Rensselaer Polytechnic Institute, Troy, NY.
Prevost, J. H. (1985). “A simple plasticity theory for frictional cohesionless soils.” Soil. Dyn. Earthquake Eng., 4(1), 9–17.
Priebe, H. J. (1991). “The prevention of liquefaction by vibro replacement.” Proc., 2nd Int. Conf. on Earthquake Resistant Construction and Design, S. A. Savidis, ed., DGEB, A. A. Balkema, Rotterdam, Netherlands, 211–219.
Rayamajhi, D., et al. (2014). “Numerical study of shear stress distribution for discrete columns in liquefiable sols.” J. Geotech. Geoenviron. Eng., 04013034.
Rayamajhi, D., Boulanger, R. W., Ashford, S. A., and Elgamal, A. (2016). “Dense granular columns in liquefiable ground: Effects on deformations.” J. Geotech. Geoenviron. Eng., 04016024.
Rollins, K. M., Evans, M. D., Diehl, N. B., and Dailey, W. D., III (1998). “Shear modulus and damping relationships for gravels.” J. Geotech. Geoenviron. Eng., 396–405.
Saxena, D. S., and Hussin, J. D. (1997). “Stone column improved and piezocone tested site supports mid rise building complex—A case history.” Proc., Ground Improvement, Ground Reinforcement and Ground Treatment: Developments 1987–1997, GSP, 69, ASCE, Reston, VA, 476–491.
Seed, H. B., and Idriss, I. M. (1971). “Simplified procedure for evaluating soil liquefaction potential.” J. Soil Mech. Found. Div., 97(9), 1249–1273.
Shenthan, T., Thevanayagam, S., and Martin, G. R. (2004). “Densification of saturated silty soils using composite stone columns for liquefaction mitigation.” Proc., 13th World Conf. on Earthquake Engineering, Vancouver, BC, Canada.
Yang, Z., Elgamal, A., and Parra, E. (2003). “A computational model for cyclic mobility and associated shear deformation.” J. Geotech. Geoenviron. Eng., 1119–1127.
Yang, Z., Lu, J., and Elgamal, A. (2008). “OpenSees soil models and solid-fluid fully coupled elements: User’s manual.” Dept. of Structural Engineering, Univ. of California, San Diego.
Zienkiewicz, O. C., Chan, A. H. C., Pastor, M., Paul, D. K., and Shiomi, T. (1990). “Static and dynamic behavior of soils: A rational approach to quantitative solutions: I. Fully saturated problems.” Proc. R. Soc. London, Series A, 429(1877), 285–309.
Information & Authors
Information
Published In
Journal of Geotechnical and Geoenvironmental Engineering
Volume 142 • Issue 7 • July 2016
Copyright
© 2016 American Society of Civil Engineers.
History
Received: Aug 25, 2014
Accepted: Dec 1, 2015
Published online: Mar 17, 2016
Published in print: Jul 1, 2016
Discussion open until: Aug 17, 2016
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.