Cyclic Resistance of a Loose Sand Subjected to Rotation of Principal Stresses
Publication: Journal of Geotechnical and Geoenvironmental Engineering
Volume 141, Issue 3
Abstract
An experimental study aimed at providing insights into the effects of the inclination of principal stress directions with respect to the bedding plane and the role of principal stress rotation on the cyclic resistance of sands is presented. A new hollow cylinder torsional shear device commissioned at Carleton University was used to conduct the experiments in water-deposited Fraser River sand. Specimens at identical initial states were subjected to a constant amplitude cyclic shear stress along loading paths that impose different levels of stress rotation. Cyclic resistance decreased significantly as the maximum orientation of the major principal stress increased to approximately 45°–60°, but it increased with further rotation. This is contrary to the conventional idea according to which the weakest response is expected when the loading causes larger principal stress rotation and/or when the major principal stress is aligned with the bedding planes. The alignment of the plane of maximum shear stress toward and stronger time history of shear stress on the horizontal bedding planes lead to increased liquefaction susceptibility. The nature of shear stress on the bedding planes appears more critical than the alignment of the major principal stress along the bedding planes during cyclic loading. Test results also suggest that cyclic simple shear tests on the basis of stress rotation would represent a lower bound or closer to lower bound resistance. Thus, cyclic simple shear tests provide a convenient means of determining the cyclic resistance and the obtained resistance can be considered a conservative measure if field loading conditions deviate from that in simple shear.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
This research was supported by grants from the Natural Sciences and Engineering Research Council of Canada, Canada Foundation for Innovation, and the Ontario Innovation Trust. Financial support was provided to the second author by Ontario Graduate Scholarship and to the second and third authors by Carleton University, and the technical assistance of Stanley Conley, Pierre Trudel, and Jim Whitehorne is gratefully acknowledged.
References
Arthur, J. R. F., Bekenstein, S., Germaine, J. T., and Ladd, C. C. (1981). “Stress path tests with controlled rotation of principal stress direction.” Proc., Laboratory Shear Strength of Soil, ASTM STP 740, R. N. Yong, and F. C. Townsend, eds., American Society for Testing and Materials, Philadelphia, 516–540.
Arthur, J. R. F., Chua, K. S., and Dunstan, T. (1977). “Induced anisotropy in a sand.” Géotechnique, 27(1), 13–30.
Arthur, J. R. F., Roderiguez, J. I., Dunstan, T., and Chua, K. S. (1980). “Principal stress rotation: A missing parameter.” J. Geotech. Eng. Div., 106(4), 419–433.
ASTM. (2000a). “Standard test methods for maximum index density and unit weight of soils using a vibratory table.” D4253, West Conshohocken, PA.
ASTM. (2000b). “Standard test methods for minimum index density and unit weight of soils and calculation of relative density.” D4254, West Conshohocken, PA.
Bhatia, S. K., Scwhab, L., and Ishibashi, I. (1985). “Cyclic simple shear, torsional shear and triaxial—A comparative study.” Advances in the art of testing soils under cyclic conditions, ASCE, Reston, VA, 232–254.
Grabe, P. J., and Clayton, C. R. I. (2009). “Effects of principal stress rotation on permanent deformation in rail track foundations.” J. Geotech. Geoenviron. Eng., 555–565.
Ishibashi, I., and Sherif, M. A. (1974). “Soil liquefaction by torsional simple shear device.” J. Geotech. Eng. Div., 100(8), 871–888.
Ishihara, K. (1993). “Liquefaction and flow failure during earthquakes.” Géotechnique, 43(3), 351–451.
Ishihara, K., Tatsuoka, F., and Yasuda, S. (1975). “Undrained deformation and liquefaction of sand under cyclic stresses.” Soils Found., 15(1), 29–44.
Ishihara, K., and Towhata, I. (1983). “Sand response to cyclic rotation of principal stress directions as induced by wave loads.” Soils Found., 23(4), 11–26.
Ishihara, K., and Yasuda, S. (1975). “Sand liquefaction in hollow cylinder torsional shear under irregular excitation.” Soils Found., 15(1), 45–59.
Lade, P. V., and Wasif, U. (1988). “Effect of height-to-diameter ratio in triaxial specimens on the cross anisotropic sand.” Advanced triaxial testing of soil and rock, ASTM STP 977, R. T. Donaghe, R. C. Chaney, and M. L. Silver, eds., ASTM, Philadelphia, 706–714.
Lam, W., and Tatsuoka, F. (1988). “Effects of initial anisotropic fabric and on strength and deformation characteristics of sand.” Soils Found., 28(1), 89–106.
Logeswaran, P., and Sivathayalan, S. (2014). “A new hollow cylinder torsional shear device for stress/ strain path controlled loading.” ASTM Geotech. Test. J., 37(1), 1–12.
Miura, K., Miura, S., and Toki, S. (1986). “Deformation behavior of anisotropic dense sand under principal stress axes rotation.” Soils Found., 26(1), 36–52.
NRC (National Research Council). (1985). “Liquefaction of soils during earthquakes.” Rep. of the Committee on Earthquake Engineering, National Academy Press, Washington, DC.
Oda, M. (1972). “Initial fabrics and their relations to mechanical properties of granular material.” Soils Found., 12(1), 17–36.
Pradhan, T. B. S., Tatsuoka, F., and Hori, N. (1988). “Simple shear testing of sand in a torsional shear apparatus.” Soils Found., 28(2), 95–112.
Pyke, R., Seed, H. B., and Chan, C. K. (1975). “Settlement of sands under multidirectional shaking.” J. Geotech. Eng., 101(4), 379–398.
Roscoe, K. H. (1970). “The influence of strains in soil mechanics.” Géotechnique, 20(2), 129–170.
Seed, H. B. (1979). “Soil liquefaction and cyclic mobility evaluation for level ground during earthquakes.” J. Geotech. Eng. Div., 105(2), 201–215.
Seed, H. B., and Peacock, W. H. (1971). “Test procedures for measuring soil liquefaction characteristics.” J. Soil Mech. Found. Div., 97(8), 1099–1119.
Sivathayalan, S., and Logeswaran, P. (2007). “Behavior of sands under generalised drainage boundary conditions.” Can. Geotech. J., 44(2), 138–150.
Sivathayalan, S., and Logeswaran, P. (2008). “Experimental assessment of the response of sands under shear-volume coupled deformation.” Can. Geotech. J., 45(9), 1310–1323.
Sivathayalan, S., and Mehrabi Yazdi, A. (2014). “Influence of strain history on postliquefaction deformation characteristics of sands.” J. Geotech. Geoenviron. Eng., 04013019.
Sivathayalan, S., and Vaid, Y. P. (2002). “Influence of generalized initial state and principal stress rotation on the undrained response of sands.” Can. Geotech. J., 39(1), 63–76.
Stokoe, K. H., Hwang, S. K., Lee, N. J., and Andrus, R. D. (1994). “Effect of various parameters on the stiffness and damping of soils at small to medium strains.” Proc., First Int. Symp. of Pre-failure Deformation Characteristics of Geomaterials, S. Shibuya, T. Mitachi, and S. Miura, eds., A. A. Balkema, Rotterdam, Netherlands, 785–816.
Sully, J. P., and Campanella, R. G. (1992). “In situ shear wave velocity determination using seismic cone penetrometer for evaluating soil anisotropy.” Proc., Tenth World Conf. on Earthquake Engineering, A. A. Balkema, Rotterdam, Netherlands, 1269–1274.
Symes, M. J., Hight, D. W., and Gens, A. (1982). “Investigating anisotropy and the effects of principal stress rotation and of the intermediate principal stress using a hollow cylinder apparatus.” Proc., IUTAM Conf. on Deformation and Failure of Granular Materials, P. A. Vermeer and H. J. Luger, eds., 441–449.
Symes, M. J. P. R., Gens, A., and Hight, D. W. (1984). “Undrained anisotropy and principal stress rotation in saturated sand.” Géotechnique, 34(1), 11–27.
Symes, M. J. P. R., Shibuya, S., Hight, D. W., and Gens, A. (1985). “Liquefaction with cyclic principal stress rotation.” Proc., Eleventh Int. Conf. on Soil Mechanics and Foundation Engineering, Vol. 11, A. A. Balkema, Rotterdam, Netherlands, 1919–1922.
Tastan, E. O. (2009). “Effects of principal stress rotation and intermediate principal stress changes on the drained monotonic and undrained cyclic behavior of clean and non-plastic silty Ottawa sands formed underwater.” Ph.D. thesis, Colorado State Univ., Fort Collins, CO.
Tatsuoka, F., Nakamura, S., Huang, C. C., and Tani, K. (1990). “Strength anisotropy and shear band direction in plane strain tests of sand.” Soil Found., 30(1), 35–54.
Thomas, J. (1992). “Static, cyclic and post liquefaction undrained behaviour of Fraser River sand.” M.Sc. thesis, Univ. of British Columbia, Vancouver, BC, Canada.
Towhata, I., and Ishihara, K. (1985). “Undrained strength of sand undergoing cyclic rotation of principal stress axes.” Soils Found., 25(2), 135–147.
Uthayakumar, M. (1996). “Liquefaction of sands under multiaxial loading.” Ph.D. thesis, Univ. of British Columbia, Vancouver, BC, Canada.
Uthayakumar, M., and Vaid, Y. P. (1998). “Static liquefaction of sands under multiaxial loading.” Can. Geotech. J., 35(2), 273–283.
Vaid, Y. P., and Chern, J. C. (1985). “Cyclic and monotonic undrained response of saturated sands.” Proc., Advances in Testing Soils under Cyclic Conditions, V. Khosla, ed., ASCE, Reston, VA, 120–147.
Vaid, Y. P., Chung, E. K. F., and Kuerbis, R. H. (1990). “Stress path and steady state.” Can. Geotech. J., 27(1), 1–7.
Vaid, Y. P., and Sivathayalan, S. (1996). “Static and cyclic liquefaction potential of Fraser Delta sand in simple shear and triaxial tests.” Can. Geotech. J., 33(2), 281–289.
Vaid, Y. P., and Sivathayalan, S. (2000). “Fundamental factors affecting liquefaction susceptibility of sands.” Can. Geotech. J., 37(3), 592–606.
Vaid, Y. P., Sivathayalan, S., and Stedman, D. (1999). “Influence of specimen-reconstituting method on the undrained response of sand.” Geotech. Test. J., 22(3), 187–196.
Vaid, Y. P., Stedman, D., and Sivathayalan, S. (2001). “Confining stress and static shear effects in cyclic liquefaction.” Can. Geotech. J., 38(3), 580–591.
Yamada, Y., and Ishihara, K. (1979). “Anisotropic deformation characteristics of sand under three dimensional stress conditions.” Soils Found., 19(2), 79–94.
Yoshimine, M., Ozay, R., Sezen, A., and Ansal, A. (1999). “Undrained plane strain shear tests on saturated sand using a hollow cylinder torsional shear apparatus.” Soils Found., 39(2), 131–136.
Information & Authors
Information
Published In
Copyright
© 2014 American Society of Civil Engineers.
History
Received: Sep 16, 2013
Accepted: Oct 28, 2014
Published online: Dec 2, 2014
Published in print: Mar 1, 2015
Discussion open until: May 2, 2015
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.