Variation of Horizontal Pullout Capacity with Width of Vertical Anchor Plate
Publication: International Journal of Geomechanics
Volume 16, Issue 5
Abstract
The variation of pullout capacity of vertical strip anchor plates with width was studied while considering the effect of mean normal stress on the peak friction angle in a granular soil domain. This analysis was performed by using lower-bound finite-element limit analysis in conjunction with linear programing. The study was conducted for a wide range of anchor widths (B) and embedment depths (H) for both loose and dense sands. It was determined that the pullout capacity factor (Fγ = Pu/γBH) increases with decreasing values of normalized anchor width (γB/σA), where Pu is the ultimate pullout load; γ is the unit weight of soil mass; and σA is the atmospheric pressure. The rate of change for increments of Fγ with γB/σA was found to be more pronounced when the anchor is embedded in loose sand and at greater embedment depths.
Get full access to this article
View all available purchase options and get full access to this article.
References
Bolton, M. D. (1986). “The strength and dilatancy of sand.” Géotechnique, 36(1), 65–78.
Bolton, M. D. (1987). “Discussion: The strength and dilatancy of sand.” Géotechnique, 37(2), 219–226.
Bottero, A., Negre, R., Pastor, J., and Turgeman, S. (1980). “Finite element method and limit analysis theory for soil mechanics problem.” Comput. Methods Appl. Mech. Eng., 22(1), 131–149.
Das, B. M., and Seeley, G. R. (1975). “Breakout resistance of shallow horizontal anchors.” J. Geotech. Eng. Div., 101(9), 999–1003.
Davis, E. H. (1968). Theories of plasticity and failure of soil masses in soil mechanics: Selected topics, I. K. Lee, ed., Elsevier, New York, 341–354.
Dickin, E. A., and Leung, C. F. (1983). “Centrifugal model tests on vertical anchor plates.” J. Geotech. Eng., 1503–1525.
Fukushima, S., and Tatsuoka, F. (1984). “Strength and deformation characteristics of saturated sand at extremely low pressures.” Soils Found., 24(4), 30–48.
Hansen, J. B. (1970). “A revised and extended formula for bearing capacity.” Geoteknisk Inst. Bull., 28, 5–11.
Khatri, V. N., and Kumar, J. (2011a). “Uplift capacity of axially loaded piles in clays.” Int. J. Geomech., 23–28.
Khatri, V. N., and Kumar, J. (2011b). “Effect of anchor width on pullout capacity of strip anchors in sand.” Can. Geotech. J., 48(3), 511–517.
Kouzer, K., and Kumar, J. (2009). “Vertical uplift capacity of equally spaced horizontal strip anchors in sand.” Int. J. Geomech., 230–236.
Kumar, J. (2002). “Seismic horizontal pullout capacity of vertical anchors in sand.” Can. Geotech. J., 39(4), 982–991.
Kumar, J., and Khatri, V. N. (2008). “Effect of footing roughness on lower bound Nγ values.” Int. J. Geomech., 176–187.
Kumar, J., and Rao, M. V. B. K. (2004). “Seismic horizontal pullout capacity of shallow vertical anchors in sand.” Geotech. Geol. Eng., 22(3), 331–349.
Kumar, J., and Sahoo, J. P. (2012). “Upper bound solution for pullout capacity of vertical anchors in sand using finite elements and limit analysis.” Int. J. Geomech., 333–337.
Lancelot, L., Shahrour, I., and Al Mahmoud, M. (2006). “Failure and dilatancy properties of sand at relatively low stresses.” J. Eng. Mech., 1396–1399.
Lau, C. K., and Bolton, M. D. (2011a). “The bearing capacity of footings on granular soils. I: Numerical analysis.” Géotechnique, 61(8), 627–638.
Lau, C. K., and Bolton, M. D. (2011b). “The bearing capacity of footings on granular soils. II: Experimental evidence.” Géotechnique, 61(8), 639–650.
MATLAB R2012b [Computer software]. MathWorks, Natick, MA.
Merifield, R. S., and Sloan, S. W. (2006). “The ultimate pullout capacity of anchors in frictional soil.” Can. Geotech. J, 43(8), 852–868.
Meyerhof, G. G. (1973). “Uplift resistance of inclined anchors and piles.” Proc., 8th Int. Conf. Soil Mechanics and Foundation Engineering, Vol. 2, International Society for Soil Mechanics and Foundation Engineering, London, 167–172.
Murray, E. J., and Geddes, J. D. (1989). “Resistance of passive inclined anchors in cohesionless medium.” Géotechnique, 39(3), 417–431.
Neely, W. J., Stuart, J. G., and Graham, J. (1973). “Failure loads of vertical anchor plates in sand.” J. Soil Mech. Found. Div., 99(9), 669–685.
Ovesen, N. K. (1981). “Centrifuge tests on the uplift capacity of anchors.” Proc., 10th Int. Conf. Soil Mechanics and Foundation Engineering, Vol. 10, International Society for Soil Mechanics and Foundation Engineering, London, 717–722.
Rowe, R. K., and Davis, E. H. (1982). “The behaviour of anchor plates in sand.” Géotechnique, 32(1), 25–41.
Shiau, J. S., Merifield, R., Lyamin, A. V., and Sloan, S. W. (2011). “Undrained stability of footings on slopes.” Int. J. Geomech., 381–390.
Sloan, S. W. (1988). “Lower bound limit analysis using finite elements and linear programming.” Int. J. Numer. Anal. Methods Geomech., 12(1), 61–77.
Sloan, S. W. (2013). “Geotechnical stability analysis.” Géotechnique, 63(7), 531–572.
Information & Authors
Information
Published In
Copyright
© 2016 American Society of Civil Engineers.
History
Received: Mar 12, 2015
Accepted: Nov 20, 2015
Published online: Feb 8, 2016
Discussion open until: Jul 8, 2016
Published in print: Oct 1, 2016
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.