Anisotropy of Undrained Shear Strength Induced by Consolidation and Swelling in Cohesive Soils
Publication: International Journal of Geomechanics
Volume 14, Issue 4
Abstract
Strength anisotropy should be introduced into stability analyses, because the shear direction differs at each sliding point. However, few experiments evaluating the effects of anisotropic consolidation on undrained shear strength have been available for practical construction problems. Therefore, torsional shear tests were conducted on specimens consolidated and swollen in different directions to evaluate the anisotropy of undrained shear strength. Furthermore, to treat two-dimensional problems, the tests were also performed under the plane strain condition, where no radial strain occurs. Results show that the anisotropy of the undrained shear strength is closely related to the differences between consolidation and shearing in terms of directions and stress conditions. Finally, slope stability analyses were conducted to demonstrate how the anisotropy of the undrained shear strength obtained from the experiments can be practically used in field analyses.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
The experiments presented herein were conducted over a period of several years with the assistance of students from the Geotechnical Engineering Laboratory, Department of Civil and Environmental Engineering, Nagaoka University of Technology. The authors express their sincere appreciation for the students’ contributions to this study.
References
Arthur, J. R. F., Chua, K. S., and Dunstan, T. (1977). “Induced anisotropy in a sand.” Géotechnique, 27(1), 13–30.
Arthur, J. R. F., and Menzies, B. K. (1972). “Inherent anisotropy in a sand.” Géotechnique, 22(1), 115–128.
Bishop, A. W. (1955). “The use of the slip circle in the stability analysis of slopes.” Géotechnique, 5(1), 7–17.
Casagrande, A., and Carillo, N. (1944). “Shear failure of anisotropic materials.” J. Boston Soc. Civ. Eng., 31, 74–87.
Davis, E. H., and Christian, T. (1971). “Bearing capacity of anisotropic cohesive soil.” J. Soil Mech. and Found. Div., 97(5), 753–769.
Duncan, M., and Seed, H. B. (1966). “Anisotropy and stress reorientation in clay.” J. Soil Mech. and Found. Div., 92(5), 21–50.
Fukuda, F., Mitachi, T., and Shibuya, S. (1997). “Induced anisotropy appeared in the deformation and strength of remolded clay.” Soils Found., 37(4), 139–148 (in Japanese).
Hight, D. W., Gens, A., and Symes, M. J. (1983). “The development of a new hollow cylinder apparatus for investigating the effects of principal stress rotation in soils.” Géotechnique, 33(4), 355–383.
Hwang, J., Dewoolkar, M., and Ko, H.-Y. (2002). “Stability analysis of two-dimensional excavated slopes considering strength anisotropy.” Can. Geotech. J., 39(5), 1026–1038.
Itasca Consulting Group. (2000). FLAC version 4.0 user's guide, Minneapolis.
Juneja, A., Mir, B., and Roshan, N. (2013). “Effect of the smear zone around SCP improved composite samples tested in the laboratory.” Int. J. Geomech., 13(1), 16–25.
Kamei, T., Ogawa, S., and Tanaka, N. (1987). “The variation in undrained shear characteristics during consolidation process.” Soils Found., 27(3), 91–98.
Kinner, E. B., and Ladd, C. C. (1973). “Undrained bearing capacity of footing on clay.” Proc,. 8th Int. Conf. on Soil Mechanics and Foundation Engineering, Kluwer Academic Publishers, Dordrecht, Netherlands, 209–215.
Kurukulasuriya, L. C., Oda, M., and Kazama, H. (1999). “Anisotropy of undrained shear strength of an over-consolidated soil by triaxial and plane strain tests.” Soils Found., 39(1), 21–29.
Ladd, C. C., and Fott, R. (1974). “New design procedure for stability of soft clay.” J. Geotech. Engrg. Div., 100(7), 763–786.
Lo, K. Y. (1965). “Stability of slopes in anisotropic soils.” J. Soil Mech. Found. Div., 91(4), 85–106.
Mayne, P. W. (1985). “Stress anisotropy effects on clay strength.” J. Geotech. Engrg., 356–366.
Mikasa, M., Takada, N., and Ohshima, A. (1984). “Anisotropy of undrained strength of one-dimensionally consolidated clay and natural clay deposits.” Soil Mech. Found. Eng., 32(11), 25–30 (in Japanese).
Mitachi, T., and Kitago, S. (1979). “The influence of stress history and stress system on the stress-strain-strength properties of saturated clay.” Soils Found., 19(2), 45–61.
Nakase, A., and Kamei, T. (1983). “Undrained shear strength anisotropy of normally consolidated cohesive soils.” Soils Found., 23(1), 91–101.
Oda, M. (1972). “Initial fabrics and their relations to mechanical properties of granular material.” Soils Found., 12(1), 17–36.
Oda, M., Koishikawa, I., and Higuchi, T. (1978). “Experimental study of anisotropic shear strength of sand by plane strain test.” Soils Found., 18(1), 25–38.
Oda, M., and Konishi, J. (1974). “Microscopic deformation mechanism of granular material in simple shear.” Soils Found., 14(4), 25–38.
Skempton, A. W. (1954). “The pore-pressure coefficients and .” Géotechnique, 4(4), 143–147.
Tatsuoka, F., Sonoda, S., Hara, K., Fukushima, S., and Pradhan, T. B. S. (1986). “Failure and deformation of sand in torsional shear.” Soils Found., 26(4), 79–97.
Toyota, H., Nakamura, K., and Sakai, N. (2003). “Application of the elastic boundary induced by shear history on saturated cohesive soil.” Soils Found., 43(1), 93–100.
Toyota, H., Nakamura, K., and Sramoon, W. (2004). “Failure criterion of unsaturated soil considering tensile stress under three dimensional stress conditions.” Soils Found., 44(5), 1–13.
Toyota, H., Sakai, N., and Nakamura, K. (2001). “Mechanical properties of saturated cohesive soil with shear history under three dimensional stress conditions.” Soils Found., 41(6), 97–110.
Toyota, H., and Takada, S. (2012). “Technique for undrained triaxial tests on unsaturated soils using active control of pore-air pressure.” Geotech. Test. J., 35(3), 480–489.
Wang, L., Shen, K., and Ye, S. (2008). “Undrained shear strength of consolidated soft soils.” Int. J. Geomech., 105–113.
Wang, L., and Yin, Z. (2012). “Stress-dilatancy of natural soft clay under undrained creep condition.” Int. J. Geomech., (Nov. 8, 2012).
Yamada, Y., and Ishihara, K. (1979). “Anisotropic deformation characteristics of sand under three dimensional stress conditions.” Soils Found., 19(2), 79–94.
Information & Authors
Information
Published In
Copyright
© 2014 American Society of Civil Engineers.
History
Received: Feb 28, 2013
Accepted: Aug 5, 2013
Published online: Aug 7, 2013
Published in print: Aug 1, 2014
Discussion open until: Aug 28, 2014
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.