Numerical Solution of Single Pile Subjected to Simultaneous Torsional and Axial Loads
Publication: International Journal of Geomechanics
Volume 14, Issue 4
Abstract
Torsional loads on pile foundations are induced by the action of eccentric horizontal forces on the supporting structures. Such loading not only initiates twisting at the pile head but also reduces its axial capacity significantly with increased settlement of the foundation. Several theoretical and experimental investigations have already been carried out on piles under torsional load, as evidenced by the available literature on the subject, although contributions on the influence of combined torsional and axial loads on pile foundations are rather limited. This paper presents a novel numerical model (boundary-element method) to analyze the response of a single vertical floating pile subjected to simultaneous torsional and axial loads. The nonlinear stress-strain response of soil has been incorporated in the model by means of the hyperbolic model, whereas the pile material has been idealized as elastic–perfectly plastic. The effect of progressive pile-soil slippage at the interface is considered. Apart from predicting the load-displacement response and incremental angle of twist of piles under combined torsional and axial loading, the shear-stress profiles and the effect of vertical loads on the torsional capacity of the piles are some of the salient features captured by the proposed model. Validation of the proposed model by means of a comparison with existing models and experimental data indicates the suitability and accuracy of the solutions developed. The proposed model is also applied successfully to selected case studies on piles in clay, sand, and layered soil, and important conclusions are drawn.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
The authors gratefully acknowledge the partial financial support received from the Defence Research and Development Organization, Ministry of Defence, Government of India, to carry out this research.
References
American Petroleum Institute (API). (2000). “Recommended practice for planning: Designing and constructing fixed offshore platforms—Working stress design.” API RP2A, Washington, DC.
Azadi, M. R. E., Nordal, S., and Sadein, M. (2008). “Nonlinear behaviour of pile-soil subjected to torsion due to environmental loads on jacket type platforms.” J. WSEAS Trans. Fluid Mech. 4(4), 390–400.
Banerjee, S. (1995). “A theoretical study of peripheral shear stress, settlement, axial static and cyclic ultimate load of piles.” Master’s thesis, Jadavpur Univ., Kolkata, India.
Barker, R. M., and Puckett, J. A. (1997). Design of highway bridges: Based on AASHTO LRFD bridge design specification, Wiley, New York.
Basack, S. (2010). “A boundary element analysis on the influence of and on the performance of cyclically loaded single pile in clay.” Lat. Am. J. Solids Struct., 7(3), 265–284.
Basack, S., and Dey, S. (2012). “Influence of relative stiffness and load eccentricity on single pile response to lateral cyclic loading in sand.” Geotech. Geolog. Eng., 30(4), 737–751.
Basile, F. (2010). “Analysis and design of pile groups.” Numerical analysis and modeling in geomechanics, J. W. Bull, ed., Spon Press, London, 278–315.
Cai, Y., Changjie, G., and Wu, X. D. (2006). “Torsional response of pile embedded in a poroelastic medium.” Soil Dyn. Earthquake Eng., 26(12), 1143–1148.
Chow, Y. K. (1985). “Torsional response of piles in nonhomogeneous soil.” J. Geotech. Engrg., 942–947.
Duncan, J. M., and Chang, C. Y. (1970). “Nonlinear analysis of stress and strain of soil.” J. Soil Mech. and Found. Div., 96(5), 1629–1653.
Federal Highway Administration (FHWA). (2006). “A laboratory and field study of composite piles for bridge substructures.” FHWA-HRT-04-043, U.S. DOT, Washington, DC.
Georgiadis, M. (1987). “Interaction between torsional and axial pile responses.” Int. J. Numer. Anal. Methods Geomech., 11(6), 645–650.
Georgiadis, M., and Saflekou, S. (1990). “Piles under axial and torsional loads.” Comput. Geotech., 9(4), 291–305.
Guo, W. D., Chow, Y. K., and Randolph, M. F. (2007). “Torsional pile in two-layered nonhomogeneous soil.” Int. J. Geomech., 410–422.
Guo, W. D., and Randolph M. F. (1996). “Torsional piles in non-homogeneous media.” Comput. Geotech., 19(4), 265–287.
Hache, R. A. G., and Valsangkar, A. J. (1988). “Torsional resistance of single pile in layered soil.” J. Geotech. Engrg., 216–220.
Jaky, J. (1944). “The coefficient of earth pressure at rest.” J. Soc. Hung. Eng. Arch., 78(2), 355–358.
Jeremic, B., and Yang, J. (2002). “Template elastic-plastic computations in geomechanics.” Int. J. Numer. Anal. Methods Geomech., 26(14), 1407–1427.
Karthigeyan, S., Ramakrishna, V. V. G. S. T., and Rajagopal, K. (2007). “Numerical investigation of the effect of vertical load on the lateral response of piles.” J. Geotech. Geoenviron. Eng., 512–521.
Kong, L. (2006). “Behaviour of pile groups subjected to torsion.” Ph.D. thesis, Hong Kong Univ. of Science and Technology, Hong Kong.
Kong, L. G., and Zhang, L. M. (2007). “Centrifuge modeling of torsionally loaded pile groups.” J. Geotech. Geoenviron. Eng., 1374–1384.
Kulhawy, F. H. (1991). “Drilled shaft foundations.” Chapter 14, Foundation engineering handbook, 2nd Ed., H.-Y. Fang, ed., Van Nostrand Reinhold, New York.
Kulhawy, F. H., et al. (1983). “Transmission line structure foundations for uplift-compression loading.” Rep. No. EL-2870, Electric Power Research Institute, Palo Alto, CA.
Mattes, N. S., and Poulos, H. G. (1969). “Settlement of single compressible pile.” J. Soil Mech. and Found. Div., 95(1), 189–207.
Poulos, H. G. (1975). “Torsional response of piles.” J. Geotech. Engrg. Div., 101(10), 1019–1035.
Poulos, H. G. (1988). Marine geotechnics, Unwin Hyman, London.
Poulos, H. G., and Davis, E. H. (1980). Pile foundation analysis and design, Wiley, New York.
Randolph, M. F. (1981). “Piles subjected to torsion.” J. Geotech. Engrg. Div., 107(8), 1095–1111.
Randolph, M. F. (2003). “RATZ version 4-2: Load transfer analysis of axially loaded piles.” School of Civil and Resource Engineering, Univ. of Western Australia, Perth, Australia.
Randolph, M. F., and Wroth, C. P. (1978). “Analysis of vertical deformation of vertically loaded piles.” J. Geotech. Engrg. Div., 104(12), 1465–1488.
Timoshenko, S. P., and Goodier, J. N. (1970). Theory of elasticity, McGraw Hill, New York.
Trochanis, A. M., Bielak, J., and Christiano, P. (1991). “Three dimensional nonlinear study of piles.” J. Geotech. Engrg., 429–447.
Vickery, B. J. (1979). “Wind effects on building and structures: Critical unsolved problems.” Proc., IAHR/IUTAM Practical Experiences With Flow-Induced Vibrations Symp., International Association for Hydro-Environment Engineering and Research (IAHR)/International Union of Theoretical and Applied Mechanics (IUTAM), 823–828.
Wang, K., Zhang, Z., Leo, C. J., and Xie, K. (2007). “Dynamic torsional response of end bearing pile in saturated poroelastic medium.” Comput. Geotech., 35(3), 450–458.
Yang, Z., and Jeremic, B. (2002). “Numerical analysis of pile behavior under lateral loads in layered elastic-plastic soils.” Int. J. Numer. Anal. Methods Geomech., 26, 1385–1406.
Yang, Z., and Jeremic, B. (2005). “Study of soil layering effects on lateral loading behaviour of piles.” J. Geotech. Geoenviron. Eng., 762–770.
Zhang, L. (2010). “Nonlinear analysis of torsionally loaded piles in a two-layer soil profile.” Int. J. Geomech., 65–73.
Zhang, L. M., and Kong, L. G. (2006). “Centrifuge modelling of torsional response of piles in sand.” Can. Geotech. J., 43(5), 500–515.
Information & Authors
Information
Published In
International Journal of Geomechanics
Volume 14 • Issue 4 • August 2014
Copyright
© 2014 American Society of Civil Engineers.
History
Received: Aug 29, 2012
Accepted: Jun 4, 2013
Published online: Jun 6, 2013
Published in print: Aug 1, 2014
Discussion open until: Aug 19, 2014
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.