Exergetic Analysis of Triple-Level Pressure Combined Power Plant with Supplementary Firing
Publication: Journal of Energy Engineering
Volume 142, Issue 4
Abstract
This work presents a thermodynamic analysis of a triple-level pressure combined power plant with supplementary firing. The supplementary firing is a technological development for improving and increasing the output power of a combined-cycle (CC) power plant. In Mexico, there is a plant operating with this configuration, which generates a net power of 1,170 MW, with a power ratio of the gas turbine (GT) to the steam turbine (ST) of . This plant is composed of four combined-cycle units with supplementary firing, each providing an output power of 292.5 MW. The energetic and exergetic analyses of the combined cycle with and without supplementary firing are pursued, taking into account the combustion process of natural gas and humid air. These analyses are also carried out for the heat recovery steam generator, considering the waste gases of the gas turbine and of the supplementary firing as the energy sources. The obtained results are fuel, steam, and humid air flows; excess of air; gas and steam turbines output works and powers; thermal efficiencies; irreversibilities; and exergetic efficiencies of the main components of the plant. This analysis is carried out, considering the following ambient conditions: 23°C, 101.3 kPa (1.013 bar), and 90% relative humidity. The computed results show that the CC with supplementary firing increased the output power by 12.2% and the efficiency of the heat recovery steam generator by 2.07% although the thermal efficiency of the combined cycle decreased by 1.4% compared with the scenario without supplementary firing.
Get full access to this article
View all available purchase options and get full access to this article.
References
Ahmadi, P., and Dincer, I. (2011). “Thermodynamic analysis and thermoeconomic optimization of a dual pressure combined cycle power plant with a supplementary firing unit.” Energy Convers. Manage., 52(5), 2296–2308.
Arrieta, F. R. P., and Lora, E. E. S. (2005). “Influence of ambient temperature on combined-cycle power-plant performance.” Appl. Energy, 80(3), 261–272.
Bassily, A. M. (2007). “Modeling, numerical optimization, and irreversibility reduction of a triple-pressure reheat combined cycle.” Energy, 32(5), 778–794.
Bassily, A. M. (2008). “Cost numerical optimization of the triple-pressure steam-reheat gas-reheat gas-recuperated combined power cycle that uses steam for cooling the first GT.” J. Energy Res., 32(15), 1399–1417.
Bejan, A. (2006). Advanced engineering thermodynamics, Wiley, 204–225.
Carapellucci, R., and Milazzo, A. (2007). “Repowering combined cycle power plants by a modified STIG configuration.” Energy Convers. Manage., 48(5), 1590–1600.
CFE. (2013). “Programa de obras e inversiones del sector eléctrico, POISE 2013-2025.” Subdirección de programación, Mexico.
Cohen, H., Rogers, G., and Saravanamutto, H. (2008). Gas turbine theory, Prentice Hall, Great Britain, U.K., 46–94.
Datta, A., Mondal, S., and Gupta, S. D. (2008). “Perspectives for the direct firing of biomass as a supplementary fuel in combined cycle power plants.” Int. J. Energy Res., 32(13), 1241–1257.
Dincer, I., and Al-Muslim, H. (2001). “Thermodynamic analysis of reheat cycle steam power plants.” Int. J. Energy Res., 25(8), 727–739.
Edris, M. (2010). “Comparison between single-shaft and multi-shaft gas fired 800 MW combined cycle power plant.” Appl. Thermal Eng., 30(16), 2339–2346.
Facchini, B., Fiaschi, D., and Manfrida, G. (2000) “Exergy analysis of combined cycles using latest generation gas turbines.” J. Eng. Gas Turbines Power, 122(2), 233–238.
Finckh, H. H., and Pfost, H. (1992). “Development potential of combined-cycle (GUD) power plants with and without supplementary firing.” J. Eng. Gas Turbines Power, 114(4), 653–660.
Ganapathy, T., Alagumurth, N., Gakkhar, R. P., and Murugesan, K. (2009). “Exergy analysis of operating lignite fired thermal power plant.” J. Eng. Sci. Technolo. Rev., 2(1), 123–130.
Godoy, E., Benz, S. J., and Scenna, N. J. (2011). “A strategy for the economic optimization of combined cycle gas turbine power plants by taking advantage of useful thermodynamic relationships.” Appl. Therm. Eng., 31(5), 852–871.
Horlock, J. H. (1995). “Combined power plants—Past, present, and future.” J. Eng. Gas Turbines Power, 117(4), 608–616.
Kaushik, S. C., Reddy, V. S., and Tyagi, S. K. (2011). “Energy and exergy analyses of thermal power plants: A review.” Renewable Sustainable Energy Rev., 15(4), 1857–1872.
Kehlhofer, R. H., Warner, J., Nielsen, H., and Bachmann, R. (1999). Combined cycle gas and steam turbine power plant, Penn Well, 135–165.
Kotas, T. J. (2012). The exergy method of thermal plant analysis, Butterworth’s, London, 29–191.
Lee, J. J., Kim, Y. S., Cha, K. S., Sohn, J. L., and Joo, Y. J. (2009). “Influence of system integration options on the performance of an integrated gasification combined power plant.” Appl. Energy, 86(9), 1788–1796.
Moran, J., and Shapiro, N. (2008). Fundamentals of engineering thermodynamics, Wiley, 359–403.
Pasha, A., Jolly, S., and Vogt, H. (1995). “Combined cycle heat recovery steam generators optimum capabilities and selection criteria.” Heat Recovery Syst. CHP, 15(2), 147–154.
Rahim, M. A. (2012). “Combined cycle power plant performance analyses based on the single-pressure and multipressure heat recovery steam generator.” J. Energy Eng., 136–145.
Rahim, M. A. (2014). “Thermodynamic evaluation and parametric study of a combined cycle power plant: Application for Ankara city.” J. Energy Eng., 04013012.
Reddy, B. V., Chui, K. F., Gnanapragasam, N. V., and Prasad, R. C. (2009). “Energy and exergy analyses of a CFB-based indirectly fired combined cycle power generation system.” J. Energy Res., 33(15), 1309–1320.
Rosen, M. A., and Dincer, I. (2004). “A study of industrial steam process heating through exergy analysis.” J. Energy Res., 28(10), 917–930.
Sanjay, Y. (2013). “Exergy and energy analysis of combined cycle systems with different bottoming cycle configurations.” J. Energy Res., 37(8), 899–912.
Srinivas, T., and Reddy, B. V. (2014). “Comparative studies of augmentation in combined cycle power plants.” J. Energy Res., 38(9), 1201–1213.
Woudstra, N., Woudstra, T., Pirone, A., and Van Der Stelt, T. (2010). “Thermodynamic evaluation of combined cycle plants.” Energy Convers. Manage., 51(5), 1099–1110.
Information & Authors
Information
Published In
Copyright
© 2016 American Society of Civil Engineers.
History
Received: Apr 21, 2015
Accepted: Nov 30, 2015
Published online: Feb 25, 2016
Discussion open until: Jul 25, 2016
Published in print: Dec 1, 2016
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.