Energy Absorption Performance of Staggered Triangular Honeycombs under In-Plane Crushing Loadings
Publication: Journal of Engineering Mechanics
Volume 139, Issue 2
Abstract
The finite-element methodology is presented to evaluate the energy absorption performance of staggered triangular honeycombs under in-plane crushing loadings at impact velocities of 50–300 m/s. The minimum dynamic cushioning coefficient is proposed to characterize the maximum energy absorption efficiency of staggered triangular honeycombs. When all configuration parameters are constant, the energy absorption per unit volume is proportional to the square of the impact velocity; for a given impact velocity, the energy absorption per unit volume is related to the ratio of the cell wall thickness to the edge length by a power law and to the expanding angle by complicated analytical equations. The maximum energy absorption efficiency is insensitive to the impact velocity. Only for the smaller ratio of the cell wall thickness to the edge length does the maximum energy absorption efficiency increase with the increasing expanding angle. At a given impact velocity there is a threshold ratio of the cell wall thickness to the edge length. The maximum energy absorption efficiency decreases abruptly when the ratio is larger than the threshold. The threshold ratio is approximately equal to 0.04.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
This work is supported by the 111 Project (B07050), the National Natural Science Foundation of China (10925212, 90916027), 973 Program (2011CB610304), the Natural Science Foundation of Shaanxi Province (2010JQ1011), the Natural Foundation of Education Department of Shaanxi (11JK0534), Initial Research Foundation of Shaanxi University of Science and Technology for Ph.D. (BJ12-15), and Initial Research Foundation of Xi’an University of Technology for Ph.D. (104-211004).
References
Ali, M., Qamhiyah, A., Flugrad, D., and Shakoor, M. (2008). “Theoretical and finite element study of a compact energy absorber.” Adv. Eng. Software, 39(2), 95–106.
Gao, X.-L. (1994). “An exact elasto-plastic solution for a thick-walled spherical shell of elastic linear-hardening material with finite deformations.” Int. J. Pressure Vessels Piping, 57(1), 45–56.
Gao, X.-L. (2007). “Strain gradient plasticity solution for an internally pressurized thick-walled cylinder of an elastic linear-hardening material.” Z. Angew. Math. Phys., 58(1), 161–173.
Gibson, L. J., and Ashby, M. F. (1997). Cellular solids: Structures and properties, 2nd Ed., Cambridge University Press, Cambridge, U.K.
Grenestedt, J. L. (1999). “Effective elastic behavior of some models for perfect cellular solids.” Int. J. Solids Struct., 36(10), 1471–1501.
Harrigan, J. J., Reid, S. R., and Peng, C. (1999). “Inertia effects in impact energy absorbing materials and structures.” Int. J. Impact Eng., 22(9–10), 955–979.
Hohe, J., and Becker, W. (1999a). “Effective elastic properties of triangular grid structures.” Compos. Struct., 45(2), 131–145.
Hohe, J., Beschorner, C., and Becker, W. (1999b). “Effective elastic properties of hexagonal and quadrilateral grid structures.” Compos. Struct, 46(1), 73–89.
Hönig, A., and Stronge, W. J. (2002a). “In-plane dynamic crushing of honeycomb. Part I: Crush band initiation and wave trapping.” Int. J. Mech. Sci., 44(8), 1665–1696.
Hönig, A., and Stronge, W. J. (2002b). “In-plane dynamic crushing of honeycomb. Part II: Application to impact.” Int. J. Mech. Sci., 44(8), 1697–1714.
Hu, L. L., and Yu, T. X. (2010). “Dynamic crushing strength of hexagonal honeycombs.” Int. J. Impact Eng., 37(5), 467–474.
Li, K., Gao, X.-L., and Wang, J. (2007). “Dynamic crushing behavior of honeycomb structures with irregular cell shapes and non-uniform cell wall thickness.” Int. J. Solids Struct., 44(14–15), 5003–5026.
Liu, Y., and Zhang, X. C. (2009). “The influence of cell micro-topology on the in-plane dynamic crushing of honeycombs.” Int. J. Impact Eng., 36(1), 98–109.
Liu, Y. D., Yu, J. L., Zheng, Z. J., and Li, J. R. (2009). “A numerical study on the rate sensitivity of cellular metals.” Int. J. Solids Struct., 46(22–23), 3988–3998.
Papka, S. D., and Kyriakides, S. (1994). “In-plane compressive response and crushing of honeycombs.” J. Mech. Phys. Solids, 42(10), 1499–1532.
Papka, S. D., and Kyriakides, S. (1998). “Experiments and full-scale numerical simulations of in-plane crushing of a honeycombs.” Acta Mater., 46(8), 2765–2776.
Papka, S. D., and Kyriakides, S. (1999a). “Biaxial crushing of honeycombs. Part I: Experiments.” Int. J. Solids Struct., 36(29), 4367–4396.
Papka, S. D., and Kyriakides, S. (1999b). “In-plane biaxial crushing of honeycombs. Part II: Analysis.” Int. J. Solids Struct., 36(29), 4397–4423.
Peng, G. (1999). Fundamentals of transportation packaging, Graphic Communication Press, Beijing (in Chinese).
Reid, S. R., and Peng, C. (1997). “Dynamic uniaxial crushing of wood.” Int. J. Impact Eng., 19(5–6), 531–570.
Ruan, D., Lu, G., Wang, B., and Yu, T. X. (2003). “In-plane dynamic crushing of honeycombs—A finite element study.” Int. J. Impact Eng., 28(2), 161–182.
Sun, D., and Zhang, W. (2009). “Mean in-plane plateau stresses of hexagonal honeycomb cores under impact loadings.” Compos. Struct., 91(2), 168–185.
Sun, D., Zhang, W., and Wei, Y. (2010). “Mean out-of-plane dynamic plateau stresses of hexagonal honeycomb cores under impact loadings.” Compos. Struct., 92(11), 2609–2621.
Tan, P. J., Reid, S. R., Harrigan, J. J., Zou, Z., and Li, S. (2005). “Dynamic compressive strength properties of aluminum foams. Part II—‘Shock’ theory and comparison with experimental data and numerical models.” J. Mech. Phys. Solids, 53(10), 2206–2230.
Wang, A. J., and McDowell, D. L. (2004). “In-plane stiffness and yield strength of periodic metal honeycombs.” J. Eng. Mater. Technol., 126(2), 137–156.
Wang, A.-J., and McDowell, D. L. (2005). “Yield surfaces of various periodic metal honeycombs at intermediate relative density.” J. Eng. Mater. Technol., 21(2), 285–320.
Zheng, Z., Yu, J., and Li, J. (2005). “Dynamic crushing of 2D cellular structures—A finite element study.” Int. J. Impact Eng., 32(1–4), 650–664.
Zhu, H. X., and Mills, N. J. (2000). “The in-plane non-linear compression of regular honeycombs.” Int. J. Solids Struct., 37(13), 1931–1949.
Information & Authors
Information
Published In
Copyright
© 2013 American Society of Civil Engineers.
History
Received: Apr 15, 2011
Accepted: May 16, 2012
Published online: May 18, 2012
Published in print: Feb 1, 2013
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.