Pneumatically Agitated High-Density Polyethylene Mesh–Based Bioreactor Developed for Wastewater Treatment
Publication: Journal of Environmental Engineering
Volume 144, Issue 5
Abstract
The use of woven and nonwoven fibers and meshes in membrane bioreactors (MBRs) has enhanced the study of the development of dynamic membranes, which aid to a large extent in overcoming the traditional problem of fouling associated with MBRs. The present study reports the mixing characteristics and the gas–liquid mass transfer characteristics of a pneumatically agitated high-density polyethylene (HDPE) mesh–based bioreactor developed for wastewater treatment. The HDPE mesh is not a material traditionally used in MBRs. The pore size of the mesh used in the study, 2 mm, has not been reported on for the development of self-forming dynamic membranes. The reactor was configured in a novel way by integrating the mesh into the reactor. Aeration was provided at the bottom for meeting the oxygen requirements and obtaining maximum mixing. The mixing characteristics and the mass transfer coefficients were determined at various superficial air velocities. The reactor exhibited excellent mixing characteristics at a superficial air velocity of 3.79 cm/min and possessed the optimum gas–liquid mass transfer coefficient. The reactor was modeled to tanks-in-series and extended tanks-in-series models. The reactor was then used for nitrification of ammonia wastewater. The treatment efficiency was recorded to be around 98%.
Get full access to this article
View all available purchase options and get full access to this article.
References
An, Y., Wang, Z., Wu, Z., Yang, D., and Zhou, Q. (2009). “Characterization of membrane foulants in an anaerobic non-woven fabric membrane bioreactor for municipal wastewater treatment.” Chem. Eng. J., 155(3), 709–715.
APHA (American Public Health Association). (2005). Standard methods for the examination of water and wastewater, 21st Ed., Washington, DC, 5.14–5.19.
Burrows, L. J., Stokes, A., West, J. R., Forster, C. F., and Martin, A. D. (1999). “Evaluation of different analytical methods for tracer studies in aeration lanes of activated sludge plants.” Water Res., 33(2), 367–374.
Clifford, E., Nielsen, M., Sørensen, K., and Rodgers, M. (2010). “Nitrogen dynamics and removal in a horizontal flow biofilm reactor for wastewater treatment.” Water Res., 44(13), 3819–3828.
De Nardi, I. R., Zaiat, M., and Foresti, E. (1999). “Influence of the tracer characteristics on hydrodynamic models of packed-bed bioreactors.” Bioprocess Eng., 21(5), 469–476.
Dinçer, A. R., and Kargi, F. (2000). “Kinetics of sequential nitrification and denitrification processes.” Enzyme Microb. Technol., 27(1–2), 37–42.
Doran, P. M. (1995). Bioprocess engineering principles, Academic Press, London.
Ersahin, E. M., Ozgun, H., Dereli, K. R., Ozturk, I., Roest, K., and Van Lier, J. B. (2012). “A review on dynamic membrane filtration: Materials, applications and future perspectives.” Bioresour. Technol., 122, 196–206.
Ersahin, M. E., Tao, Y., Ozgun, H., Spanjers, H., and Van Lier, J. B. (2016). “Characteristics and role of dynamic membrane layer in anaerobic membrane bioreactors.” Biotechnol. Bioeng., 113(4), 761–771.
Gander, M., Jefferson, B., and Judd, S. (2000). “Aerobic MBRs for domestic wastewater treatment: A review with cost considerations.” Sep. Purif. Technol., 18(2), 119–130.
Garcia-Ochoa, F., and Gomez, E. (2009). “Bioreactor scale-up and oxygen transfer rate in microbial processes: An overview.” Biotechnol. Adv., 27(2), 153–176.
Germain, E., et al. (2007). “Biomass effects on oxygen transfer in membrane bioreactors.” Water Res., 41(5), 1038–1044.
Harraz, A. A., et al. (2015). “Liquid–solid mass transfer behaviour of a fixed bed airlift reactor.” Biochem. Eng. J., 103, 1–11.
Kiso, Y., et al. (2005). “Coupling of sequencing batch reactor and mesh filtration: Operational parameters and wastewater treatment performance.” Water Res., 39(20), 4887–4898.
Leon, M. A., Nijhuis, T. A., Van Der Schaaf, J., and Schouten, J. C. (2014). “Residence time distribution and reaction rate in the horizontal rotating foam stirrer reactor.” Chem. Eng. Sci., 117, 8–17.
Levenspiel, O. (2007). Chemical reaction engineering, 3rd Ed., Wiley, New Delhi, India, 255–338.
Liu, H., Yang, F., Wang, T., Liu, Q., and Hu, S. (2007). “Carbon membrane-aerated biofilm reactor for synthetic wastewater treatment.” Bioprocess Biosyst. Eng., 30(4), 217–224.
Meng, F., Chae, S., Drews, A., Kraume, M., and Shin, H. (2009). “Recent advances in membrane bioreactors (MBRs): Membrane fouling and membrane material.” Water Res., 43(6), 1489–1512.
Miron, A. S., Garcia, M.-C. C., Camacho, F. G., Grima, E. M., and Chisti, Y. (2004). “Mixing in bubble column and airlift reactors.” Chem. Eng. Res. Des., 82(10), 1367–1374.
Olivet, D., Valls, J., Gordillo, A. M., Freixo, A., and Sanchez, A. (2005). “Application of residence time distribution technique to the study of the hydrodynamic behaviour of a full-scale wastewater treatment plant plug-flow bioreactor.” J. Chem. Technol. Biotechnol., 80(4), 425–432.
Poostchi, A. A., Mehrnia, M. R., Rezvani, F., and Sarrafzadeh, M. H. (2012). “Low-cost mono filament mesh filter used in membrane bioreactor process: Filtration characteristics and resistance analysis.” Desalination, 286, 429–435.
Rahimi, Y., Torabian, A., Mehrdadi, N., and Shahmoradi, B. (2011). “Simultaneous nitrification-denitrification and phosphorus removal in a fixed bed sequencing batch reactor (FBSBR).” J. Hazard. Mater., 185(2–3), 852–857.
Rodríguez, F. A., Reboleiro-Rivas, P., Osorio, F., Martínez-Toledo, M. V., Hontoria, E., and Poyatos, J. M. (2012). “Influence of mixed liquid suspended solids and hydraulic retention time on oxygen transfer efficiency and viscosity in a submerged membrane bioreactor using pure oxygen to supply aerobic conditions.” Biochem. Eng. J., 60, 135–141.
Sivasubramanian, V. (2009). “Gas–liquid mass transfer in three-phase inverse fluidized bed reactor with Newtonian and non-Newtonian fluids.” Asia-Pac. J. Chem. Eng., 5(2), 361–368.
Swaine, D. E., and Daugulis, A. J. (1988). “Review of liquid mixing in packed bed biological reactors.” Biotechnol. Progress, 4(3), 134–148.
Walters, E., Hille, A., He, M., Ochmann, C., and Horn, H. (2009). “Simultaneous nitrification/denitrification in a biofilm airlift suspension (BAS) reactor with biodegradable carrier material.” Water Res., 43(18), 4461–4468.
Wang, Y., Brannock, M., and Leslie, G. (2009). “Diagnosis of membrane bioreactor performance through residence time distribution measurements: A preliminary study.” Desalination, 236(1–3), 120–126.
Yu, Z., Chu, H., Cao, D., Ma, Y., Dong, B., and Wei, Y. (2012). “Pilot-scale hybrid bio-diatomite/dynamic membrane reactor for slightly polluted raw water purification.” Desalination, 285, 73–82.
Information & Authors
Information
Published In
Journal of Environmental Engineering
Volume 144 • Issue 5 • May 2018
Copyright
©2018 American Society of Civil Engineers.
History
Received: Jun 11, 2017
Accepted: Sep 26, 2017
Published online: Feb 19, 2018
Published in print: May 1, 2018
Discussion open until: Jul 19, 2018
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.