Modeling Concentrations of Air Toxics near Intersections and Freeways in Florida
Publication: Journal of Environmental Engineering
Volume 140, Issue 1
Abstract
This paper reports on the results of dispersion modeling of mobile source air toxics (MSATs) near seven intersections and seven freeway segments in the state of Florida. Different modeling approaches were used, all with the focus on a hot-spot analysis to obtain the worst-case (highest) 1-h concentration. To accomplish the worst-case modeling, the CAL3QHC model was modified to handle inputs of several individual MSATs and to predict the concentrations of these MSATs around roadways. Real-world data (traffic volumes and site geometry) were gathered, meteorological input data were selected, and mobile source emission factors (EFs) were obtained from the U.S. EPA’s mobile-source emissions model, MOVES2010a. Based on a literature search of short-term effects, maximum acceptable concentrations (MACs) for a 1-h averaging time were proposed for comparison with the modeled results. Results from this study indicate that for all of the intersections and freeway segments, the worst-case 1-h modeled concentrations of the MSATs were several orders of magnitude below the proposed short-term MACs. It is recognized that long-term exposures and chronic health effects are a major concern associated with MSATs. With this in mind, additional modeling (using CAL3QHCR and AERMOD) was conducted to show how the prediction of long-term concentrations could potentially be addressed.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
The authors gratefully acknowledge the financial support of the State of Florida Department of Transportation (FDOT) and the help and guidance of the project officer Mr. Mariano Berrios. We also acknowledge the excellent help of Dr. Michael Claggett. The opinions, findings, and conclusions expressed in this publication are those of the authors and not endorsed by the FDOT.
References
Abdul-Wahab, S. (2004). “An application and evaluation of the CAL3QHC model for predicting carbon monoxide concentrations from motor vehicles near a roadway intersection in Muscat, Oman.” Environ. Manage., 34(3), 372–382.
Benson, P. E. (1979). “CALINE3—A versatile dispersion model for predicting air pollutant levels near highways and arterial streets.”, Federal Highway Administration, Washington, DC.
Black, K., Martinez, V., Gaber, M., Bauldauf, R., Thoma, E., and Costa, D. L. (2009). “Study design to evaluate mobile source air toxics compounds in the near-roadway environment.” Proc., 102nd Annual Conf. and Exhibition, Air & Waste Management Association, Pittsburgh.
Carr, E. L., Ernst, D. A., Rosenbaum, A., Glass, G., and Hartley, S. (2007). “Analyzing, documenting, and communicating the impacts of mobile source air toxic emissions in the NEPA process.” AASHTO, Fairfax, VA.
Chen, H., Bai, S., Eisinger, D., Niemeier, D., and Claggett, M. (2008). “Modeling uncertainties and near-road : A comparison of CALINE4, CAL3QHC, and AERMOD.” Caltrans Air Quality Project, Univ. of California Davis, Sacramento, CA.
Claggett, M., and Bai, S. (2012). “Compaing predictions from the CAL3QHCR and AERMOD Models for Highway Applications.” Proc., 92nd Annual Meeting, Transportation Research Board, Washingtion, DC.
Cohn, L. F., and McVoy, G. R. (1982). Environmental analysis of transportation systems, Wiley, New York.
Cooper, C. D. (1987). “Indirect source impact analysis-carbon monoxide modeling.” J. Air Pollut. Control Assoc., 37(11), 1308–1313.
Cooper, C. D., and Alley, F. C. (2011). Air pollution control, 4th Ed., Waveland Press, Long Grove, IL.
Cooper, C. D., Leftwich, D. S., and Liu, P. S. (1989). “Persistence factors for carbon monoxide modeling near intersections.” Proc., 82nd Annual Meeting and Exhibition, Air & Waste Management Association, Pittsburgh.
Cooper, C. D., Malone, L. C., and Liu, P. S. (1992). “Identifying worst case persistence factors for carbon monoxide modeling near intersections in Orlando, Florida.” J. Air Waste Manage. Assoc., 42(11), 1461–1465.
Federal Highway Administration (FHWA). (2011). “FHWA MSAT study: US 95 settlement agreement.” 〈http://www.fhwa.dot.gov/environment/air_quality/air_toxics/research_and_analysis/near_road_study/annrpt11.cfm〉 (Sep. 25, 2012).
Federal Highway Administration (FHWA). (2012). “Information: Interim guidance on mobile source air toxic analysis in NEPA.” 〈http://www.fhwa.dot.gov/environment/air_quality/air_toxics/policy_and_guidance/aqintguidmem.cfm〉 (Jan. 4, 2013).
Florida Dept. of Environmental Protection (FDEP). (2004). “Guidelines for evaluating the air quality impacts of indirect sources.” Division of Air Resources Management, Tallahassee, FL.
Florida Dept. of Transportation (FDOT). (2011). “Modeling of concentrations of MSATs (mobile source air toxics) along highways and near intersections in Florida.” Tallahassee, FL.
Health Effects Institute (HEI). (2007). “Mobile-source air toxics: A critical review of the literature on exposure and health effects.” Special Rep. 16, Air Toxics Review Panel, Boston.
Kimbrough, S., et al. (2013). “Long-term continuous measurment of near-road air pollution in Las Vegas: Seasonal variability in traffic emissions impact on local air quality.” Air Qual. Atmos. Health, 6(1), 295–305.
Schewe, G. J., and Smith, P. J. (2009). Sensitivity of AERMOD in modeling fugitive dust emission sources, Trinity Consultants, Covington, KY.
Strum, M., et al. (2006). “Projection of hazardous air pollutant emissions to future years.” Sci. Total Environ., 366(2–3), 590–601.
Tam, B. N., and Neumann, C. M. (2004). “A human health assessment of hazardous air pollutants in Portland, OR.” J. Environ. Manage., 73(2), 131–145.
Thullier, R. H. (1978). Air quality considerations in residential planning, Vol. 3: Scientific support and documentation, U.S. Dept. of Housing and Urban Development, Washington, DC.
Transportation Research Board. (2012). “NCHRP 25-25 task 70: Assessment of quantitative mobile source air toxics in environmental documents.” Cambridge Systematics, Inc., Cambridge, MA.
U.S. Dept. of Health, and Human Services (USDHHS). (2010). “Agency for toxic substances and disease registry (ATSDR).” 〈http://www.atsdr.cdc.gov〉 (May 2, 2012).
U.S. Environmental Protection Agency (USEPA). (1992a). “Guideline for modeling carbon monoxide from roadway intersections.”, Research Triangle Park, NC.
U.S. Environmental Protection Agency (USEPA). (1992b). “Screening procedures for estimating the air quality impact of stationary sources, revised.”, Research Triangle Park, NC.
U.S. Environmental Protection Agency (USEPA). (1995a). “Addendum to the user’s guide to CAL3QHC version 2.0 (CAL3QHCR user’s guide).” Research Triangle Park, NC.
U.S. Environmental Protection Agency (USEPA). (1995b). “User’s guide for the industrial source complex (ISC3) dispersion models: Volume II—Description of model algorithms.”, Research Triangle Park, NC.
U.S. Environmental Protection Agency (USEPA). (2001). “Control of emissions of hazardous air pollutants from mobile sources.” 40 CFR Parts 80 and 86, Final Rule, 66 FR 61,17230-17273, Washington, DC.
U.S. Environmental Protection Agency (USEPA). (2004). “User’s guide for the AMS/EPA regulatory model-AERMOD.”, Research Triangle Park, NC.
U.S. Environmental Protection Agency (USEPA). (2006). “The master list of compounds emitted by mobile sources—2006.”, Washington, DC.
U.S. Environmental Protection Agency (USEPA). (2007). “Control of emissions of hazardous air pollutants from mobile sources.” 40 CFR Parts 59, 80, 85 and 86, Final Rule, 72 FR 37,8428-8570, Washington, DC.
U.S. Environmental Protection Agency (USEPA). (2010a). “Integrated risk information system (IRIS).” 〈http://www.epa.gov/IRIS/〉 (Apr. 20, 2012).
U.S. Environmental Protection Agency (USEPA). (2010b). “Technical guidance on the use of MOVES2010 for emission inventory preparation in state implementation plans and transportation conformity.”, Washington, DC.
U.S. Environmental Protection Agency (USEPA). (2010c). “Toxic air pollutants.” 〈http://www.epa.gov/oar/toxicair/〉 (Apr. 25, 2012).
U.S. Environmental Protection Agency (USEPA). (2010d). “Transportation conformity guidance for quantitative hot-spot analyses in and nonattainment and maintenance areas.”, Washington, DC.
U.S. Environmental Protection Agency (USEPA). (2012a). “2005 national-scale air toxics assessment.” 〈http://www.epa.gov/ttn/atw/nata2005/index.html〉 (Sep. 30, 2012).
U.S. Environmental Protection Agency (USEPA). (2012b). “Acute exposure guideline levels (AEGLs).” 〈http://www.epa.gov/oppt/aegl/〉 (Sep. 22, 2012).
U.S. Environmental Protection Agency (USEPA). (2012c). “Dose-response assessment for assessing health risks associated with exposure to hazardous air pollutants.” 〈http://www.epa.gov/ttn/atw/toxsource/summary.html〉 (Sep. 22, 2012).
U.S. Environmental Protection Agency (USEPA). (2012d). “Motor vehicle emission simulator (MOVES): User guide version, MOVES2010b.”, Washington, DC.
U.S. Environmental Protection Agency (USEPA). (2012e). “MOVES2010b: Additional toxics added to MOVES.”, Washington, DC.
Venkatram, A., Isakov, V., Seila, R., and Baldauf, R. (2009). “Modeling the impacts of traffic emissions on air toxics concentrations near roadways.” Atmos. Environ., 43(20), 191–199.
Wayson, R. (2012). “Using AERMOD for highway projects.” Proc., 105th Annual Conf. and Exhibition, Air & Waste Management Association, Pittsburgh.
Information & Authors
Information
Published In
Journal of Environmental Engineering
Volume 140 • Issue 1 • January 2014
Pages: 92 - 99
Copyright
© 2014 American Society of Civil Engineers.
History
Received: Jan 23, 2013
Accepted: Jul 9, 2013
Published online: Dec 16, 2013
Published in print: Jan 1, 2014
Discussion open until: May 16, 2014
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.