Comparison of Chlorine and Chloramines on Lead Release from Copper Pipe Rigs
Publication: Journal of Environmental Engineering
Volume 139, Issue 8
Abstract
The objective of this study was to assess lead release in a pipe rig system that was disinfected with either chloramines or free chlorine. The study was carried out using pipe loops and copper pipe rigs that had lead solder, which provided the only source of lead. The water quality of the treated water had a low alkalinity ( as ), neutral pH, and low hardness ( as ). However, the study used a corrosion control program that consisted of dosing with 0.8-mg of zinc orthophosphate and controlling the pH to 7.3, that was consistent with the corrosion-control program operated in the host water treatment plant. Key findings from the study confirmed that chloramines would result in lead release under the current corrosion-control program, whereas free chlorine was not as compromising. Lead concentrations were approximately an order of magnitude lower in the free chlorine system than the chloramine systems. In this study, chloramines with a target residual concentration of released and following stagnation times of 24 h and 30 min, respectively. Furthermore, chloramines with a target residual concentration of resulted in a lead release of and following a stagnation time of 24 h and 30 min, respectively. By comparison, the pipe rigs that were dosed with a free chlorine target residual concentration of had lead concentrations of and for the 24-h and 30-min stagnation times. This project demonstrates that care needs to be taken when evaluating secondary disinfectants, particularly for those water systems having a low dissolved inorganic carbon concentration.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
The authors thank Halifax Water and the Natural Sciences and Engineering Resource Council of Canada (NSERC) for financial support to the NSERC/Halifax Water Industrial Research Chair. Additional funding support for this project was obtained from the Canadian Water Network (CWN). Additionally, the authors also acknowledge and thank research support staff at Dalhousie University (Halifax, Nova Scotia, Canada), specifically Heather Daurie, and at the J.D. Kline Water Supply Plant (Halifax, Nova Scotia, Canada).
References
Arnold, R. B., and Edwards, M. (2012). “Potential Reversal and the Effects of Flow Pattern on Galvanic Corrosion of Lead.” Environ. Sci. Technol., 46(20), 10941–10947.
AWWARF. (1996). Internal corrosion of water distribution systems, 2nd Ed., American Water Works Association Research Foundation, Denver.
Berthouex, P. M., and Brown, L. C. (2002). Statistics for environmental engineers, 2nd Ed., Lewis Publishers, Boca Raton, FL.
Boulay, N., and Edwards, M. (2001). “Role of temperature, chlorine, and organic matter in copper corrosion by-product release in soft water.” Water Res., 35(3), 683–690.
Boyd, G. R., Shetty, P., Sandvig, A. M., and Pierson, G. L. (2004). “Lead in tap water following simulated partial lead pipe replacements.” J. Environ. Eng., 130(10), 1188–1197.
Cartier, C., Arnold, R. B., Triantafyllidou, S., Prevost, M., and Edwards, M. (2012). “Effect of flow rate and lead/copper pipe sequence on lead release from service lines.” Water Res., 46(13), 4142–4152.
Churchill, D. M., Mavinic, D. S., Neden, D. G., and MacQuarrie, D. M. (2000). “The effect of zinc orthophosphate and pH–alkalinity adjustment on metal levels leached into drinking water.” Can. J. Civ. Eng., 27(1), 33–43.
Deshommes, E., Laroche, L., Nour, S., Cartier, C., and Prévost, M. (2010). “Source and occurrence of particulate lead in tap water.” Water Res., 44(12), 3734–3744.
Dryer, D. J., and Korshin, G. V. (2007). “Investigation of the reduction of lead dioxide by natural organic matter.” Environ. Sci. Technol., 41(15), 5510–5514.
Edwards, M., and Dudi, A. (2004). “Role of chlorine and chloramine in corrosion of lead-bearing plumbing materials.” J. Am. Water Works Assoc., 96(10), 69–81.
Eisnor, J. D., and Gagnon, G. A. (2003). “A framework for the implementation and design of piot-scale distribution systems.” J. Water Supply: Res. Technol.–AQUA, 52(7), 501–519.
Eisnor, J. D., and Gagnon, G. A. (2004). “Impact of secondary disinfection on corrosion in a model distribution system.” J. Water Supply: Res. Technol.–AQUA, 53(7), 441–452.
Gagnon, G. A., and Doubrough, J. D. (2011). “Lead release from premise plumbing: a profile of sample collection and pilot studies from a small system.” Can. J. Civ. Eng., 38(7), 741–750.
Gagnon, G. A., et al. (2008). “Disinfectant efficacy in distribution systems: a pilot-scale assessment.” J. Water Supply: Res. Technol.–AQUA, 57(7), 507–518.
Halifax Water. (2010). Halifax Water, 14th Annual Rep., Halifax Water, Halifax, NS.
Hozalski, R. M., Esbri-Amador, E., and Chen, C. R. (2005). “Comparison of stannous chloride and phosphate for lead corrosion control.” J. Am. Water Works Assoc., 97(3), 89–103.
Kim, E. J., Herrera, J. E., Huggins, D., Braam, J., and Koshowski, S. (2011). “Effect of pH on the concentrations of lead and trace contaminants in drinking water: A combined batch, pipe loop and sentinel home study.” Water Res., 45(9), 2763–2774.
Knowles, A. D., MacKay, J., and Gagnon, G. A. (2012). “Pairing a pilot plant to a direct filtration water treatment plant.” Can. J. Civ. Eng., 39(6), 698–700.
Knox, G., Mavinic, D., Atwater, J., and MacQuarrie, D. (2005). “Assessing the impact of corrosion control measures on tap drinking of the Greater Vancouver Regional District.” Can. J. Civ. Eng., 32(5), 948–956.
Korshin, G. V., Ferguson, J. F., and Lancaster, A. N. (2000). “Influence of natural organic matter on the corrosion of leaded brass in potable water.” Corrosion Sci., 42(1), 53–66.
Lamsal, R., Montreuil, K. R., Kent, F. C., Walsh, M. E., and Gagnon, G. A. (2012). “Characterization and removal of natural organic matter by an integrated membrane system.” Desalination, 303, 12–16.
Lin, Y. P., and Valentine, R. L. (2008). “Release of Pb(II) from monochloramine—mediated reduction of lead oxide ().” Environ. Sci. Technol., 42(24), 9137–9143.
Lintereur, P. A., Duranceau, S. J., Taylor, J. S., and Stone, E. D. (2010). “Sodium silicate impacts on lead release in a blended potable water distribution system.” Desalination and Water Treatment, 16(1–3), 427–438.
Maddison, L. A., Gagnon, G. A., and Eisnor, J. D. (2001). “Corrosion control strategies for the Halifax regional distribution system.” Can. J. Civ. Eng., 28(2), 305–313.
McDonald, B., MacDonald, J., and Gagnon, G. A. (2006). “Haloacetic acid occurrence in drinking water in Nova Scotia and the implications for small treatment systems.” Proc., 12th Nation. Drinking Water Conf., Canadian Water and Wastewater Association (CWWA), Ottawa, ON.
McNeill, L. S., and Edwards, M. (2004). “Importance of Pb and Cu particulate species for corrosion control.” J. Environ. Eng., 130(2), 136–144.
Nadagouda, M. N., Schock, M. R., Metz, D. H., DeSantis, M. K., Lytle, D., and Welch, M. (2009). “Effect of phosphate inhibitors on the formation of lead phosphate/carbonate nanorods, microrods, and dendritic structures.” Cryst. Growth Des., 9(4), 1798–1805.
Nguyen, C. K., Clark, B. N., Stone, K. R., and Edwards, M. (2011). “Acceleration of galvanic lead solder corrosion due to phosphate.” Corrosion Sci., 53(4), 1515–1521.
Renner, R. (2004). “Plumbing the depths of D.C.’s drinking water crisis.” Environ. Sci. Technol., 38(12), 224A–227A.
Schock, M. R., Hyland, R. N., and Welch, M. M. (2008). “Occurrence of contaminant accumulation in lead pipe scales from domestic drinking water distribution systems.” Environ. Sci. Technol., 42(12), 4285–4291.
Tam, Y. S., and Elefsiniotis, P. (2009). “Corrosion control in water supply systems: Effect of pH, alkalinity, and orthophosphate on lead and copper leaching from brass plumbing.” J. Environ. Sci. Health, Part A: Toxic/Hazardous Substances Environ. Eng., 44(12), 1251–1260.
Triantafyllidou, S., and Edwards, M. (2011). “Galvanic corrosion after simulated small-scale partial lead service line replacements.” J. Am. Water Works Assoc., 103(3), 85–99.
Triantafyllidou, S., Parks, J., and Edwards, M. (2007). “Lead particles in potable water.” J. Am. Water Works Assoc., 99(6), 107–117.
USEPA. (1999). “Method 300.1 – Determination of inorganic anions in drinking water by ion chromatography.” Revision 1.0, U.S. Environmental Protection Agency, Cincinnati, OH.
Vadasarukkai, Y. S., Gagnon, G. A., Campbell, D. R., and Clark, S. C. (2011). “Assessment of hydraulic flocculation process using computational fluid dynamics (CFD).” J. Am. Water Works Assoc., 103(11), 66–80.
Waller, D. H., Macphee, M. J., Prendiville, P. W., McCurdy, R. F., Gates, A. W., and D’Eon, W. J. (1996). “Characteristics of Nova Scotia surface waters and treatment options for removal of color and trihalomethane precursors.” Can. J. Civ. Eng., 23(6), 1316–1325.
Wang, Y., Jing, H., Mehta, V., Welter, G. J., and Giammar, D. E. (2012). “Impact of galvanic corrosion on lead release from aged lead service lines.” Water Res., 46(16), 5049–5060.
Zhang, Y., Griffin, A., Rahman, M., Camper, A., Baribeau, H., and Edwards, M. (2009). “Lead contamination of potable water due to nitrification.” Environ. Sci. Technol, 43(6), 1890–1895.
Information & Authors
Information
Published In
Copyright
© 2013 American Society of Civil Engineers.
History
Received: Sep 18, 2012
Accepted: Mar 11, 2013
Published online: Mar 13, 2013
Published in print: Aug 1, 2013
Discussion open until: Aug 13, 2013
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.