Influence of Process Parameters on the Characteristics of Struvite Pellets
Publication: Journal of Environmental Engineering
Volume 138, Issue 12
Abstract
With an ever-increasing demand for phosphate-based fertilizer, new sustainable sources of phosphorus are warranted. Recent technologies have successfully demonstrated the possibility of recovering phosphorus from wastewater-treatment plants as struvite, which is also a ready-made, slow-release fertilizer. However, process parameters that influence the operation of crystallizers and production of good-quality struvite pellets have yet to be fully understood. This paper discusses the influence of process parameters on the characteristics of struvite pellets. Among the various process parameters, upflow velocity and flow patterns in the crystallizer were found to influence the size and shape of the pellets. In the range (1.5–7.1) tested, supersaturation ratio did not appear to influence the crushing strength of the pellets formed. Midsized pellets, in the 2.0–2.5-mm range, exhibited the highest crushing strengths. Higher magnesium concentration in the crystallizer was able to increase the crushing strength of struvite pellets by as much as 15–27%.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
The authors would like to thank The University of British Columbia, Natural Science and Engineering Research Council of Canada (NSERC), Greater Vancouver Regional District (GVRD), and Stantec Consulting Ltd., Vancouver, B.C., Canada, for their financial support toward this research. The authors are also very grateful to the staff at Lulu Island Wastewater Treatment Plant for their support and help during the study.
References
Bhuiyan, M. I. H., Mavinic, D. S., and Beckie, R. D. (2007). “A solubility and thermodynamic study of struvite.” Environ. Technol., 28(9), 1015–1026.
Bhuiyan, M. I. H., Mavinic, D. S., and Beckie, R. D. (2008). “Nucleation and growth kinetics of struvite in a fluidized bed reactor.” J. Crystal Growth, 310, 1187–1194.
Britton, A., Koch, F. A., Mavinic, D. S., Adnan, A., Oldham, W. K., and Udala, B. (2005). “Pilot-scale struvite recovery from anaerobic digester supernatant at an enhanced biological phosphorus removal wastewater treatment plant.” J. Environ. Eng. Sci., 4(4), 265–277.
Demeestere, K., Smet, E., Van Langenhove, H., and Galbacs, Z. (2001). “Optimization of magnesium ammonium phosphate precipitation and its applicability to the removal of ammonium.” Environ. Technol., 22(12), 1419–1428.
Fattah, K. P. (2004). “Pilot scale struvite recovery potential from centrate at Lulu Island Wastewater Treatment Plant.” M.A.Sc. thesis, Dept. of Civil Engineering, Univ. of British Columbia, Vancouver, B.C., Canada.
Fattah, K. P., Mavinic, D. S., Koch, F. A., and Jacob, C. (2008). “Determining the feasibility of phosphorus recovery as struvite from filter press centrate in a secondary wastewater treatment plant.” J. Environ. Sci. Health Part A Toxic/Hazardous Substances Environ. Eng., 43(7), 756–764.
Forrest, A. (2004). “Process optimization of a technical scale phosphorus recovery system through struvite crystallization at the City of Penticton advanced wastewater treatment plant.” M.A.Sc. thesis, Dept. of Civil Engineering, Univ. of British Columbia, Vancouver, Canada.
Forrest, A. L., Fattah, K. P., Mavinic, D. S., and Koch, F. A. (2008). “Optimizing struvite production for phosphate recovery in WWTP.” J. Environ. Eng., 134(5), 395–402.
Gaterell, M. R., Gay, R., Wilson, R., Gochin, R. J., and Lester, J. N. (2000). “An economic and environmental evaluation of the opportunities for substituting phosphorus recovered from wastewater treatment works in existing UK fertilizer markets.” Environ. Technol., 21(9), 1067–1084.
Jeanmaire, N. (2001). “Recycling of removed phosphorus: Analysis of the potential interest in wastewater treatment plants.” Centre European d’Etudes des Polyphosphates (CEEP), 〈http://www.nhm.ac.uk/mineralogy/phos/Jeanmaire_report.doc〉.
Le Corre, K. S., Valsami-Jones, E., Hobbs, P., and Parsons, S. A. (2007). “Kinetics of struvite precipitation: Effect of the magnesium dose on induction times and precipitation rates.” Environ. Technol., 28(12), 1317–1324.
Mavinic, D. S., Koch, F. A., Huang, H., and Lo, K. V. (2007). “Phosphorus recovery from anaerobic digester supernatants using a pilot-scale struvite crystallization process.” J. Environ. Eng. Sci., 6(5), 561–571.
Ohlinger, K. N., Young, T. M., and Schroeder, E. D. (1999). “Kinetics effects on preferential struvite accumulation in wastewater.” J. Environ. Eng., 125(8), 730–737.
Omar, W., and Ulrich, J. (2003). “Influence of crystallization conditions on the mechanism and rate of crystal growth of potassium sulphate.” Crystal Research and Technology, 38(1), 34–41.
Owen, J., Stoven, H., Kowalski, J., and Phillips, K. (2009). “Assessment of struvite containing controlled release fertilizer as a source of phosphorus for containerized ornamental crops.” Hortiscience, 44(4), 1131–1132.
Rahaman, M. S., Ellis, N., and Mavinic, D. S. (2008). “Effects of various process parameters on struvite precipitation kinetics and subsequent determination of rate constants.” Water Sci. Technol., 57(5), 647–654.
Ribeiro, D. V., and Morelli, M. R. (2009). “Performance analysis of magnesium phosphate cement mortar containing grinding dust.” Mater. Res., 12(1), 51–56.
Shane, M. J., Talbot, J. B., Sluzky, E., and Hesse, K. R. (1995). “Zeta potential of phosphorus.” Colloids Surfaces A: Physicochem. Eng. Aspects, 96, 301–305.
Shimamura, K., Tanaka, T., Miura, Y., and Ishikawa, H. (2003). “Development of a high-efficiency phosphorus recovery method using a fluidized-bed crystallized phosphorus removal system.” Water Sci. Technol., 48(1), 163–170.
Stratful, I., Scrimshaw, M. D., and Lester, J. N. (2001). “Conditions influencing the precipitation of magnesium ammonium phosphate.” Water Res., 35(17), 4191–4199.
Sterling, M. S., and Ashley, K. I. (2003). “Evaluations of a slow-release fertilizer for rehabilitating oligotrophic streams.” Am. Fisheries Soc. Symp., 34, 237–243.
Thomas, M., and van der Poel, A. F. B. (1996). “Physical quality of pelleted animal feed: 1. Criteria for pellet quality.” Anim. Feed Sci. Technol., 61(1–4), 89–112.
Ueno, Y., and Fujii, M. (2001). “Three years experience of operating and selling recovered struvite from full-scale plant.” Environ. Technol., 22(11), 1373–1381.
Walker, G. M., Magee, T. R. A., Holl, C. R., Ahmad, M. N., Fox, N., and Moffatt, N. A. (1997). “Compression testing of granular NPK fertilizers.” Nutrient Cycling Agroecosys., 48, 231–234.
Information & Authors
Information
Published In
Copyright
© 2012 American Society of Civil Engineers.
History
Received: Sep 29, 2011
Accepted: Mar 31, 2012
Published online: Apr 10, 2012
Published in print: Dec 1, 2012
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.