Role of Solids in Heavy Metals Buildup on Urban Road Surfaces
Publication: Journal of Environmental Engineering
Volume 138, Issue 4
Abstract
Solids are widely identified as a carrier of harmful pollutants in stormwater runoff exerting a significant risk to receiving waters. This paper outlines the findings of an in-depth investigation on heavy metal adsorption to solids surfaces. Pollutant build-up samples collected from 16 road sites in residential, industrial, and commercial land uses were separated into four particle size ranges and analyzed for a range of physicochemical parameters and nine heavy metals including Iron (Fe), Aluminum (Al), Lead (Pb), Zinc (Zn), Cadmium (Cd), Chromium (Cr), Manganese (Mn), Nickel (Ni), and Copper (Cu). High specific surface area (SSA) and total organic carbon (TOC) content in finer particle size ranges were noted, thus confirming strong correlations with heavy metals. On the basis of their physicochemical characteristics, two different types of solids originating from traffic and soil sources were identified. Solids generated by traffic were associated with high loads of heavy metals, such as Cd and Cr, with strong correlation with SSA. This suggested the existence of surface dependent bonds, such as cation exchange between heavy metals and solids. In contrast, Fe, Al, and Mn, which can be attributed to soil inputs, showed strong correlation with TOC suggesting strong bonds such as chemsorption. Zn was found to be primarily attached to solids by bonding with the oxides of Fe, Al, and Mn. The data analysis also confirmed the predominance of the finer fraction, with 70% of the solids being finer than 150 µm and containing 60% of the heavy metal pollutant load.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
This research was supported by the Faculty of Built Environment and Engineering, Queensland University of Technology, Australia. The authors would like to acknowledge Gold Coast City Council for facilitating data collection in the Gold Coast. The support provided by the QUT technical staff is gratefully acknowledged.
References
Adachi, K., and Tainosho, Y. (2004). “Characterization of heavy metal particles embedded in tire dust.” Environ. Int.ENVIDV, 30(8), 1009–1017.
Adams, M. J. (1995). Chemometrics in analytical spectroscopy, Royal Society of Chemistry, Cambridge, England.
American Public Health Association (APHA), American Water Works Association (AWWA), and Water Environment Federation (WEF). (1999). Standard methods for the examination of water and wastewater, Washington, DC.
Ball, J. E., Jenks, R., and Aubourg, D. (1998). “An assessment of the availability of pollutant constituents on road surfaces.” Sci. Total Environ.STENDL, 209(2-3), 243–254.
Blok, J. (2005). “Environmental exposure of road borders to zinc.” Sci. Total Environ.STENDL, 348(1–3), 173–190.
Carter, D. L., Mortland, M. M., and Kemper, W. D. (1986). “Specific surface, methods of soil analysis, Part 1. Physical and mineralogical methods.” Chapter 16, Agronomy, No. 9, 2nd Ed., American Society of Agronomy, Madison, WI, 413–423.
Charlesworth, S., and Lees, J. A. (1999). “The distribution of heavy metals in deposited urban dusts and sediments, Coventry, England.” Environ. Geochem. HealthEGHEE3, 21(2), 97–115.
de Bartolomeo, A., Poletti, L., Sanchini, G., Sebastiani, B., and Morozzi, G. (2004). “Relationship among parameters of lake polluted sediments evaluated by multivariate statistical analysis.” ChemosphereCMSHAF, 55(10), 1323–1329.
Egodawatta, P., and Goonetilleke, A. (2006). “Characteristics of pollutants built-up on residential road surfaces.” Proc., 7th Int. Conf. on Hydro Science and Engineering, Michael Piasecki and College of Engineering, Drexel Univ., Philadelphia.
Egodawatta, P., Thomas, E., and Goonetilleke, A. (2007). “Mathematical interpretation of pollutant wash-off from urban road surfaces using simulated rainfall.” Water Res.WATRAG, 41(13), 3025–3031.
Eisma, D. (1981). “Suspended matter as a carrier for pollutants in estuaries and sea.” Marine Environmental Pollution, 2. Mining and Dumping, Geyer, R. A., ed., Elsevier, Amsterdam, Netherlands, 281–295.
Ellis, J. B. (1976). “Sediments and water quality of urban stormwater.” Water Serv.WTSVAK, 80(970), 730–734.
Federal Highway Administration (FHWA). (2005). “Surface texture for asphalt and concrete pavements.” Technical Advisory T5040.36, Washington, DC.
Flanagan, D. C., and Foster, G. R. (1989). “Storm pattern effect on nitrogen and phosphorus losses in surface runoff.” Trans. ASABE, 32(2), 535–544.
Goonetilleke, A., Egodawatta, P., and Kitchen, B. (2009). “Evaluation of pollutant build-up and wash-off from selected land uses at the Port of Brisbane, Australia.” Mar. Pollut. Bull.MPNBAZ, 58(2), 213–221.
Goonetilleke, A., Thomas, E., Ginn, S., and Gilbert, D. (2005). “Understanding the role of land use in urban stormwater quality management.” J. Environ. Manage.JEVMAW, 74(1), 31–42.
Gunawardana, C. (2011). “Influence of physical and chemical properties of solids on heavy metal adsorptions.” Ph.D. thesis, Queensland University of Technology, Brisbane, Australia.
Hendershot, W. H., and Lavkulich, L. M. (1983). “Effect of sesquioxide coatings on surface charge of standard mineral and soil samples.” Soil Sci. Soc. Am. J.SSSJD4, 47(6), 1252–1260.
Herngren, L., Goonetilleke, A., and Ayoko, G. A. (2005). “Understanding heavy metal and suspended solids relationships in urban stormwater using simulated rainfall.” J. Environ. Manage.JEVMAW, 76(2), 149–158.
Herngren, L., Goonetilleke, A., and Ayoko, G. A. (2006). “Analysis of heavy metals in road-deposited sediments.” Anal. Chim. ActaACACAM, 571(2), 270–278.
Hoffman, E. J., Latimer, J. S., Hunt, C. D., Mills, G. L., and Quinn, J. G. (1985). “Stormwater runoff from highways.” Water, Air, Soil Pollut.WAPLAC, 25(4), 349–364.
Kim, L., Zoh, K., Jeong, S., Kayhanian, M., and Stenstrom, M. K. (2006). “Estimating pollutant mass accumulation on highways during dry periods.” J. Environ. Eng.JOEEDU, 132(9), 985–993.
Kokot, S., Grigg, M., Panayiotou, H., and Phuong, T. D. (1998). “Data interpretation by some common chemometrics methods.” ElectroanalysisELANEU, 10(16), 1081–1088.
Li, Y., et al. (2008). “Characteristics of particles on urban impervious surfaces: Heavy metals, TOC and specific surface area.” Proc., 12th Int. Conf. on Integrated Diffuse Pollution Management (IWA DIPCON 2008), Khon Kaen Univ., Thailand.
Mahbub, S. M. P., Goonetilleke, A., and Egodawatta, P. (2009). “Experimental methodology for determining heavy metals and total petroleum hydrocarbons in pollutant build-up and wash-off due to urban traffic and climate change.” Proc., 2nd Infrastructure Theme Postgraduate Conf., Queensland Univ., Brisbane, Australia, 355–363.
Munksgaard, N. C., and Parry, D. L. (2001). “Trace metals, arsenic and lead isotopes in dissolved and particulate phases of North Australian coastal and estuarine seawater.” Mar. Chem.MRCHBD, 75(3), 165–184.
Petersen, W., Bertino, L., Callies, U., and Zorita, E. (2001). “Process identification by principal component analysis of river water-quality data.” Ecol. Model.ECMODT, 138(1–3), 193–213.
Roger, S., Montrejaud-Vignoles, M., Andral, M. C., Herremans, L., and Fortune, J. P. (1998). “Mineral, physical and chemical analysis of the solid matter carried by motorway runoff water.” Water Res.WATRAG, 32(4), 1119–1125.
Sansalone, J. J., Buchberger, S. G., Koran, J. M., and Smithson, J. A. (1997). “Relationship between particle size distribution and specific surface area of urban roadway stormwater solids.” Transportation Research Record 1601, Transportation Research Board, Washington, DC, 95–108.
Sartor, J. D., Boyd, B. G., and Agardy, F. J. (1974). “Water pollution aspects of street surface contaminants.” Rep. No. EPA-R2-72/081, U.S. EPA, Washington, DC.
Shi, G., et al. (2008). “Potentially toxic metal contamination of urban soils and roadside dust in Shanghai, China.” Environ. Pollut.ENPOEK, 156(2), 251–260.
Standards Australia. (1998). Water quality-sampling—guidance on the design of sampling programs, sampling techniques and the preservation and handling of samples, AS/NZS 5667.1:1998, Sydney, Australia.
USEPA. (1994). Method 200.8: Trace elements in waters and wastes by inductively coupled plasma-mass spectrometry, Cincinnati.
Vdovic, N., Biscan, J., and Juracic, M. (1991). “Relationship between specific surface area and some chemical and physical properties of particulates: Study in the northern Adriatic.” Mar. Chem.MRCHBD, 36(1–4), 317–328.
Wang, X., and Li, Y., and Dong, D. (2008). “Sorption of pentachlorophenol on surficial sediments: The roles of metal oxides and organic materials with co-existed copper present.” ChemosphereCMSHAF, 73(1), 1–6.
Wen, L., Warnken, K. W., and Santschi, P. H. (2008). “The role of organic carbon, iron, and aluminium oxyhydroxides as trace metal carriers: Comparison between the Trinity River and the Trinity River Estuary.” Mar. Chem.MRCHBD, 112(1–2), 20–37.
Zhang, M., and Wang, H. (2009). “Concentrations and chemical forms of potentially toxic metals in road-deposited sediments from different zones of Hangzhou, China.” J. Environ. Sci. (Beijing, China)JENSEE, 21(5), 625–631.
Information & Authors
Information
Published In
Copyright
© 2012. American Society of Civil Engineers.
History
Received: Oct 29, 2010
Accepted: Sep 7, 2011
Published online: Sep 9, 2011
Published in print: Apr 1, 2012
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.