Abstract
In 2004, during ordinary maintenance work, consisting of waterproofing a building located in the south of Italy, the long-span (14.5 m) in situ RC roof partially collapsed. The building, constructed in 1950, was in service as a cinema until 1967 and then utilized as a school until 1985. Lastly, it was a hotel until 2000. In 2004, when the building was not in service and was undergoing maintenance work, it partially collapsed under dead load. After the collapse, which involved a large portion of the roof, several beams, and two columns, the Italian court nominated an official technical consultant to investigate the direct and related causes of the failure. After the main causes were identified, the building was repaired and the roof was reconstructed with a light steel structure. This article is focused on the behavior of the collapsed structure considering the original design choices, the construction details adopted, and the material properties, including the effect of concrete and steel degradation. The influences of these aspects on the collapse are examined, with particular emphasis on concrete carbonation, steel bar corrosion, and design mistakes. The lessons learned from the case study could help professional engineers to be aware of the main peculiarities and structural deficiencies of structural systems affected by material degradation and the importance of in situ periodic checks and monitoring during the life of the structures.
Get full access to this article
View all available purchase options and get full access to this article.
References
Adam, J. M., and M. Buitrago. 2018. “Learning from failures in an emblematic building in Valencia, Spain.” Eng. Fail. Anal. 92 (Oct): 418–429. https://doi.org/10.1016/j.engfailanal.2018.06.023.
Betti, M., and A. Vignoli. 2011. “Numerical assessment of the static and seismic behaviour of the basilica of Santa Maria all’Impruneta (Italy).” Constr. Build. Mater. 25 (12): 4308–4324. https://doi.org/10.1016/j.conbuildmat.2010.12.028.
Biegus, A., and D. Madry. 2009. “Failure hazard and strengthening of roof in steel industrial building after explosion of electric furnace.” Eng. Fail. Anal. 16 (7): 2427–2432. https://doi.org/10.1016/j.engfailanal.2009.03.030.
Brencich, A. 2010. “Collapse of an industrial steel shed: A case study for basic errors in computational structural engineering and control procedures.” Eng. Fail. Anal. 17 (1): 213–225. https://doi.org/10.1016/j.engfailanal.2009.06.015.
Coronelli, D., and P. Gambarova. 2004. “Structural assessment of corroded reinforced concrete beams: Modeling guidelines.” J. Struct. Eng. 130 (8): 1214–1224. https://doi.org/10.1061/(ASCE)0733-9445(2004)130:8(1214).
del Coz Díaz, J. J., F. P. Álvarez Rabanal, P. J. García Nieto, J. Roces-García, and A. Alonso-Estébanez. 2012. “Nonlinear buckling and failure analysis of a self-weighted metallic roof with and without skylights by FEM.” Eng. Fail. Anal. 26 (Dec): 65–80. https://doi.org/10.1016/j.engfailanal.2012.07.019.
del Coz Díaz, J. J., P. J. García Nieto, A. Lozano Martínez-Luengas, and J. L. Suárez Sierra. 2010. “A study of the collapse of a WWII communications antenna using numerical simulations based on design of experiments by FEM.” Eng. Struct. 32 (7): 1792–1800. https://doi.org/10.1016/j.engstruct.2009.09.011.
Imperatore, S. 2016. “Influence of the bond-slip relationship on the flexural capacity of R.C. joints damaged by corrosion.” In Vol. 1738 of Proc., AIP Conf. Proc., 270021. Amsterdam, Netherlands: Elsevier.
Krentowski, J. 2014. “Steel roofing disaster and the effect of the failure of butt joints.” Eng. Fail. Anal. 45 (Oct): 245–251. https://doi.org/10.1016/j.engfailanal.2014.07.008.
Murta, A., J. Pinto, H. Varum, J. Guedes, J. Lousada, and P. Tavares. 2010. “Survey on the main defects in ancient buildings constructed mainly with natural raw materials.” In Proc., Portugal SB10, Sustainable Building, Affordable to All, Low Cost Sustainable Solutions. Amsterdam, Netherlands: Elsevier.
Pieraccini, L., M. Palermo, T. Trombetti, and F. Baroni. 2017. “The role of ductility in the collapse of a long-span steel roof in North Italy.” Eng. Fail. Anal. 82 (Dec): 243–265. https://doi.org/10.1016/j.engfailanal.2017.07.012.
Pinto, J., H. Varum, and L. Ramos. 2011. “Two roofs of recent public buildings, the same technological failure.” Eng. Fail. Anal. 18 (2): 811–817. https://doi.org/10.1016/j.engfailanal.2011.01.001.
Piskoty, G., L. Wullschleger, R. Loser, A. Herwig, M. Tuchschmid, and G. Terrasi. 2013. “Failure analysis of a collapsed flat gymnasium roof.” Eng. Fail. Anal. 35 (Dec): 104–113. https://doi.org/10.1016/j.engfailanal.2012.12.006.
Zhang, X., L. Wang, J. Zhang, and Y. Liu. 2016. “Model for flexural strength calculation of corroded RC beams considering bond–slip behavior.” J. Eng. Mech. 142 (7): 04016038. https://doi.org/10.1061/(ASCE)EM.1943-7889.0001079.
Information & Authors
Information
Published In
Journal of Performance of Constructed Facilities
Volume 34 • Issue 2 • April 2020
Copyright
©2020 American Society of Civil Engineers.
History
Received: Apr 30, 2019
Accepted: Aug 28, 2019
Published online: Jan 3, 2020
Published in print: Apr 1, 2020
Discussion open until: Jun 3, 2020
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.