Forensic Investigation of Causes of Premature Longitudinal Cracking in a Newly Constructed Highway with a Composite Pavement System
This article has a reply.
VIEW THE REPLYThis article has a reply.
VIEW THE REPLYPublication: Journal of Performance of Constructed Facilities
Volume 31, Issue 2
Abstract
Forensic investigations were conducted to identify the causes of longitudinal cracking (LC) of a newly constructed highway. The case-study highway was built with a composite pavement system and is located in a semiarid region north of the equator in Africa. During these investigations, several tests were performed, such as a visual survey of cracks, nondestructive tests, and coring. Long-term observations of soil movements and crack growth were executed. The results showed that the main reasons for surface cracking were (1) use of clayey soils as filling material, and (2) the region’s climate. Such conditions led to a cycle of nonuniform swelling-shrinkage of embankment soil, which resulted in failure of the treated base and the beginning of a well-defined cracking mechanism. The results of this investigation will allow suggestions to be proposed for immediate improvement of the zone against most defects and to implement remedial solutions for other parts.
Get full access to this article
View all available purchase options and get full access to this article.
References
Adaska, W. S., and Luhr, D. R. (2004). “Control of reflective cracking in cement stabilized pavements.” Proc., 5th Int. RILEM Conf. on Cracking in Pavements, RILEM Publications S.A.R.L., France, 309–316.
Ardani, A., Hussain, S., and LaForce, R. (2003). “Evaluation of premature PCC pavement longitudinal cracking in Colorado.” Proc., 2003 Mid-Continent Transportation Research Symp., Iowa State Univ., Ames, IA.
ASTM. (2003). “Standard practice for computing international roughness index of roads from longitudinal profile measurements.” ASTM E1926, West Conshohocken, PA.
ASTM. (2009). “Standard test method for deflections with a falling-weight-type impulse load device.” ASTM D469, West Conshohocken, PA.
Baek, J., and Al-Qadi, I. (2006). “Finite element method modeling of reflective cracking initiation and propagation: Investigation of the effect of steel reinforcement interlayer on retarding reflective cracking in hot-mix asphalt overlay.” Transp. Res. Rec., 1949, 32–42.
Chen, D. H. (2007). “Field and lab investigations of prematurely cracking pavements.” J. Perform. Constr. Facil., 293–301.
Chen, D. H., Hong, F., and Zhou, F. (2010). “Premature cracking from cement-treated base and treatment to mitigate its effect.” J. Perform. Constr. Facil., 113–120.
Chen, D. H., and Scullion, T. (2008). “Forensic investigations of roadway pavement failures.” J. Perform. Constr. Facil., 35–44.
Chen, D. H., Scullion, T., Hong, F., and Lee, J. (2011). “Pavement swelling and heaving at State Highway 6.” J. Perform. Constr. Facil, 335–344.
Cook, W. D., and Zhu, J. (2009). “Piecewise linear output measures in DEA (third revision).” Eur. J. Oper. Res., 197(1), 312–319.
Cross, S., and Brown, E. (1993). “Effect of segregation on performance of hot-mix asphalt.” Transp. Res. Rec., 1417, 117–126.
Dessouky, S. H., Oh, J., Ilias, M., Lee, S. I., and Park, D. (2014). “Investigation of various pavement repairs in low-volume roads over expansive soil.” J. Perform. Constr. Facil., .
European-French Standard. (2004). “Hydraulically bound mixtures, specifications. Part 1: Cement bound granular mixtures.”, Association Française de Normalisation, France.
European-French Standard. (2006). “Bituminous mixtures, test methods for hot mix asphalt. Part 1: Soluble binder content.”, Association Française de Normalisation, France.
Flintsch, G. W., Diefenderfer, B. K., and Nunez, O. (2008). “Composite pavement systems: Synthesis of design and construction practices.”, Virginia Tech Transportation Institute, Blacksburg, VA.
Freitas, E., Pereira, P., and Picado-Santos, L. (2003). “Assessment of top-down cracking causes in asphalt pavements.” Proc., 3rd Int. Symp. on Maintenance and Rehabilitation of Pavements and Technological Control, Universidade do Minho, Portgual, 555–564.
French Standard. (1994). “Pavement-earthworks-road pavement structural design. Road traffic evaluation for pavement structural design.”, Association Française de Normalisation, France (in French).
Harmelink, D., Shuler, S., and Aschenbrener, T. (2008). “Top-down cracking in asphalt pavements: Causes, effects, and cures.” J. Transport Eng., 1–6.
Loria, L., Sebaaly, P., and Hajj, E. (2008). “Long-term performance of reflective cracking mitigation techniques in Nevada.” Transp. Res. Rec., 2044, 86–95.
Matsuno, S., and Nishizawa, T. (1992). “Mechanism of longitudinal surface cracking in asphalt pavement.” Proc., 7th Int. Conf. on Asphalt Pavements, Vol. 2, ARRB Group Limited, Vermont South, VIC, Australia, 277–291.
Miller, J. S., and Bellinger, W. Y. (2014). “Distress identification manual for the long-term pavement performance program.”, Federal Highway Administration, Office of Infrastructure Research and Development, McLean, VA.
Moses, T. L., Hulsey, J. L., and Connor, B. (2009). “Airport managers guide for the mainteanance of asphalt pavements of general aviation air ports.”, Alaska Univ. Transportation Center, Fairbanks, AK.
Myers, L. A., Roque, R., and Birgisson, B. (2001). “Propagation mechanisms for surface-initiated longitudinal wheelpath cracks.” Transp. Res. Rec., 1778, 113–122.
Myers, L. A., Roque, R., Ruth, B. E., and Drakos, C. (1999). “Measurement of contact stresses for different truck tire types to evaluate their influence on near-surface cracking and rutting.” Transp. Res. Rec., 1655, 175–184.
Nesnas, K., and Nunn, M. E. (2006). “Thermal pavement response model for top-down reflection cracking in composite pavements.” Proc., 85th Annual Meeting of the Transportation Research Board, Transportation Research Board, Washington, DC.
Nunn, M. E. (1989). “An investigation of reflective cracking in composite pavements in the United Kingdom.” Proc., RILEM Conf. on Reflective Cracking in Pavements, Assessment and Control, International Union of Laboratories and Experts in Construction Materials, Systems and Structures, Bagneux, France, 146–153.
Nunn, M. E. (2004). “Development of a more versatile approach to flexible and flexible composite pavement design.”, TRL Limited, Crowthorne, U.K.
Phanikumar, B. R. (2006). “Prediction of swelling characteristics with free swell index.” Expansive soils: Recent advances in characterization and treatment, Taylor & Francis Group, London, 173–184.
Rao, S. P. (2013). “Composite pavement systems: HMA/PCC composite pavements.”, Transportation Research Board, Washington, DC.
Roesler, J. R., Popovics, J. S., Ranchero, J. L., Mueller, M., and Lippert, D. (2005). “Longitudinal cracking distress on continuously reinforced concrete pavements in Illinois.” J. Perform. Constr. Facil., 331–338.
Sebesta, S. (2002). “Investigation of maintenance base repairs over expansive soils: Year 1.”, Texas Transportation Institute, Texas A&M Univ. System, Arlington, TX.
Uzarowski, L., Moore, G., Halloran, M., and Henderson, V. (2009). “Construction of durable longitudinal joints—The courage to use innovations pays off.” 2009 Annual Conf. and Exhibition of the Transportation Association of Canada Transportation in a Climate of Change, Transportation Association of Canada, Ottawa.
Wanyan, Y., Abdallah, I., Nazarian, S., and Puppala, A. J. (2015). “Moisture content-based longitudinal cracking prediction and evaluation model for low-volume roads over expansive soils.” J. Mater. Civ. Eng., .
Yao, J. L., and Weng, Q. H. (2011). “Causes of longitudinal cracks on newly rehabilitated jointed concrete pavements.” J. Perform. Constr. Facil., 84–94.
Information & Authors
Information
Published In
Journal of Performance of Constructed Facilities
Volume 31 • Issue 2 • April 2017
Copyright
©2016 American Society of Civil Engineers.
History
Received: Mar 10, 2016
Accepted: Aug 15, 2016
Published online: Sep 28, 2016
Discussion open until: Feb 28, 2017
Published in print: Apr 1, 2017
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.